10
REGISTRATION
STATUS
display
REG
button
Step 1
Ste
2
Ste
3
3.3 BELT-PAC & ODYSSEY IQ HEADSET
SETUP AND REGISTRATION
The first time you operate the System 6001, you must register each Belt-pac and/or Odyssey IQ
Headset for use with a specific base station. The base station will then recognize all registered
Belt-pacs/Headsets when their power is on, and will know the difference between them and other
electronic equipment operating on the same frequencies. If a Belt-pac/Headset is added or
replaced later, the new one must be registered but the old one will remain in memory. Since only
15 Belt-pacs and/or Odyssey IQ Headsets can be in memory, whether currently in use or not, all
memory must be cleared to remove any old Belt-pac/Headset registrations.
3.3.1 Set Up Belt-pacs
Before registering them, set up each Belt-pac as follows.
Step 1. Insert a fully charged battery in the
Belt-pac, with the metal contacts on the end of
the battery inserted first. Press it in until it snaps.
Step 2. Place the Belt-pac in the pouch.
Step 3. Plug the headset cable connector into the Belt-pac.
3.3.2 Register Belt-pacs
NOTE: Belt-pacs must be within 6 feet (1.83 meters) of the base station while you are registering
them. Press the base station PWR button to turn it on, and be sure each Belt-pac you are going to
register is turned off before you begin. Belt-pacs that are already registered can be on or off.
Step 1. Put the headset, of the Belt-pac being registered, on your head.
Step 2. Press the REG button on the front panel of the base station.
The REGISTRATION STATUS display on the
base station will show a small “o” for open.
NOTE: If you wait too long before going on
to Step 3, the base station will go out of the
registration mode and you will have to repeat Step 2.
Step 3. Press and hold the Bbutton on the Belt-pac while you press and release the PWR (power) button to
turn the unit on, then release the Bbutton. This will cause the Belt-pac to enter the registration mode.
The two power lights will begin blinking red,
then will blink green two or three times and go off.
Wait! There may be a short delay.
Power lights
