en
►►1. INFORMATION REGARDING
SAFETY
IMPORTANT: READ AND UNDERSTAND
THIS OPERATIONAL MANUAL BEFORE
ASSEMBLING, COMMISSIONING OR
PERFORMING MAINTENANCE ON THIS
APPLIANCE. INCORRECT USE OF THE
APPLIANCE CAN CAUSE SERIOUS
INJURY. KEEP THIS MANUAL FOR
FURTHER REFERENCE.
IMPORTANT: This appliance is not
suitable for use by persons (including
children) with reduced physical,
sensory and mental capacities or with
lack of experience or knowledge unless
supervised by a person responsible
for their safety. Children must be
supervised to make sure they do not
play with the appliance.
►1.1. Fill the appliance tank only with
clean water.
►1.2. Switch off and disconnect the
appliance from the mains before lling
it.
►1.3. Do not move the appliance, once
the tank has been lled.
►1.4. When using the appliance, comply
with all local regulations and Standard
in force.
►1.5. Keep the appliance dry, in order
to avoid electric shocks. Hands must
always be dry.
►1.6. Use only in ventilated and dry
areas.
►1.7. For indoor use only.
►1.8. Power the appliance only with
voltage and frequency as specied on
the data plate.
►1.9. Only use extensions with three
wires appropriately connected to earth.
►1.10. Do not cover the appliance with
paper, cardboard, plastic, metal sheets
or any other inammable material
during use, in order to prevent any risk.
►1.11. The appliance must be used on a
stable and levelled surface, in order to
prevent any risk.
►1.12. When it is not used, disconnect
the appliance from the power plug.
►1.13. Do not block the air vent (rear
side) or the air outlet (front side) of the
appliance.
►1.14. The minimum safety distance
recommended between the appliance
and walls or other items is 0,5 m.
►1.15. When the appliance is connected
to the mains or running, it must never
be moved, handled, topped-up or
subject to any maintenance operation.
►1.16. The appliance (power cable
included) must be kept at a suitable
safety distance from heat sources.
►1.17. In any case, the appliance must be
opened and/or repaired by authorised
after-sales centre.
►1.18. If the power cable is damaged,
it must be replaced by the technical
after-sales centre, in order to prevent
any risk.
►1.19. Rinse the case with clean water
and clean it before using, after the
period during which the bio cooler was
not in use.
►1.20. The ashing of the red diode on
the control panel means that the water
level in the vessel is low.
►1.21. In the case of improper operation
of the product at the start, disconnect
itfrom the power supply immediately
and contact service point.
►1.22. Protect the power supply cord
from damage as a result of movement
of the vehicles or pedestrians. The
connection of improper electrical
voltage or improper installation, will
cause the electrical shock hazard.
►1.23. Conditions of use:
A) Air temperature: 18°C to 45°C; Water
temperature: <45°C.
B) Voltage in the power supply source
may not exceed the required voltage
by (+/-) 5%.
C) The air supply must be free of dust,
pollutants, or additional cleaning
should be used.
Figures and texts of this book are protected by COPYRIGHT.
