HOKUYO AUTOMATIC Photo Master PNX Series Bedienungsanleitung

No.MPR-0100COsakaHUBuilding,2-2-5Tokiwamachi,Chuo-Ku,Osaka,540-0028JapanTEL：+81-6-6947-6333FAX：+81-6-6947-6350URL：http://www.hokuyo-aut.jp

PNXseries

InstructionManual

Noticeforsafety

Please be sure handle and operate the product correctly accord-

ing to the attached instruction manual etc. before making installa-

tion wiring, operation and /or maintenance of the product. If

necessary, arrange to reach the instruction manual etc. to final

responsible person.

■Installation

Caution:Make sure to make a wiring or detached connector

after power-off.

(1)Pleaseprohibitfromusingatplaces:●Places where water or oil may be spattered and much

dust exist.

●Solvent gas and corrosive gas exist.

●Direct sunlight put into the lenses.

●Any places suffered with over-rated temperature, humi-

dity, vibration, shock etc.

:Possible to cause medium damage and

slight injury, or physical damage when

mis used. However it is possible to cause

more serious result according to situation.

●This product can' t be used as safety device due to

protect human body.

●This product should be used under the voltage and current

mentioned on the product or the brochure. It is possible to

occur short circuit or fire if it is used out of reated value.

WARNING

●This product isn' t explosion-proof structure. Don' t

use it under flammable and explosive gas or liquid

environment.

●Do not disassemble, repair, or convert the product. Fail-

ure to do this may cause failure, fire, or electric shock.

●When abandon, please treat if as industrial waste.

●Sensor●Installationbracket●Reflector

■Externaldimensions

3943.9

545474.436226.418.6

CenterofopticalaxisFreepowercableφ6.42-core,2m(Projector)5-core,2m(Receiver)DCpowercable φ3.82-core,2m(Projector)Tighteningtorque0.5N.morless2ーφ4.22ーφ4.2Tighteningtorque0.5N.morlessSensitivityadjuster452016°39.5R3R342038.6402022

701.84460

1.52

20Centerofopticalaxis

Receiver（withretroreflectivetype） Projector

Stablelamp(Green)Outputlamp(Orange)51.647

5161.6

4-core,2m(Receiver)

■Connection

(1)Circuitofinputandoutput.Load●DCpowertype●Projectorofthroughbeamtype(DCpower)●FreepowertypeBrown0V0VBlueBlueBlackGreyWhiteCOMN.C.N.O.Brown

BlackWhite

DC10〜30VAC24〜240VDC24〜240V（Nopolarity）AC24〜240VDC24〜240V（Nopolarity）DC10〜30VProtectivecircuitOutputrelayFreepowercircuitBrownBlue

Changeoverof outputmodeControloutput

Maincircuit

●Projectorofthroughbeam(freepowertype)BrownBlue12①Light-onwhenwhiteleadwireisconnectedto+Vorfree.②Dark-onwhenwhiteleadwireisconnectedto0V.

MaincircuitMaincircuitMaincircuit

(2)Payattentionnottobeawrongwiring.(3)Don'tmakeaparallelwiringoruseinsametubewithpowersource/highvoltageline.Itmaycausemalfunctionbyinduction.(4)Whenusingacommercialswitchingregulatoraspersource,groundFG(Framegroundterminal)andG(Groundterminal).Ifusingwithoutground,theunitmaycausemalfunctionbyswitchingnoiseofpowersource.(5)Pleaseavoidusingthesensorwhenpowerisbeingswitchedon(approx.150ms).

■Adjustingopticalaxias

●Through beam type

(1)Installtheprojectorandreceiveroppositetoeachothersothattheopticalaxislinesup.(2)Swingtheprojectorandthereceiververticallyandfromsidetoside,andfixeachatthemid-pointintherangewheretheindicatinglampatthereceiverlightsup.●Retroreflection type

Swing the sensor vertically and from side to side, and fix

it at the mid-point in the range where the indicating lamp

lights up.

■Sensitivityadjustment

(1)SetthedetectableobjectatthedetectionpositionandturnthesensitivitycontrolslowlyfromMINtowardMAXuntiltheoutputindicator(orange)lightsup.CallitpositionA.(2)RemovedetectableobjectandturnthesensitivitycontrolfromMAXtoMINpositionwheretheoutputindicator(orange)isextinguished.CallitpositionB.(3)PointCmidwaybetweenAandBistheoptimumsensitivityposition.

ABC

■Othernotice