HP 705 Kurzanleitung

For Series 700 systems operating with HP-UX releases 9.01, 9.03, and 9.05, you

must load patch PHCO_5881 for disktab and sam functionality, and patch

PHSS_5776 for network installation functionality.

For Series 300 systems, this disk drive is supported on the following releases by

loading the appropriate patch:

HP–UX 9.03: PHCO_6819

HP–UX 9.10: PHCO_6819

Pascal: Rev.

3.25C (Quantum only

, not needed for Seagate)

Basic: Rev. 6.3; SCSI Binary Rev. 6.7

For

Series 400 systems, this disk drive is supported at HP-UX release 9.03 and 9.10,

with patch PHCO_6819 required for full functionality of newfs and sam.

The software patches may be obtained from HP Customer Service.

To install the patches to HP–UX, perform the following steps:

1. Begin the HP-UX software installation process. If the system has a one of the

drives installed, the following message appears:

“Note:

the destination disk type “

disk–drive

”

was not found in the disk table /etc/disktab.

(Press any key to continue.)”

2. Press any key. The screen displays the following message: “If

model

number:

“

disk–drive

”, is incorrect, and

a correct one

(one

that has an entry in the /etc/disktab) is known,

please

enter it now otherwise press return.”

3. a. For Series 300 and 400, type: Return

The

screen now displays disk physical parameters. Change three of these

param

eters as shown, leaving the other parameters at the default values:

1024 byte sectors per track: [

]

Tracks per cylinder: [

]

RPMs of the disk: [

5400

]

b. For Series 700, type: MICROP_2112 Return

The MICROP_2112 drive is functionally equivalent to the new drives. By

using this entry, you can complete the software installation process.

4. Let the software installation process complete.

5. Install the appropriate patch using /etc/update and reboot the system.

1–GB Disk Drive

User Notes

Refer to your workstation owner’s guide or your disk drive installation

guide for detailed information about installing your disk drive. During

the installation procedure, you may have to change the SCSI ID of your

disk drive. Refer to the appropriate illustration to set the SCSI ID

jumpers to the desired SCSI ID.

NOTICE: We recommend that you use SCSI ID 6 for your

workstation’s first hard disk drive, and SCSI ID

5 for the second hard disk drive.

  

The 1–GB disk drive is fully operational with HP-UX Release 9.01 and

later on Series 700 systems (releases 9.01, 9.03, and 9.05 require patches

to the operating system). On Series 300 and 400 systems, this disk drive

is supported only at HP-UX release 9.03 and 9.10, and a patch is re-

quired to obtain full functionality. Please see the patch instructions on

the last page of this document.

Also, for Series 700 systems, the following patches are necessary to run

diagnostics:

HP-UX 9.01 -Diagnostic support is not available for these

drives running on HP–UX 9.01

HP-UX 9.03 through 9.07 – PHSS_6620

HP-UX 10.01 – PHSS_6607

HP-UX 10.10 – PHSS_6796

The HP part numbers for these drives are A1658–60007 (spare) and

A1658–69007 (exchange).

Part Number A1658–90690

Edition E0696

Printed in U.S.A.



CAUTION

NOT

plugs for J2 on J6.

ou will damage the

internal contacts

use the jumper

SCSI

erm Power

from Drive

Seagate ST31051N Disk Drive Jumpers

SCSI

FRONT

Quantum 1050S Disk Drive Jumpers

Andere Handbücher für 705

Dieses Handbuch passt für folgende Modelle

Andere HP Lagerung Handbücher

HP StorageWorks 8000 - NAS Installationsanleitung

HP StorageWorks MSL5000 series Bedienungsanleitung

HP StorageWorks 1900ux Bedienungsanleitung

HP EVA P6000 Kurzanleitung

HP D2D Bedienungsanleitung

HP SureStore DLT VS80 Bedienungsanleitung

HP StorageWorks 6000 Bedienungsanleitung

HP 6400/8400 Bedienungsanleitung

HP D2D100 Bedienungsanleitung

HP StorageWorks 4000/6000/8000 - Enterprise Virtual... Bedienungsanleitung

HP Surestore 160ex - Optical Jukebox Bedienungsanleitung

HP HPE Alletra 6010 Montageanleitung

HP LeftHand P4000 - SAN Solutions Bedienungsanleitung

HP Alletra 4120 Montageanleitung

HP StorageWorks MSL2024 Handbuch

HP StoreAll 8800 Service-Handbuch

HP EVA P6000 Bedienungsanleitung

HP StorageWorks XP1024 Bedienungsanleitung

HP StorageWorks NAS 8000 - Version 1.6.X Betriebsanleitung

HP High-Performance Secure Hard Disk Bedienungsanleitung

HP MSA 2050 Bedienungsanleitung

HP Surestore 6164 - Switch Bedienungsanleitung

HP SureStore AutoBackup PC100 Bedienungsanleitung

HP 3PAR StoreServ 7200 2-node Bedienungsanleitung

Beliebte Lagerung Handbücher anderer Marken

QNAP

QNAP TS 32PXU Series Bedienungsanleitung

LaCie

LaCie RUGGED RAID Bedienungsanleitung

Freecom

Freecom CLS DOCK Bedienungsanleitung

PNY

PNY Attache P-FD64MBATT3 Bedienungsanleitung

OLT

OLT 6x6 Maximizer Bedienungsanleitung

Transcend

Transcend JetFlash 160 Bedienungsanleitung

LaCie

LaCie RUGGED MINI Bedienungsanleitung

Thunderbolt

Thunderbolt 600 Bedienungsanleitung

Panasonic

Panasonic LB-DH8 series Handbuch

Intel

Intel RAID High Availability Bedienungsanleitung

LaCie

LaCie 12big Thunderbolt 3 Bedienungsanleitung

Spectra Logic

Spectra Logic T-Series Spectra T50e Bedienungsanleitung

Panasonic

Panasonic LKM-F931-1 Bedienungsanleitung

Tabernus

Tabernus Enterprise Erase E2400 Bedienungsanleitung

Rocstor

Rocstor COMMANDER 3F series Bedienungsanleitung

Western Digital

Western Digital Ultrastar Data60 Bedienungsanleitung

Dell

Dell PowerVault MD3600f Series Bedienungsanleitung

CFI

CFI TERA STOR SATA RAID IV Bedienungsanleitung