Step 4
Do not pull the circuit board away from the pager case until you have detached the battery. After removing the two
screws, slowly pull up the circuit board. Detach the white connector going from the battery wires to the circuit board.
Ensure that the pagers side button does not fall out.
Step 5
When the battery is no longer connected to the circuit board, use the opener tool to remove the battery from the
bottom case. Take your new battery, place it in the same location and press down to secure.
Step 6
Once the new battery is attached to the bottom case, connect the battery wires to the connecter on the bottom of the
circuit board.
