Hobie SPORT CRUISER 21 Bedienungsanleitung

WELCOME TO THE

HOBIE WAY OF LIFE

Congratulations on the purchase of your new HOBIE 21 Sport Cruiser and welcome to the HOBIE® sailing family. The beauty

of the 21 Sport Cruiser is that a single adult can sail it at top performance - and a crew of four can cruise in comfort.

We offer this manual as a guide to increased safety and enjoyment of your new boat. The purpose of this publication is to

provide easy, simple and accurate instructions on how to get your Hobie 21 SC ready for the water. Please read them

carefully and familiarize yourself with the boat and all of the parts spread before you.

Whether you are a new sailor or a veteran of many years, we recommend that you read this thoroughly before your first sail

and TRY IT OUR WAY FIRST! If you are new to sailing, this manual alone is not intended to teach you how to sail. There are

many excellent books, videos and courses on the safe handling of small sailboats. We suggest that you contact your local

sailboat dealer, college or Coast Guard Auxiliary for recommendations.

Watch for overhead wires whenever you are rigging, launching, sailing or trailering with the mast up. CONTACT OF THE

MAST WITH POWER LINES COULD BE FATAL! Be certain that the rigging area and the area that you will be sailing in are

free of overhead power lines. Report any such power lines to your local power authority and sail elsewhere.

We take pride in presenting the Hobie 21 SC to you and hope that you'll take as much pride in owning her.

Fair winds and good sailing!

This assembly manual takes you step-

by-step through the setting-up and

sailing of your new HOBIE 21 SC.

This manual will help you understand

each part in detail.

Setting up your Hobie 21 SC PAGE

Framing the Hulls..............................2-3

Lacing the Trampoline, Main ................4

Bow Spreader ......................................5

Lacing the Trampoline, Front ...............5

Cat Cabin .............................................6

Wings ................................................6-7

Rudders................................................8

Tiller Cross Bar and Extensions ...........8

Centerboards........................................9

Drain Plugs.........................................10

Mast...............................................10-11

Preparing the Mast........................12-14

Mast Stepper.................................15-16

Boom Installation................................17

The Jib ..........................................18-19

The Main Sail ................................19-20

Downhaul and Outhaul.......................20

Hull Storage Hatches .........................21

The Tent (option) ...........................21-22

Motor Mount (option)..........................22

Jennaker (option) ...............................26

Sailing your Hobie 21 SC ...........PAGE

Topping LIft ...............................................23

Furling the Mainsail..................................23

Righting the Cruiser .................................23

Trailering...................................................24

Comptip Maintenance..............................24

Routine Maintenance .........................24-25

Safety........................................................25

Sailing Basics......................................27-30

Safety tips ..................................Back page

HOBIE 21 SPORT

CRUISER ASSEMBLY MANUAL

I. FRAMING YOUR BOAT.

l.l USING THE CARDBOARD CRADLES

FROM THE SHIPPING BOX, PLACE HULLS

PARALLEL TO ONE ANOTHER SO THAT

PHANTOM LINES 1 AND 2 ARE OF EQUAL

DISTANCE. WIDTH APART = 8'6" (FIGURE

1.2A INSTALL MAIN TRAMPOLINE INTO

LOWER SLOT OF FORWARD CROSS BAR.

(FIGURE 2)

1.3 INSTALL FRONT CROSSBAR (SEE

NEXT PAGE FOR DIAGRAM)

NOTE - READ ALL INSTRUCTIONS PRIOR TO ASSEMBLY.

TRAMPOLINE INSTALLATION

SLIDE INTO TRAMP

TRACKS BEFORE

MOUNTING THE X-

BAR TO THE

HULLS.

8’ 6”

FIGURE 1

FIGURE 2

-CAUTION-

If BOLTS FEEL LIKE YOUR FORCING THEM

TO THREAD, BACK THEM OUT AND CHASE

TAPPED HOLES WITH A 3/8" -16 TAP.

FORCING THREADING WILL DAMAGE THE

BOLT AND TAPPED HOLE THREADS.

