on model 256652/IDT)
Verificationof shield integrity
Cross talk detectionin excess of 3dB + 0.3dBat 3.5Mhz
between any twopairs
Specially designed remoteunit that enables one person to
test installed cables
Easy to readfault display and high speed testing
Debug mode fordetailed fault identification results
Auto sleep modeand power off switch todecrease power
consumption
LANtest Pro Specifications
Connectors
LANtest Pro MainUnit RJ45 jack
Remote Unit RJ45 jack
Pairs tested
1/2, 3/6, 4/5,7/8 and shield
LED display
Horizontal: 5 GreenLEDs for pair andshield display
(1-2, 3-6, 4-5,7-8 and shield)
TONE G. LED (for models 256652/LBT, 256652/TK,
256652/TFK and 256652/IDT)
Vertical: 5 Red LEDs for fault displayand #ID display
(OPEN, SHORT, REVERSED, MISWIRE,
SPLIT PAIRS and LOW BATTERY)
For 256652/IDT thefault display shares with the #ID
Display (#1, #2,#3, #4)
Cable test lengthlimit
Minimum: 0.4m Maximum:Over 200m
Power:
LANtest Pro: 6Valkaline DC battery
Remote identifier: Nobattery required
Dimensions:
LANtest Pro: 125x 52 x 30 mm (Lx W x H)
Low battery indicator
LANtest Pro Cable Test Operation:
1.Select "Cable" positionon the toggle switch.
2.Plug one endof the subject cable into theRJ45 jack on
the master unitand the other end into theRJ45 jack on
the remote terminator.
Note: The remote terminatorcan be slippedand locked intothe
master unit forconvenient testing ofpatch cables.
3.Push the testbutton and check the results: First,check
the 5 horizontallyaligned green LED indicators (1-2, 3-
6, 4-5, 7-8,SHIELD) for integrity status:
Solid light : pair is OK
Flashing light : pair is faulty
No light : open pair
a. Simultaneously, check the 5 vertically alignedLED
indicators (SHORT, REVERSED, MISWIRE,SPLIT
PAIRS)for the wiring faults.
b. For moredetailed information about what faults are
occurring in whichpairs, hold the TEST button for2
seconds to activate"Debug mode." The tester will test
each pair oneby one, pausing briefly on eachpair, and
display the correspondingfault status.
LANtest Pro Tone Generator Operation(only
available on models 256652/LBT, 256652/TK,
256652/TFK and 256652/IDT):
1. Slide thetoggle switch on the LANtest Proto the "Tone"
position
2. Quickly pressthe TEST button once for continuoustone
mode, or holddown for two full seconds forwarble tone
23
