HP LC2000r - NetServer - 128 MB RAM Bedienungsanleitung
HP NetServer LC 2000
with
HP Rack Storage/12FC
Windows 2000 Advanced Server
Cluster Configuration Guide
16 May 2000
(see Versions at the end of this document)
Introduction
This document defines the supported HP NetServer LC 2000 configuration with HP Rack Storage/12FC
and Microsoft Cluster Server. These configurations minimize single points of failure (SPOF), provide
maximum availability, and have been certified by Hewlett-Packard and Microsoft. This guide is
prescriptive; it describes the configurations supported by HP. Any deviance to these configurations can
result in an inoperative cluster or an operating cluster with degraded performance, hidden SPOFs, etc., and
therefore will not be supported by HP.
What’s Defined in Cluster
Cluster
SPUs
Local and Shared Storage
Intra-cluster and Client LANs
Shared Storage Cabling
Cluster
Type of SPUs HP NetServer LC 2000
Each node must be the same model SPU, but may have different size main
memory, cache, and CPU clock speeds.
Installation Pedestal or racked
Number of nodes 2
Shared Storage HP Rack Storage/12FC with 2 FCArray Cards, HP disks, and using a HP
D8602A HBA in the server. See Shared Storage below.
LANs:
Client LAN Any NIC that is HP and Microsoft approved. See Client LAN below.
Intra-cluster
(Heartbeat) LAN Embedded NIC with crossover cable. See Intra-cluster LAN below.
Power source Direct from power mains, power conditioner or uninterruptible power
supply (UPS) using any power conditioner or UPS.
System software:
Navigator version L.18.02 or later
Operating System Microsoft Windows 2000 Advanced Server
SPU
Model HP NetServer LC 2000
Clock speed 733 MHz
No. of CPUs 2
BIOS version 4.06.20 PV or later
CPU cache Any size
RAM 256 MB minimum. Must be HP.
No. of power supplies 1 standard, 2 required
Local storage See
Local Storage below.
I/O slots: P1 - Local storage
P3 - Client LAN
P5 - Shared Storage
Storage
Local
Controller Use embedded SCSI as the boot controller. For additional local storage:
May use embedded SCSI or NetRAID-1Si in PCI slot P1.
May not use embedded RAID, NetRAID-1, NetRAID-3, or NetRAID-3Si.
Driver Use driver(s) supplied with Microsoft Windows 2000 Advanced Server.
Cabinets (Physical drive
location) SPU internal drive bays or HP external drive cabinet (e.g., HP Rack
Storage/12), any number.
Disk drives Must be HP (hot swap or fixed)
SCSI bus Any HP cables that meet SCSI specifications and any SCSI bus speed.
SCSI Ids Any
Shared
HP Rack
Storage/12FC Required
Host Bus Adapter
Model HP Fibre Channel Host Bus Adapter - HP D8602A
No. of controllers 1
Driver Hhba.sys 2.06
SPU I/O slot P5
RAID level 0,1, 3, 5
Cabinet
RAID arrays Not more than eight physical drives per logical array and not more than
eight LUNs are permitted per multiple Rack Storage 12/FC clusters.
Number of cabinets 1
FC Array Cards HP Fibre Channel Array Controller - D5990A
No. of cards per cabinet 2 (Requires second card be installed in the Rack Storage/12FC)
Firmware 4.64-00 or later
Status SCSI ID 5 (fixed)
Disk SCSI IDs 0 – 3, 8 – 15 (fixed)
Disk drives: HP 9.1 GB (7200 rpm)Ultra SCSI Disk Module D6106A
HP 9.1 GB (10k rpm) Ultra SCSI Disk Module D6107A
HP 18.2 GB (7200 rpm) Ultra SCSI Disk Module D6108A
HP 18.2 GB (10k rpm) Ultra SCSI Disk Module D7031A
HP 18.2 GB (7200 rpm) Low Profile Ultra SCSI Disk Module D7174A
HP 18.2 GB (10k rpm) Low Profile Ultra SCSI Disk Module D7175A
HP 36.4 GB (10k rpm) Ultra SCSI Disk Module D8210A
Fibre Channel Cables Optical – Server to Hub Only: 50 meter D6980A
100 meter D6981A
Copper – Server to Hub and/or Shared Storage to Hub:
3 meter D6978A
5 meter D6979A
10 meter D7080A
Hub
Model HP D6976A 6-port fibre channel hub
Quantity 1
LANs
Intra-cluster (Heartbeat) LAN Client LAN
LAN connection HP D5954A crossover cable or any
equivalent. Any LAN
The intra-cluster LAN may only be
used for cluster node
communication via a crossover
cable. It may not be used for client
communication.
NIC:
Model Embedded NIC Any that is on both the HP
Tested Products List and the
Microsoft Hardware
Compatibility List.
Driver Supplied with Microsoft Advanced
Server CD Any driver
NOTE If the NIC used is the
same type as the embedded NIC
(D5013A/B), then the Client
LAN NIC must use the same
driver as the Intra-cluster NIC.
No. of NICs 1 1 minimum
SPU I\O slot N/A P3
Shared Storage Cabling
This part of the guide defines the allowable cabling configurations for clusters using the HP NetServer
LC2000 and HP Rack Storage/12FC. Only this cabling configuration and cables are supported.
NOTES
The HBA and NICs must be
installed in PCI slots as follows:
HBA in P5
Client LAN in P3
Intra-cluster LAN (embedded NIC)
Fibre-channel HBA
with GBICs
6-port Fibre-channel
Hub with GBICs. The
recommend port
connections are as
shown.
LEGEND
Heavy, dark lines are fibre
channel Optical or Copper
cables. See inside this
guide for specifications.
Versions
16 May 2000 Corrected drawing.
11 May 2000 Initial release.
Andere Handbücher für LC2000r - NetServer - 128 MB RAM
16
Dieses Handbuch passt für folgende Modelle
4
Inhaltsverzeichnis
Andere HP Server Handbücher
HP
HP T5135 - Compaq Thin Client Handbuch
HP
HP 4700 Installations- und Benutzerhandbuch
HP
HP ProLiant ML110 Bedienungsanleitung
HP
HP ProLiant Server Anleitung zur Verwendung
HP
HP MultiSeat t100 - Thin Client Technisches Datenblatt
HP
HP 9x9KS Series Kurzanleitung
HP
HP 9000 V-Class Handbuch
HP
HP ProLiant ML115 G5 Gebrauchsanweisung
HP
HP StorageWorks S1000 - NAS Bedienungsanleitung
HP
HP AlphaServer ES47 Stücklistenhandbuch
HP
HP L1000 - 9000 - 0 MB RAM Bedienungsanleitung
HP
HP ProLiant ML330 Generation 3 Bedienungsanleitung
HP
HP mt245 Handbuch
HP
HP Cluster Platform Express v2010 Merkblatt
HP
HP D7171A - NetServer - LPr Bedienungsanleitung
HP
HP ProLiant EC200a Bedienungsanleitung
HP
HP Compaq t5525 Bedienungsanleitung
HP
HP DL120 - ProLiant - G5 Bedienungsanleitung
HP
HP ProLiant ML350 Gen9 Bedienungsanleitung
HP
HP D7171A - NetServer - LPr Bedienungsanleitung