APPLY ANTI SEIZE

PRIOR TO INSTALLING

(PREVENTS THREAD

DAMAGE)

(4” BOLTS

INSTALL IN

REAR BAR)

2. INSTALLING CROSS BAR BOLTS

Applies to both front and rear cross bars

3/8” X 3/4” WASHERS

FROM RIG KIT

FRONT BAR -

STDB OUTBOARD

APPLY RTV SEALANT

AROUND HOLES PRIOR

TO INSTALLATION

STBD HULL - OUTBOARD

FIGURE 3

3. LACING YOUR TRAMPOLINE

LINE STARTS AT GROMMET

IN TRAMP W/ A BOWLINE

KNOT.

3.1 Before lacing, slide the tramp into the tracks in both of the hulls. Be sure to slide back as

far aft as possible. Using soapy water helps with the installation of the tramp.

3.2 Place tramp lace bar in tramp as shown below. (FIGURE 4)

3.3 Follow the rear X-bar lacing diagram (Figure 5)

NOTE: Tighten tramp to individual preference. Do not use any tramp tightening device. This

may cause damage to the tramp.

INSERT ROD IN AFT LOOP OF THE TRAMP AS SHOWN

FIGURE 5

FIGURE 4

4. BOW SPREADER INSTALLATION

Install the bow spreader bar assembly with the open slot towards the aft of

the boat using the four round head bolts provided.

5. FRONT TRAMPOLINE INSTALLATION

Insert the forward trampoline into the upper groove of the front X-bar. The trampoline folds over the

front X-bar and then inserts into the forward trampoline track. Slide the tramp track forward (leave

loose until cat cabin is fully installed). After the cat cabin has been fully tensioned down...pull the

tramp forward until taunt to slugs in forward spreader bar.

INSTALLATION HINT:

USE SOAPY WATER TO HELP

INSTALL THE TRAMPOLINE.

FOLLOW THE LACING SEQUENCE SHOWN ABOVE

(TIE BOWLINE KNOT HERE)

FIGURE 6

6. 21 SPORT CRUISER FWD. TRAMP LACING INSTRUCTIONS

REMINDER:

DO NOT TENSION FRONT

TRAMPOLINE UNTIL CAT CABIN

IS FULLY TENSIONED DOWN.

8. WINGS

8.1 Identify the left and right wing assemblies.

Red Dot = LEFT

Green Dot = RIGHT

8.2 Mark the legs with tape as shown. These

points indicate full and complete insertion of

the legs into the hull. (FIGURE 8)

8.3 Put the right wing legs into the sockets and

place the right seat onto the legs. All parts are

pre-drilled so the holes should line up properly.

Rivet the seat onto the legs using rivets and

rivet caps. (FIGURE 9)

FIGURE 8

FIGURE 9

7. CAT CABIN

(FRONT TRAMPOLINE MUST BE LOOSE) POSITION BOX OVER FRONT CROSSBAR. EASE

DOWN OVER CROSSBAR. STUDS IN THE BOTTOM OF CAT CABIN PASS THRU THE

TRAMPOLINE SLOTS. REMOVE TWO BLACK PLATES, FOUR BLACK LOCK KNOBS AND LOCK

WASHERS FROM RIG KIT. PLATES INSTALL SO THAT THE CABIN IS REMOVABLE FROM

BELOW THE BOAT BY HAND.

FIGURE 7

8.4 Lace the wing tramp as shown. (FIGURE 10)

8.6 Before sailing, secure the wing legs on the

hull with a short piece of line. (FIGURE 12)

NOTE: INSTALL WING TRAMPS SO

LACE LINES DO NOT INTERFERE WITH

CUP HOLDERS (FIGURE 11)

WARNING:

WINGS WILL NOT FLOAT!

CAUTION

It is very important that the wings are

completely inserted when sailing or

whenever any load is applied to them.

Failure to completely insert the wings will

result in hull and/or wing damage. You

have inserted the wings completely when

the band of tape on the outboard side of

each insertion tube aligns with the top of

the hull deck.

8.5 To insert the wings, simply work the leg

tubes into the hull sockets an inch or so at a

time. Push one leg of the wing into the tube,

then the other and continue alternating until

both sides are completely inserted. If the wings

cannot be easily inserted using this system,

check the end caps and sockets for debris

(such as sand), improper fitting or metal burrs.

FIGURE 10

FIGURE 11

FIGURE 12

9. RUDDERS

9.1 Identify the left and the right rudder

assemblies.

