Hobie Twixxy Bedienungsanleitung

•

ASSEMBLY MANUAL

HOBIE CAT EUROPE

ZI Toulon Est, BP 250

83078 Toulon cedex 9, France

Tel : +33 (0)494 08 78 78 - Fax : +33 (0)494 08 13 99

Email : [email protected] - http://www.hobie-cat.net

•

CAUTION DANGER

ALUMINIUM MAST

KEEP AWAY FROM

ELECTRICAL WIRES

ASSEMBLY MANUAL

SOMMAIRE

List of parts..................................................2

Wires and ropes..........................................3

Part bag, trampoline....................................4

Hull assembly...........................................5-7

Trampoline fitting......................................8-9

Rudder assembly .................................10-11

Mast Preparation of the mast....................12

Jib furler and shrouds.......................13

Stepping the mast ............................14

Trapeze............................................15

Mainsail ....................................................16

Jibsail...................................................17-18

Mainsheet system .....................................19

Cunningham and righting line...................20

Safety device.............................................21

Optional equipment : Spinnaker...........22-23

Safety & advice .........................................24

LIST OF PARTS

⇒

Hulls (2)

⇒

Front crossbar

⇒

Rear crossbar

⇒

Forward spreader bar

⇒

Mast

⇒

Trampoline

⇒

Rudder assembly (2)

⇒

Tiller crossbar

⇒

Tiller extension

⇒

Mainsail

⇒

Jibsail

⇒

Batten set (7)

⇒

Part bag

⇒

Rope bag

⇒

Wire bag

Tools required

2 #13 spanners

1 pair of pliers

Two persons are recommended to

assemble the boat

•

Wires

1. Shrouds with adjuster covers

2. Trapeze wires

3. Forestay, jib halyard assembly

4. Trapeze handles, rope lock and

shock cord.

Wires and ropes

Ropes

1. Righting line

2. Mainsheet

3. Jibsheet

4. Trampoline line

5. Main Halyard

6. Jib luff tensioning line

7. Trapeze line

8. Jib halyard

9. Cunningham

1 3

•

Part bag and trampoline

Part bag :

1. Mainsheet ratchet block

2. Mainsheet top block with hook

3. Silicone

4. Stay adjusters, clevis pins and split rings

5. Jib furler assembly

6. Shackle

7. Twist toggles.

8. Jib clew blocks with shackle

9. Cunningham block

10. Trampoline

Other parts not shown above :

⇒ Drain plugs (on the hulls)

⇒ Screws for bar fixing (on the bars)

5 6

•

Position the hulls parallel on the ground approxima-

tely 2.5 meters apart. Prepare the front crossbar.

Unscrew the nuts off of the two 2 external head

bolts. Unscrew the nuts also off of the two internal

headless bolts.

HULLS

See drawing next page for positioning of bolts

All go round the boat and tighten all eight bolts.

Lift the right hull into an upright position. One person

straddles the hull to hold in position. The other one ap-

plies the silicone sealant (for waterproofing) around the

bolt holes and on rivets.

Repeat the same operation for the other hull.

Repeat step 1 and 2 for the rear crossbar.

5 6

Taking the front crossbar, position it on

the crossbar moulding in the deck ma-

king sure that the eye strap on the bar

is facing to the rear of the boat and the

remaining headless bolt on the cross

bar fits in the hole on the deck. Insert

the long external screw.

Pass your hand through the inspec-

tion port to position the nuts and

washers onto the long bolt and the

headless bolt.

NB : Periodically check the

tightness of all 8 bolts.

•

FORWARD SPREADER BAR

Forward spreader bar assembly/Montage de la barre

de maintien parallèle.

It is highly recommended to install the forward

spreader bar if the loaded weight is more than 75

kg and wind force more than 3. Failure to respect

this recommendation may cause structural da-

mages on the hulls that will not be covered by

warranty.

Identify the right side from the left

side of the bar (look for the sti-

ckers) and position it the right way

between the two hulls. Unscrew

one of the screws fixing the pad-

eye on the hull and attach the bar

as shown on the photo.

VERY IMPORTANT / TRES IMPORTANT

Never use the forward spreader bar to carry the boat. Use the 4 handles

(2 at the front, 2 at the rear of the boat) to carry the boat.

•

HULLS

Crossbar fixation

Long bolt

Short bolt

Stainless steel nut

Stainless steel washer

Plastic washer

Crossbar

Screw with head

Headless screw

•

Unfold the trampoline. Note that the side tension

lines are prethreaded. Insert the front sealed bolt

rope edge into the trampoline track of the front

crossbar. Continue feeding the trampoline into the

trampoline track and position it in the centre. Line

up the grommet in the centre of the front edge of

the trampoline with the dolphin striker post. This

will position the trampoline in the centre.

