Hitachi SINELINK 24G Bedienungsanleitung

150Mbps High-speed Radio Link

User’s Manual

Please read ahead of the use.

SINELINK24G

Caution:

Changes or modifications not expressly approved by Hitachi Kokusai Electric Inc.

could void the user's authority to operate the equipment.

Note:

This equipment has been tested and found to comply with the limits for a Class A

digital device, pursuant to part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference when the equipment is

operated in a commercial environment. This equipment generates, uses, and can

radiate radio frequency energy and, if not installed and used in accordance with the

instruction manual, may cause harmful interference to radio communications.

Operation of this equipment in a residential area is likely to cause harmful interference

in which case the user will be required to correct the interference at his own expense.

SINELINK24G

1. INTRODUCTION ............................................................................1

1-1 TARGETS .....................................................................................1

1-2 PRODUCT SUMMARY.....................................................................1

1-3 FEATURES ...................................................................................1

1-7 NAME AND EXPLANATION OF MAIN BODY EACH PART .......................2

1-8 DIRECTIVITY OF ANTENNA .............................................................3

1-9 CONNECTING SINELINK24G.......................................................4

2. INSTALLATION, CONNECTION, SETTING..................................5

2-1 INSTALLATION FLOW.....................................................................5

2-2 SETTING UP FROM PC..................................................................6

2-3 PREPARATION FOR INSTALLATION. ............................................... 11

2-4 INSTALLATION ............................................................................12

2-5 CONNECT TO LAN EQUIPMENTS .................................................20

2-6 CONFIRM THE RF STATUS...........................................................20

3. USE OF THIS DEVICE.................................................................21

3-1 POWER-ON...............................................................................21

3-2 POWER-OFF ..............................................................................21

3-3 MAINTENANCE BY WWW BROWSER ...........................................21

4. APPENDIX....................................................................................33

4-1 SPECIFICATION ..........................................................................33

4-2 RF CHANNEL ALLOCATION NUMBER .............................................35

4-8 FACTORY DEFAULT.....................................................................36

SINELINK24G

1. INTRODUCTION

This manual describes the use of SINELINK24G.

Please read this manual carefully before using the equipment.

1-1 Targets

This manual targets the engineer who has knowledge of LAN, TCP/IP, and a WWW

browser at the business level.

1-2 Product summary

* Using unlicensed 24GHz band, everybody can use SINELINK and install anywhere.

* The through-put achieves 56Mbps for each uplink and downlink.

* Wireless communication circuit enables high-speed data communication system in

areas where wire circuit installation is not available, due to obstacles such as rivers,

railroad, principal road, etc..

1-3 Features

(1) 150Mbps high-speed transmission

 150Mbps radio transmission speed as optic fiber

 Enough effective through-put to achieve transmission of moving image etc.

(2) Unlicensed and uncrowded 24GHz band

 Enough channels availability (8ch)

 Dynamic frequency selection function (Avoid using interfered channel and

enable the stable circuit quality)

 No license required, you can use SINELINK if only the installation has been

done.

(3) High security

 Data is scrambled

 Unique and nonpublic radio protocol

* This secures important data

 Pencil beam antenna (3.5 degrees or less)

* Narrow beam prevents unexpected receiver

(4) Easy installation (Note 1)

 Compact and light weight

* 29 x 29 x 7cm, Approx. 3kg (Antenna is contained)

 Easy direction tuning by watching hole only

 Compliant with IEEE802.3af

 Parameter setting and status confirmation by PC Web style input only

(Note 1) Communication cannot be performed under the condition that opposite

product is unseeable.

SINELINK24G

1-7 Name and explanation of main body each part

Name explanation

(a)

Antenna The radio wave emits from the antenna

side.

The antenna side is turned to the opposing

device for set up.

(b)

Direction Adjustment Scope By looking from the hole in scope, the

direction of this antenna is adjusted.

(c)

Heat radiation fin integrated

back lid

It releases internal heat into air.

(d) Mount bracket It fixes this device to pole.

The diameter of a pole is 25 ~ 45mm.

(e)

LAN connecter Connect LAN cable.

At the outdoor installation, connect LAN

cable with waterproofing cap.

(f) The atmospheric pressure

adjustment hole

The atmospheric pressure in this product is

adjusted.

(g)

GND (FG) Terminal Connect grounding wire.

(a) (b) (c) (d) (b) (d) (e) (f) (g)

approximately

29cm

approximately

29cm

approximatel

7cm

approximately

8cm

SINELINK24G

1-8 Directivity of antenna

Directivity of antenna

Horizontal direction 0.5°

Vertical direction 0.5°

Antenna pattern

-50

-45

-40

-35

-30

-25

-20

-15

-10

-5

-30 -20 -10 0 10 20 30

Angle(degree)

Gain(dB)

-8

-7

-6

-5

-4

-3

-2

-1

-2 -1 0 1 2

Angle(degree)

Gain(dB)

SINELINK24G

1-9 Connecting SINELINK24G

Connected composition example is shown below.

* Example1

When you use PoE-PSE Adapter

* Example2

When you use PoE-PSE Switching-HUB

(1) The communication distance between this product and opposite product is 5 ~

2000m (recommendation).

(2) This product connects with PoE-PSE. Maximum cable length that adds (2) to (3) is

100m. Please use the STP cable and the serge protective device when you

connect outdoor with indoor.

(3) PoE-PSE connects with Switching-HUB.

(4) The terminal GND of SINELINK 24G must connect with grounding conductors.

(5) Use the Switching-HUB corresponding to 100Mbps(full-duplex).

(6) Ground it through PoE-PSE when you use the STP cable for (2).

Outdoor or Indoor

Opposite

product

This product

PoE-PSE

Adapter

Switching-

HUB (5)

(2) (3)

Indoor

Connect LAN

equipments and PC for

setting.

