HP ProCurve Networking J8462A Bedienungsanleitung

Quick Start Guide 5991-2108

ProCurve Secure Router dl Analog Modem Backup Module

J8462A

SPECIFICATIONS

Features ITU V.90 Compliant

Async

Standards FCC Part 15 Class A, EN 55022 Class A, EN 61000-3-2,

EN 61000-3-3

ETSI TBR 21, IC CS-03, ACTA/FCC Part 68, AS/ACIF S002

UL/CUL 60950, AS/NZS 60950, EN 60950, IEC 60950

Physical Dimensions: 6.35cm (2.5 in) W x 9.53cm (3.75 in) D

Operating Temperature: 0°C to 50°C (32°F to 122°F)

Relative Humidity: Up to 95 percent, noncondensing at 30°C

(86°F)

Non-Operating Temperature: -20°C to 70°C (-4°F to 158°F)

Non-Operating Relative Humidity: Up to 95 percent,

noncondensing at 30°C (86°F)

Altitude: Up to 3.05 km (10,000 ft)

Eth 0/1

Eth 0/2

P/N: J8462A

US: PNBMM04AJ8462

IC: 2250A-J8462

ITE

32F8

P/N: J8462A

US: PNBMM04AJ8462

IC: 2250A-J8462

ITE

32F8

P/N:J8462A

US:PNBMM04AJ8462

IC:2250A-J8462

ITE

32F8

INSTALLATION INSTRUCTIONS

1. Remove power from the base unit.

2. If the ProCurve Router interface module is already installed in the

ProCurve Secure Router chassis, release the screws at both

edges of the module front panel and slide the module out of the

chassis.

3. Carefully align the P1 connector on the interface module with the

J1 connector on the backup module. Using only fingertip pressure

so that neither circuit board bends or flexes, ensure that the

connectors are firmly seated. Secure the backup module to the

interface module using the screws and standoff posts supplied.

4. Slide the interface module with the backup module attached into

the ProCurve Secure Router option slot until the module is firmly

seated against the chassis.

5. Secure the screws at both edges of the module.

6. Connect the cables to the associated device(s).

7. Complete installation of the base unit.

8. Restore power to the base unit.

ANALOG MODEM BACKUP (RJ-11) CONNECTION PINOUT

Pin Name Description

1-3 — Unused

4 R Network-Ring

5TNetwork-Tip

6-8 — Unused

Note For safety information for the routers and all modules,

please refer to the safety and ESD precautions in the

ProCurve Secure Router Installation Guide included

in your router shipment.

Quick Start Guide 5991-2108

ProCurve Secure Router dl Analog Modem Backup

Module

ANALOG MODEM BACKUP MODULE COMMANDS

alias <text>

Comment line to provide the text name assigned by the SNMP network

management system.

caller-id override always <number>

Forces a replacement of the incoming caller ID number with the number

given. The received caller ID, if any, is discarded, and the given override

number is used to connect the incoming call to a circuit of the same number.

Use no caller-id override (default) to disable any caller ID overrides.

caller-id override if-no-CID <number>

Allows a replacement of the received caller ID number, but only if there is no

caller ID available on the incoming call. The received caller ID, if available,

is used to connect the call. However, if no caller ID is received, the given

override number is used to connect the incoming call to a circuit of the same

number.

description <text>

Comment line to provide an identifier for this interface (for example, circuit

ID, contact information, etc.).

<text> Shows up to 80 alphanumeric characters.

dialin

Enables the modem for remote console dialin disabling the use of the

modem for backup.

init-string <string>

Specifies an initialization string for the modem using standard AT

commands.

<string> Initialization string using standard AT

commands. The default string is

ATE0Q0V1X4\N0.

shutdown

Turns off the interface. By default, all interfaces are disabled. Use the no

shutdown command to enable the interface and allow it to pass data.

Note This command list is an illustration of available

commands. For complete command descriptions and

default values, refer to the SROS Command Line

Interface Reference Guide provided on your ProCurve

SROS Documentation CD.

Andere HP Modem Handbücher

HP D7808A Bedienungsanleitung

HP p5091a Bedienungsanleitung

HP 8886 - Photosmart Camera Dock Digital Docking... Bedienungsanleitung

HP Pavilion xe800 - Desktop PC Handbuch

HP J8135A Bedienungsanleitung

HP Compaq Presario Bedienungsanleitung

HP V.90 56K PCI Modem Bedienungsanleitung

HP Pavilion 9888 Handbuch

Beliebte Modem Handbücher anderer Marken

Davicom

Davicom DM562AP Bedienungsanleitung

Zte

Zte WiMAX Bedienungsanleitung

Intelimax

Intelimax MA-2060 Bedienungsanleitung

SMC Networks

SMC Networks D3CM1604V Gebrauchs- und Pflegehandbuch

Telstra

Telstra Wi-Fi 4G Advanced Pro X Bedienungsanleitung

Thrane&Thrane

Thrane&Thrane imarsat EXPLORER 300 Bedienungsanleitung

Samsung

Samsung AceLink SAM-335A Bedienungsanleitung

Enfora

Enfora Enabler-G Kurzanleitung zur Einrichtung

iRZ

iRZ ATM2-232 Bedienungsanleitung

Zhone

Zhone 6310 Bedienungsanleitung

Paradyne

Paradyne Hotwire 7976 Bedienungsanleitung

US Robotics

US Robotics 3453C Bedienungsanleitung

MaxTech

MaxTech Plug & Play Internal Voice/FAX/Data/SVD... Bedienungsanleitung

Zte

Zte MF823 Bedienungsanleitung

Four-Faith

Four-Faith F1403 Bedienungsanleitung

Sierra Wireless

Sierra Wireless AIRLINK MP595W Bedienungsanleitung

Gemtek

Gemtek WiMAX WIXFBR-103 Bedienungsanleitung

Zoom

Zoom 1070 Series Bedienungsanleitung