Page 4 of 4
RB31188 Iss-2 13APR17 ©Hills Limited 2017 www.hills.com.a /antenna 1300 445 571
4. Hills Antenna & TV Systems ndertakes that if d ring the Warranty Period, the
Eq ipment, or any part of the Eq ipment, has failed to operate correctly d e to
fa lty Workmanship or defective Material, it will repair or replace the Eq ipment or
part (as the case may be) free of charge on the following terms:
(a) The cons mer m st retain proof of p rchase of the Eq ipment. Hills Antenna
& TV Systems may reject a warranty claim on Eq ipment where the
cons mer is nable to s bstantiate proof of p rchase to the reasonable
satisfaction of Hills Antenna & TV Systems.
(b) The cons mer m st contact the relevant Hills Antenna & TV Systems Branch
Office (details listed below) or telephone 1800 720 000 pon becoming aware
of a defect to any Eq ipment.
(c) Following cons ltation with Hills Antenna & TV Systems, we will determine
whether there is a defect, and if so we agree (at o r option) to repair,
replace or s pply eq ivalent goods, or pay the cost of any of those remedies
to the cons mer.
(d) The cons mer will be responsible for the collection and freight costs of
ret rning the Eq ipment to Hills Antenna & TV Systems or to any designated
Hills Antenna & TV Systems Branch Office for repair or replacement (as
determined by s).
(e) Hills Antenna & TV Systems will be responsible for the freight costs to deliver
any new or repaired Eq ipment to the cons mer.
(f) Please note that a service charge will apply if no fa lt is identified or if any
fa lt does not fall within the conditions of this warranty. For details of the
applicable service charge, please contact Hills Antenna & TV Systems prior to
making a claim nder this warranty.
5. The cons mer’s right to this warranty will cease to apply where:
(a) The Eq ipment has not been sed in accordance with the instr ctions
provided in the installation instr ctions s pplied with the Eq ipment, or in
accordance with s al se for that type of eq ipment;
(b) Alterations, modifications or repairs have been carried o t on the Eq ipment
6. This warranty is in addition to any non-excl dable legal rights or remedies conferred
on the cons mer nder any applicable Act and any similar laws. To the extent
permitted by law, Hills Antenna & TV Systems’ liability for any non-excl dable
condition or warranty is limited to rectifying any defect at its option, as set o t in
paragraph 4(c).
7. S bject to the req irements of any applicable Act or legislation and to the extent
permitted by law, no liability (whether expressed or implied) of any nat re
whatsoever, is accepted by Hills Antenna & TV Systems for any conseq ential loss,
damage or inj ry arising as a res lt of any fa lt in the Eq ipment.
8. This warranty does not extend to damage to Eq ipment which occ rs d ring transit
or transportation, or which is ca sed by any ab se, accident or improper
installation, connection, se, adj stment or repair of goods otherwise than in
accordance with instr ctions iss ed by Hills Antenna & TV Systems.
9. The following applies to cons mers who p rchased the Eq ipment in A stralia:
Our goods come with guarantees that cannot be excluded under the Australian
Consumer Law. You are entitled to a replacement or refund for a major failure and
compensation for any other reasonably foreseeable loss or damage. You are also
entitled to have the goods repaired or replaced if the goods fail to be of acceptable
quality and the failure does not amount to a major failure.
Page 1 of 4
RB31188 Iss-2 13APR17 ©Hills Limited 2017 www.hills.com.a /antenna 1300 445 571
TRU-MAX 4G Antenna Range
INSTALLATION INSTRUCTIONS
•FB608601-4G Tru-Max 36
•FB608601-4G-BLACK Tru-Max 36
•FB608602-4G Tru-Max 18
1. BOOT PREPARATION
The boot has been desi ned to suit various
sizes of cables. For RG59 cable no trimmin is
necessary, but for other cables trimmin is
required to allow the boot to fit over the
cable. Refer to Fi ure 1 for details. When
trimmin the boot, ensure there is a neat fit
around the cable to minimise water in ress.
2. COAX CABLE RUN
Slide the rubber boot provided over the
coaxial cable and then fit an F-type connector
to the cable. Refer Fi ure 2.
NOTE: The F-type connector is not included
and should be fitted accordin to the
manufacturer's instructions.
3. COAX CABLE CONNECTION
Screw the F-type connector onto the balun,
ensurin it is not over-ti htened. The
recommended torque is 3 N-m. Slide the boot
over the connector onto the balun housin ,
ensurin that it completely covers the
connector and is seated into the housin to
prevent water in ress. See Fi ure 3.
Figu e 1
Figu e 3
RG59
