Hisense HHO60TAMI Montageanleitung
MODEL NO.:HHO60TAMI
ES - CAMPANA EXTRACTORA 12
FR - HOTTE 17
PT - EXAUSTOR 22
EN - COOKER HOOD 7
1
3
600
558
272
290
min.306- max. 476
130
16
40
150
2
4
173
5
16 cm
10 cm
6
170
180
204
204
173
11a
16 cm
>1 cm
78
139
98
28
10a
9a
12a
13a 14a
4 szt.
16a
9b
173
∅180
∅5
4x
10b
131
290
17
160
600
4x∅5
204
173
220
498
30
min 10 - max 50
15a
4x
ST4,2x16
42
12b
13b
M4x35
4x
17
1
18
4
19
11b
min 10 - max 50
EN - COOKER HOOD
EN - COOKER HOOD
CAUTION
Closely follow the instructions set out in this manual. All responsibility, for any eventual inconveniences, damages or
fires caused by not complying with the instructions in this manual, is declined. The hood is conceived for the suction of
cooking fumes and steam and is destined only for domestic use.
The hood can look different to that illustrated in the drawings in this booklet. The instructions for use, maintenance
and installation, however, remain the same.
! It is important to conserve this booklet for consultation at any moment. In the case of sale, cession or move, make sure
it is together with the product.
! Read the instructions carefully: there is important information about installation, use and safety.
! Do not carry out electrical or mechanical variations on the product or on the discharge conduits.
! Before proceeding with the installation of the appliance verify that there are no damaged all components. Otherwise
contact your dealer and do not proceed with the installation.
Note: the elements marked with the symbol “(*)” are optional accessories supplied only with some models or elements to
purchase, not supplied.
WARNING! Do not connect the appliance to the mains until the installation is fully complete.
Before any cleaning or maintenance operation, disconnect hood from the mains by removing the plug or disconnecting the
mains electrical supply.
Always wear work gloves for all installation and maintenance operations.
The appliance is not intended for use by children or persons with impaired physical, sensorial or mental faculties, or if lacking
in experience or knowledge, unless they are under supervision or have been trained in the use of the appliance by a person
responsible for their safety.
This appliance is designed to be operated by adults, children should be monitored to ensure that they do not play with the
appliance.
This appliance is designed to be operated by adults. Children should not be allowed to tamper with the controls or play with
the appliance.
Never use the hood without effectively mounted grating!
The hood must NEVER be used as a support surface unless specifically indicated.
The premises where the appliance is installed must be sufficiently ventilated, when the kitchen hood is used together with
other gas combustion devices or other fuels.
The ducting system for this appliance must not be connected to any existing ventilation system which is being used for any
other purpose such as discharging exhaust fumes from appliances burning gas or other fuels.
The flaming of foods beneath the hood itself is severely prohibited.
The use of exposed flames is detrimental to the filters and may cause a fire risk, and must therefore be avoided in all
circumstances.
Any frying must be done with care in order to make sure that the oil does not overheat and ignite. Accessible parts of the
hood may became hot when used with cooking appliance.
With regards to the technical and safety measures to be adopted for fume discharging it is important to closely follow the
regulations provided by the local authorities.
The hood must be regularly cleaned on both the inside and outside (AT LEAST ONCE A MONTH).
This must be completed in accordance with the maintenance instructions provided in this manual). Failure to follow the
instructions provided in this user guide regarding the cleaning of the hood and filters will lead to the risk of fires.
Do not use or leave the hood without the lamp correctly mounted due to the possible risk of electric shocks.
We will not accept any responsibility for any faults, damage or fires caused to the appliance as a result of the non-
observance of the instructions included in this manual.
7
Appliance designed, tested and manufactured according to:
•Safety: EN/IEC 60335-1; EN/IEC 60335-2-31, EN/IEC 62233.
•Performance: EN/IEC 61591; ISO 5167-1; ISO 5167-3; ISO 5168; EN/IEC 60704-1; EN/IEC 60704-2-13; ISO 3741;
EN 50564; IEC 62301.
