HP F505g Bedienungsanleitung

Battery warning



Never dismantle, crush, or pierce the battery, or allow the

battery to short-circuit. Do not expose battery being placed in

high temperature environment, if battery leaks or bulges, stop

continue to use.



Always charge using the system. isk of explosion if battery is

replaced by an incorrect type.



Keep the battery out of reach of children.



Batteries may explode if exposed to open fire. Never dispose of

batteries in a fire.



Never replace the battery on your own; have the dealer do it

for you.



Disposed of used batteries observing local regulations.

Notes on Installation

1. This product shall be installed near the rear view-mirror, at the

center of windshield, if possible, for optimal viewing.

2. Make sure that the lens is within the wiping range of the

windscreen wiper to ensure a clear view even when it rains.

3. Do not touch the lens with your fingers. Finger grease may be

left on the lens and will result in unclear videos or snapshots.

Clean the lens on a regular basis.

4. Do not install the camcorder on a tinted window. Doing so may

damage the tint film.

5. Make sure that the installation position is not hindered by the

tinted window.

6. To use the products of the attached power charger only, please

do not use other brand power charger, in order to avoid

equipment burn or cause the battery explosion.

For more operation details, please refer to CD ROM.

1Introduction

1.1 Package Contents

The package contains the following items. In case there is any missing

or damaged item, contact your dealer immediately.

Car Camcorder Bracket CD- OM

Quick start guide Car adapter

1.2 Product Overview

Top and Bottom Views

Side (Left and ight) Views

Front View

ear View

No.

Item

No.

Item

Bracket Socket

LED

Indicator

2 Microphone

9 LCD Panel

Power Button

Up Button (

)

Memory Card Slot

Down Button (

)

USB Connector

Enter Button (

)

HD(Mini HDMI) Connector

Wide Angle Lens

Back Button (

)

Speaker

2Getting Started

2.1 Inserting the Memory Card

Insert the memory card with the gold contacts facing the back of the

camcorder. Push the memory card until it clicks into place. (Use class

6 or above the micro SD cards for this camcorder; It is recommended

to format the micro SD cards before the initial use.)

To remove the memory card

Push the edge of the memory card inward until you hear/feel it click,

then allow it to push out until you can remove it from the slot.

Note:

1. Do not remove or insert the memory card when the camcorder is powered on. This

may damage the memory card.

2. It is recommended to use a 32 GB, Class 6 speed or above micro SD card.

3. It is recommended to format the micro SD cards before the initial use.

2.2 Installing in Vehicles

2.2.1 Mount to Windshield

1. Attach the bracket to the camcorder.

Slide it into the bracket holder until you hear

a click.

2. Before installing the bracket, please use

alcohol to clean the windshield and suction

cup of the bracket. Wait for dry and press

suction-cup on the windshield.

3. Hold the base firmly on the windshield

and press down the clamp to mount the

car holder to the windshield. Make sure

the base is securely locked in place.

Warning: Do not install the camcorder on a

tinted window. Doing so may damage the tint

film.

2.2.2 Adjust the camcorder

position

1. Loose the knob to swivel the

camcorder vertically or horizontally.

2. Then tighten the knob to make sure

the camcorder is securely locked in

place.

Knob

2.3 Connecting to Power

Use only the supplied car adapter to power up the camcorder and

charge the built-in battery.

1. Connect one end of the car adapter to the USB connector of the

camcorder. USB port input: DC 5V / 1A.

2. Plug the other end of the car charger to the cigarette lighter

socket of your vehicle. Once the vehicle engine is started, the

camcorder automatically powers on.

Car charger input: DC 12 /

24V.

Note:

1. ed LED light indicates the battery is charging; when devices are connecting power

cord to charge and the red light flashes, it indicates the device temperature is too high

and should unplug the power cord immediately.

2. Please take note if the environment temperature reaches 45°C or above, the car

adapter still can supply power to camcorder, but it may not charge the battery. This is

characteristic of Lithium polymer battery and is not a malfunction.

2.4 Powering the Camcorder On / Off

2.4.1 Auto Power On/Off

Once the vehicle engine is started, the camcorder automatically turns

on. If the Automatic ecord function is enabled, the recording will

automatically start right away after the camcorder turns on.

Once the vehicle engine is shut down, the camcorder automatically

saves the recording and turns off the power within 10 seconds.

Note:

Automatic power up and shut down assumes the power socket is linked to the car

ignition.

2.5 Setting the Universal Time Code (UTC)

Depending on your location, you may need to change the current UTC

setting of the camcorder so that the correct date and time are

updated when a GPS signal is detected.

1. If recording is in progress, press the button to stop

recording.

2. Press the button to open the OSD menu.

3. Use the or buttons to navigate to the Satellite

Synchronization option and press the OK button. Ensure that

the On setting is selected and press the OK button again to view

the UTC setting.

4. efer to the UTC Map below and use the or button to

select the desired setting and press the OK button to confirm

the setting.

5. Press the button to exit the menu.

* Be sure to adjust for daylight saving time (DST) by adding +1 hour

to the UTC offset

** These areas may observe half hour increments and daylight saving

time (DST)

3Using the Camcorder

3.1 Recording Videos

3.1.1 Record videos while driving

When the vehicle engine starts up, the camcorder automatically turns

on and starts recording.

ecording will automatically stop when the engine is switched off.

Note:

On some cars, the recording will continue when the engine is switched off.

With some vehicle models, the automatic power up and off feature of this car

camcorder will not function because the cigarette lighter/power socket is not linked to

the ignition system.

To work around this issue, please do one of the following:

- Manually turn on or off the cigarette lighter/power socket if this is possible with your

vehicle model.

- Manually plug in the power adapter into the socket to turn on the car camcorder and

unplug from the socket to turn off the car camcorder.

- One video file is saved for every 3 or 5 minutes of recording. If the memory card

capacity is full, the oldest file in the memory card will be overwritten.

Andere Handbücher für f505g

Inhaltsverzeichnis

Sprachen:

Andere HP Camcorder Handbücher

Beliebte Camcorder Handbücher anderer Marken

Toshiba

Toshiba CAMILEO Z100 Bedienungsanleitung

Panasonic

Panasonic NV-VS40B Bedienungsanleitung

Canon

Canon RC 260 Bedienungsanleitung

Sony

Sony Handycam DCR-DVD7E Bedienungsanleitung

Brinno

Brinno TimeLapse TLC200 Bedienungsanleitung

JVC

JVC GR-SXM68AC Kurzanleitung

Panasonic

Panasonic AG-HMC152EN Bedienungsanleitung

MYDLINK

MYDLINK DCS-6100LH Bedienungsanleitung

Sony

Sony video Hi8 Handycam CCD-TR555 Bedienungsanleitung

SECURECOM

SECURECOM V-5014B Bedienungsanleitung

Sharper Image

Sharper Image U-VIDEO Bedienungsanleitung

JVC

JVC AA-V15EG Bedienungsanleitung

Canon

Canon LEGRIA HV40 Bedienungsanleitung

Sony

Sony Handycam DCR-VX2000 Bedienungsanleitung

RCA

RCA CC616 Bedienungsanleitung

Insignia

Insignia NS-DCC5HB09 - Camcorder - 720p Bedienungsanleitung

Panasonic

Panasonic NVM40 Bedienungsanleitung

ATIK Cameras

ATIK Cameras Horizon Bedienungsanleitung

HP f505g Bedienungsanleitung

Beliebte Camcorder Handbücher anderer Marken