Red Dot = LEFT

Green Dot =RIGHT

9.2 Insert one nylon bearing into the bottom of

each hole in the rudder castings. (FIGURE 13)

9.3 Put one cotter pin on each rudder pin.

(FIGURE 13)

9.4 Set the casting on the gudgeons. (FIGURE

13)

9.5 Push the rudder pin UP through the lower

gudgeon and make sure to place a stainless

steel washer between the gudgeon and the

nylon bearing in the casting. (FIGURE 13)

9.6 Repeat step 4.5 for the upper gudgeon.

(FIGURE 13)

9.7 Secure the top of the rudder pin with a

second cotter pin. (FIGURE 13)

9.8 Repeat for the other rudder assembly.

10. TILLER CROSSBAR

10.1 Place the red dot end (left) of the tiller

crossbar on the red dot (left) rudder.

10.2 Insert the tiller crossbar onto the rudder

arm pin so that the crossbar sets on top of the

arm.

10.3 Capture the tiller arm to the tiller crossbar

with the keyhole retainer clip on the tiller arm.

(FIGURE 14)

10.4 Attach the tiller extension to the yoke of

the tiller crossbar by inserting the clevis pin

and retaining ring. (FIGURE 15)

FIGURE 13

FIGURE 14

FIGURE 15

Andere Handbücher für SPORT CRUISER 21

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Hobie Boot Handbücher

Hobie

Hobie Mirage Kayak Bedienungsanleitung

Hobie

Hobie Float Cat 75 Montage- und Bedienungsanleitung

Hobie

Hobie Holder 12 Bedienungsanleitung

Hobie

Hobie Getaway Bedienungsanleitung

Hobie

Hobie 16 Bedienungsanleitung

Hobie

Hobie Mirage Vantage CT Bedienungsanleitung

Hobie

Hobie HCX Bedienungsanleitung

Hobie

Hobie Wave Bedienungsanleitung

Hobie

Hobie Mirage Drive Bedienungsanleitung

Hobie

Hobie 15 Bedienungsanleitung

Hobie

Hobie Hobie T2 Bedienungsanleitung

Hobie

Hobie 18 SX Bedienungsanleitung

Hobie

Hobie Wave Handbuch

Hobie

Hobie Mirage Pro Angler Bedienungsanleitung

Hobie

Hobie Mirage Tandem Island Bedienungsanleitung

Hobie

Hobie kayak Bedienungsanleitung

Hobie

Hobie Wave Bedienungsanleitung

Hobie

Hobie Quest 13 Bedienungsanleitung

Hobie

Hobie MAX RACE Bedienungsanleitung

Hobie

Hobie 17 Bedienungsanleitung

Hobie

Hobie T1 Bedienungsanleitung

Hobie

Hobie PACIFIC 18 Betriebsanleitung

Hobie

Hobie Hobie T2 Bedienungsanleitung

Hobie

Hobie Tiger Bedienungsanleitung

Beliebte Boot Handbücher anderer Marken

Raymarine

Raymarine ST70 Instrument Bedienungsanleitung

Jeanneau

Jeanneau CAP CAMARAT 8.5 CC Bedienungsanleitung

Tiara Yachts

Tiara Yachts C49 2024 Bedienungsanleitung

J 105 Bedienungsanleitung

Monterey Boats

Monterey Boats Sport Yacht 330 Bedienungsanleitung

PURSUIT

PURSUIT OS 335 Bedienungsanleitung

Boston Whaler

Boston Whaler CONQUEST 345 Bedienungsanleitung

Jeanneau

Jeanneau SUN ODYSSEY 41 DS Bedienungsanleitung

Meridian

Meridian 490 Pilothouse Bedienungsanleitung

Advanced Elements

Advanced Elements AdvancedFrame Expedition AE1009 Bedienungsanleitung

Robo Marine Indonesia

Robo Marine Indonesia GEOMAR Bedienungsanleitung

Swallow Boats

Swallow Boats BayRaider Bedienungsanleitung

Intex

Intex Excursion 5 Set Bedienungsanleitung

X SHORE

X SHORE EELEX 8000 Bedienungsanleitung

ISLAND PACKET

ISLAND PACKET 370 Bedienungsanleitung

Sea Ray

Sea Ray 175 Sport Bedienungsanleitung

Regal

Regal 2300 Bedienungsanleitung

Mercury

Mercury Sport 220/240 Bedienungsanleitung