•EMC: EN 55014-1; CISPR 14-1; EN 55014-2; CISPR 14-2; EN/IEC 61000-3-2; EN/IEC 61000-3-3.
USE
The hood is designed to be used either for exhausting or filter version.
This appliance is marked according to the European directive 2012/19/EC on Waste Electrical and Electronic Equipment
(WEEE). By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the
environment and human health, which could otherwise be caused by inappropriate waste handling of this product.
The symbol on the product, or on the documents accompanying the product, indicates that this appliance may not
be treated as household waste. Instead it should be taken to the appropriate collection point for the recycling of electrical and
electronic equipment. Disposal must be carried out in accordance with local environmental regulations for waste disposal.
For further detailed information regarding the process, collection and recycling of this product, please contact the appropriate
department of your local authorities or the local department for household waste or the shop where you purchased this
product.
Suggestions for a correct use in order to reduce the environmental impact: Switch ON the hood at minimum speed when you
start cooking and kept it running for few minutes after cooking is finished. Increase the speed only in case of large amount of
smoke and vapour and use boost speed(s) only in extreme situations. Replace the charcoal filter(s) when necessary to
maintain a good odour reduction efficiency. Clean the grease filter(s) when necessary to maintain a good grease filter
efficiency. Use the maximum diameter of the ducting system indicated in this manual to optimize efficiency and minimize
noise.
Additional Installation Specifications:
Use only the fixing screws supplied with the product for installation or, if not supplied, purchase the correct screws type. Use
the correct length for the screws which are identified in the Installation Guide.
In case of doubt, consult an authorised service assistance centre or similar qualified person.
WARNING! Failure to install the screws or fixing device in accordance with these instructions may result in electrical hazards.
In this case the fumes are conveyed outside of the building by means of a special pipe connected with the connection ring
located on top of the hood.
Attention! The exhausting pipe is not supplied and must be purchased apart. Diameter of the exhausting pipe must be equal
to that of the connection ring.
In the horizontal runs the exhausting pipe must be slightly slanted (about 10°) and directed upwards to vent the air easily
from the room to the outside.
Attention! If the hood is supplied with active charcoal filter, then it must be removed.
Connect the hood and discharge holes on the walls with a diameter equivalent to the air outlet (connection flange).
Using the tubes and discharge holes on walls with smaller dimensions will cause a diminution of the suction performance
and a drastic increase in noise.
Any responsibility in the matter is therefore declined.
8
DUCTING VERSION
One active charcoal filter is needed for this and can be obtained from your usual retailer.
The filter removes the grease and smells from the extracted air before sending it back into the room through the upper outlet
grid.
INSTALLATION
ELECTRICAL CONNECTION
MOUNTING
Very heavy product; hood handling and installation must be carried out by at least two persons. Before beginning installation:
•
•
•
•
•
•
Use a duct of the minimum indispensible length.
Use a duct with as few elbows as possible (maximum elbow angle: 90°).
Avoid drastic changes in the duct cross-section.
Use a duct as smooth as possible inside.
The duct must be made of certified material.
!
!
!
!
!
FILTER VERSION
The minimum distance between the supporting surface for the cooking equipment on the hob and the lowest part of the
range hood must be not less than 50cm from electric cookers and 65cm from gas or mixed cookers.
If the instructions for installation for the gas hob specify a greater distance, this must be adhered to.
The mains power supply must correspond to the rating indicated on the plate situated inside the hood. If provided with a plug
connect the hood to a socket in compliance with current regulations and positioned in an accessible area, after installation. If
it not fitted with a plug (direct mains connection) or if the plug is not located in an accessible area, after installation, apply a
double pole switch in accordance with standards which assures the complete disconnection of the mains under conditions
relating to over-current category III, in accordance with installation instructions.
Warning! Before re-connecting the hood circuit to the mains supply and checking the efficient function, always check that the
mains cable is correctly assembled.
The hood is provided with a special power cable ; if the cable is damaged, request a new one from Technical Service.
Check that the product purchased is of a suitable size for the chosen installation area.
Remove the charcoal (*) filter/s if supplied (see also relative paragraph). This/these is/are to be mounted only if you
want to use the hood in the filtering version.