(4)

GND

(1)

Outdoor or Indoor

Opposite

product

This product

PoE-PSE

Switching-HUB (5)

(2)

(4)

GND

Connect LAN

equipments and PC

for setting

Indoor

(1)

(6)

GND

(6)

GND

SINELINK24G

2. Installation, Connection, Setting

2-1 Installation Flow

Setting up from PC

Install after setting values by WWW browser of PC.

(1) Confirm a setting environment.

(2) Change IP Address of PC for setting.

(3) Setting this product from PC.

Preparation

Prepare in indoor environment before installation.

(1) Confirm fit of the mounting kit.

Installation

Fix this device to pole.

Connection

Connect this device to LAN equipment.

Check Wireless Status

Confirm the wireless of this device

by WWW browser of PC.

SINELINK24G

2-2 Setting up from PC

(1) Confirm a setting environment.

Please confirm the following content.

 PoE-PSE(Power over Ethernet - Power Sourcing Equipment)

* It is a state of feeding power to this product.

 LAN cable

* The length of the cable from this device to the switching HUB is within 100m in

total.

* Straight cable for both LAN cables from this product to switching HUB.

(Switching HUB corresponding to Auto MDI/MDI-X can be connected also with

cross-over cable.

 Switching HUB

* Support for 100BASE-TX (100Mbps full duplex)。

* Auto negotiation or 100Mbps(Full-Duplex) fixation for setting of connected port

with this product.

* Connected port with this product is linked by 100Mbps full duplex.

* Connected port with PC is linked.

 PC for Setting

* OS：Microsoft Windows XP/2000 Professional

* WWW Browser：Microsoft Internet Explorer 6.0 SP1 or above.

When OS and WWW Browsers other than specification are used, this device

might not work normally. Please use specified OS and a WWW browser.

(2) Change IP Address of PC for setting.

 Change IP Address and Subnet Mask of PC for setting to the following values.

* IP Address: 192.168.0.1 ~ 192.168.0.254 (without 192.168.0.202)

* Subnet Mask: 255.255.255.0

 Factory Default of SINELINK 24G

* IP Address: 192.168.0.202

* Subnet Mask: 255.255.255.0

SINELINK24G

(3) Setting this device from PC.

Set this device by WWW browser so that the wireless may communicate with the

opposite product.

1 To get to setting

pages, browse to

SINELINK 24G by

entering the URL in the

location bar of your

browser.

The URL is

http://192.168.0.202/

(factory default).

2 Enter “administrator”

in the User Name field.

Do not enter anything in

the Password field.

(factory default is none)

Please set it later.

3 Click Settings for

Wireless and LAN.

Inhaltsverzeichnis

Andere Hitachi Radio Handbücher

Hitachi

Hitachi UR 18DSL Bedienungsanleitung

Hitachi

Hitachi UR 10DL Bedienungsanleitung

Hitachi

Hitachi KH335BE Bedienungsanleitung

Hitachi

Hitachi UR 18DSL Handbuch

Hitachi

Hitachi TRK100DAB Bedienungsanleitung

Hitachi

Hitachi UR 10DL Bedienungsanleitung

Hitachi

Hitachi KH530B Bedienungsanleitung

Hitachi

Hitachi KH337E Bedienungsanleitung

Hitachi

Hitachi KH 322 Bedienungsanleitung

Hitachi

Hitachi UR 18DSAL Bedienungsanleitung

Hitachi

Hitachi KHI340E Bedienungsanleitung

Hitachi

Hitachi UR 10DL Bedienungsanleitung

Hitachi

Hitachi UR 18DSAL Bedienungsanleitung

Hitachi

Hitachi UR 18DSL Bedienungsanleitung

Hitachi

Hitachi UR 18DSL Fehlerbehebungshandbuch

Hitachi

Hitachi UR 18DSL2 Bedienungsanleitung

Hitachi

Hitachi UR 10DL Bedienungsanleitung

Hitachi

Hitachi AXM1204E Bedienungsanleitung

Hitachi

Hitachi KH1000D Bedienungsanleitung

Hitachi

Hitachi KH 312 Bedienungsanleitung

Hitachi

Hitachi KH335FMBE Bedienungsanleitung

Hitachi

Hitachi KHD150E Bedienungsanleitung

Hitachi

Hitachi UR 18DSL2 Bedienungsanleitung

Hitachi

Hitachi UR 18DSL2 Bedienungsanleitung

Beliebte Radio Handbücher anderer Marken

EisSound

EisSound KBSound iSelect Bedienungsanleitung

Midland

Midland 1001LWX Bedienungsanleitung

Konig

Konig HAV-SR41 Bedienungsanleitung

Roberts

Roberts exprssion Bedienungsanleitung

VDigi

VDigi DD3.0 Bedienungsanleitung

Radio Shack

Radio Shack 21-1863 Bedienungsanleitung

Roberts

Roberts Stream 207 Bedienungsanleitung

Sony

Sony Walkman SRF-M97 Bedienungsanleitung

Stanley

Stanley FatMax FMC770 Bedienungsanleitung

auna

auna DAB-Radio 10026947 Bedienungsanleitung

SOUNDMASTER

SOUNDMASTER UR190 Bedienungsanleitung

HYT

HYT TC-320 Bedienungsanleitung

B-Tech

B-Tech GMRS-V2 Bedienungsanleitung

Weierwei

Weierwei VEV-V8 Bedienungsanleitung

SOUNDMASTER

SOUNDMASTER DAB750 Bedienungsanleitung

Telefunken

Telefunken TF-1505 Bedienungsanleitung

Makita

Makita LXRM03 Bedienungsanleitung

PRESIDENT

PRESIDENT TEDDY R. Bedienungsanleitung