TRAMPOLINE

Trampoline fitting

Commence lacing the rear of the trampoline. The

lacing line ties off on the lacing post at the left rear

of the rear beam. Pass the line around the rod and

back around the first lacing post. Lead the line

around the second lacing post and pass it around

the rod on the first trampoline cut out. Now, come

back around the second lacing post and continue

towards the third. Continue all the way across the

beam in the same fashion and tie off loosely. Do

not attempt to tighten the rear lacing too much at

this stage.

Pull the trampoline to the back of the boat

and insert the fibreflass rod into the rear

flap of the trampoline. Leave an equal

amount protruding from each side.

•

TRAMPOLINE

Now lead the end of the line through the eyestrap on the rear of the front beam

and back through the loop. Lead the end back through the eyestrap and apply as

much tension as possible. Maintaining the tension, lead the line through the grom-

met and back to the eyestrap. Next, lead the line through the grommet in the front

edge of the trampoline and tie off securely. Repeat procedure for port side.

Move to the front right corner of

the trampoline. Pull on the line

as firmly as possible and tie a

bowline knot or loop in the line

as close to the trampoline edge

as possible. This will enable a

4:1 purchase to be used for ten-

sioning. Tie off once tensioned

to secure.

Tensioning the sides : starting at the right rear corner, take the

line that emerges from the trampoline. Lead it through the eye

strap on the rear beam and then through the grommet/eyelet.

Tie it off with a bowline knot or similar.

Retighten rear lacing from left to right. Tie the rear lacing off securely at the eyelet posts on the right hand end

of the rear beam. NB :

It is important that the trampoline lacing is kept very tight. Check the trampoline tension

on a regular basis. Remember : all ropes streches!

•

RUDDER ASSEMBLY

Montage du gouvernail

Identify the right rudder from the left rudder (look for

the stickers on the rudder arms). As shown, line up

the rudder pintles (metal pegs on the hulls) with the

rudder castings . Push the rudder castings down

onto the pintles.

Insert the retainer clip attached to the lower pintle to

lock the rudders in place. The clip will prevent the

rudders from falling off the boat in the event of cap-

size.

Inhaltsverzeichnis

Andere Hobie Boot Handbücher

Hobie

Hobie 15 Club Bedienungsanleitung

Hobie

Hobie 15 Club Bedienungsanleitung

Hobie

Hobie Mirage Drive Bedienungsanleitung

Hobie

Hobie Gateway Bedienungsanleitung

Hobie

Hobie 16 Bedienungsanleitung

Hobie

Hobie Getaway Bedienungsanleitung

Hobie

Hobie Mirage Tandem Island Bedienungsanleitung

Hobie

Hobie HC 16 Einrichtungshandbuch

Hobie

Hobie Mirage Inflatables Bedienungsanleitung

Hobie

Hobie Float Cat 75 Montage- und Bedienungsanleitung

Hobie

Hobie Wave Bedienungsanleitung

Hobie

Hobie mirage Pro Angler Bedienungsanleitung

Hobie

Hobie H14 Bedienungsanleitung

Hobie

Hobie Getaway Bedienungsanleitung

Hobie

Hobie Mirage Lynx Bedienungsanleitung

Hobie

Hobie LANAI Bedienungsanleitung

Hobie

Hobie WILD CAT Bedienungsanleitung

Hobie

Hobie 16 Bedienungsanleitung

Hobie

Hobie 16 Bedienungsanleitung

Hobie

Hobie Brave Bedienungsanleitung

Hobie

Hobie Mirage Pro Angler Bedienungsanleitung

Hobie

Hobie Hobie T2 Bedienungsanleitung

Hobie

Hobie SPORT CRUISER 21 Bedienungsanleitung

Hobie

Hobie 17 Bedienungsanleitung

Beliebte Boot Handbücher anderer Marken

Raymarine

Raymarine ST70 Instrument Bedienungsanleitung

Jeanneau

Jeanneau CAP CAMARAT 8.5 CC Bedienungsanleitung

Tiara Yachts

Tiara Yachts C49 2024 Bedienungsanleitung

J 105 Bedienungsanleitung

Monterey Boats

Monterey Boats Sport Yacht 330 Bedienungsanleitung

PURSUIT

PURSUIT OS 335 Bedienungsanleitung

Boston Whaler

Boston Whaler CONQUEST 345 Bedienungsanleitung

Jeanneau

Jeanneau SUN ODYSSEY 41 DS Bedienungsanleitung

Meridian

Meridian 490 Pilothouse Bedienungsanleitung

Advanced Elements

Advanced Elements AdvancedFrame Expedition AE1009 Bedienungsanleitung

Robo Marine Indonesia

Robo Marine Indonesia GEOMAR Bedienungsanleitung

Swallow Boats

Swallow Boats BayRaider Bedienungsanleitung

Intex

Intex Excursion 5 Set Bedienungsanleitung

X SHORE

X SHORE EELEX 8000 Bedienungsanleitung

ISLAND PACKET

ISLAND PACKET 370 Bedienungsanleitung

Sea Ray

Sea Ray 175 Sport Bedienungsanleitung

Regal

Regal 2300 Bedienungsanleitung

Mercury

Mercury Sport 220/240 Bedienungsanleitung