Check (for transport reasons) that there is no other supplied material inside the hood (e.g. packets with screws (*),
guarantees (*), etc.), eventually removing them and keeping them.
If possible, disconnect and move freestanding or slide-in range from cabinet opening to provide easier access to rear
wall/ceiling. Otherwise put a thick, protective covering over countertop, cooktop or range to protect from damage and
debris. Select a flat surface for assembling the unit. Cover that surface with a protective covering and place all canopy
hood parts and hardware in it.
In addition check whether near the installation area of the hood (in the area accessible also with the hood mounted) an
electric socket is available and it is possible to connect a fumes discharge device to the outside (only suction version).
Carry out all the masonry work necessary (e.g. installation of an electric socket and/or a hole for the passage of the
discharge tube).
Expansion wall plugs are provided to secure the hood to most types of walls/ceilings. However, a qualified technician must
verify suitability of the materials in accordance with the type of wall/ceiling. The wall/ceiling must be strong enough to take
the weight of the hood. Do not tile, grout or silicone this appliance to the wall. Surface mounting only.
9
OPERATION
Use the high suction speed in cases of concentrated kitchen vapours. It is recommended that the cooker hood is switched on
for 5 minutes prior to cooking and left in operation during cooking and for approximately another 15 minutes after terminating
cooking. Below described three types of operation.
ROCKER SWITCH
BUTTON CONTROL
– Hood operation ON / OFF. When pressing the button, the hood will start to operate on
speed level 1.
– Press the Speed 2 button to start the motor with speed 2.
– Press the Speed 3 button to start the motor with speed 3.
– Light button to switch the light ON. Press again to switch the light OFF.
10
The hood operation is controlled by (three) switches, which are located on each side. They are visible when the telescopic
front is ejected.
The telescopic hood is equipped with a limit switch. Every time you eject the telescopic front, the hood will start operating on
the previously set gear.
MAINTENANCE
CLEANING
CHARCOAL FILTER (FILTER VERSION ONLY)
It absorbs unpleasant odours caused by cooking. The saturation of the charcoal filter occurs after more or less prolonged
use, depending on the type of cooking and the regularity of cleaning of the grease filter. In any case it is necessary to the
cartridge at least every four mounths. The charcoal filter may NOT be washed or regenerated.
ATTENTION! Before performing any maintenance operation, isolate the hood from the electrical supply by switching
off at the connector and removing the connector fuse.
Or if the appliance has been connected through a plug and socket, then the plug must be removed from the socket.
The cooker hood should be cleaned regularly (at least with the same frequency with which you carry out maintenance of the
fat filters) internally and externally. Clean using the cloth dampened with neutral liquid detergent. Do not use abrasive
products. DO NOT USE ALCOHOL!
WARNING: Failure to carry out the basic cleaning recommendations of the cooker hood and replacement of the filters may
cause fire risks. Therefore, we recommend observing these instructions. The manufacturer declines all responsibility for any
damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety
recommendations.
GREASE FILTER
Traps cooking grease particles. The grease filter must be cleaned once a month using non aggressive detergents, either by
hand or in the dishwasher, which must be set to a low temperature and a short cycle. When washed in a dishwasher, the
grease filter may discolour slightly, but this does not affect its filtering capacity. To remove the grease filter, press it and pull it
down.
Andere Handbücher für HHO60TAMI
1
Inhaltsverzeichnis
Sprachen:
Andere Hisense Dunstabzugshaube Handbücher
Hisense
Hisense HHO60TAMI Montageanleitung
Hisense
Hisense MH9INBG Bedienungsanleitung
Hisense
Hisense HAS949BSC Bedienungsanleitung
Hisense
Hisense CH6C4BXUK Bedienungsanleitung
Hisense
Hisense CH6IN6BXBG Bedienungsanleitung
Hisense
Hisense CH6T4BXUK Bedienungsanleitung
Hisense
Hisense MH6INBG Bedienungsanleitung
Hisense
Hisense CH6C4AXUK Bedienungsanleitung
