HSM Shredstar X15 Bedienungsanleitung

01/2013 shredstar X15_X18 7

english

The shredder is designed exclusively for de-

stroying paper. Depending on the cutting type, it

can also handle small quantities of CDs,

credit

and charge cards.

Its sturdy drive mechanism is not damaged by

paper clips and staples.

The warranty period for the document shredder

is 2 years. This warranty and guarantee exclude

wear and damage caused by improper handling

or actions taken by third parties.

1 Proper use, warranty

Before using the machine for the ﬁrst

time, read the operating manual, and

keep it for later use and to pass on to

any subsequent users. Observe all safety in-

structions on to the machine.

WARNING

Dangerous for children and others!

The machine may not be used by

persons (including children under

14 years of age) with limited physi-

cal, sensory or mental capabilities or

with a lack of experience and knowl-

edge, unless they are supervised by

a responsible person or are instructed by them

on the use of the machine. Children must be

supervised to ensure they do not play with the

machine. Do not leave the document shredder

switched on when it is unattended.

2 Safety instructions

Classiﬁcation

Safety notice Explanation

WARNING Failure to observe this

warning can lead to

serious or fatal injury.

Notice Failure to observe this

instruction can cause

damage.

WARNING

Risk of injury!

Do not reach into the paper feed slot.

Risk of injury from being pulled in!

Keep long hair, loose articles of cloth-

ing, ties, scarves, jewellery, etc. away

from feed opening. Material with the

tendency to form loops, e.g. tapes,

strapping material, etc. must not be

shredded.

Risk of combustion!

Do not use cleaning agents or pres-

surized air sprays which contain

inﬂammable substances, as they

could ignite.

WARNING

Dangerous mains voltage!

Improper handling of the machine can

lead to an electric shock.

– Before you insert the power plug, make sure

that the voltage and frequency of your power

supply comply with the information on the

name plate.

– Make sure that the power plug is easily ac-

cessible.

– Make sure that no water gets into the shred-

der. Do not immerse the power cable or the

power plug in water.

– Never touch the power plug with wet hands.

– Never pull the plug out of the socket using

the power cable. Always pull out the plug

directly.

– Only use the machine in a dry room indoors.

Never operate the machine in damp rooms

or in the rain.

8 shredstar X15_X18 01/2013

english

1 Shredded paper container

2 Cutting head

3 Feed opening for CDs

4 Feed opening for paper and cards

5 Safety notice

6 Container for shredded CD

7 LED indicator

8 Rocker switch

I: On

O: Off

R: Reverse

9 Base cabinet

10 Adapter (only required in Great Britain)

4 Machine components

1 2 3 4 5 6 7 8 9

3 Setting up

Take the shredded paper container and

cutting head out of the base cabinet.

• Carefully place the cutting head on the base

cabinet.

The lugs on the bottom of the cutting head

latch into the openings on the base cabinet.

• Push the shredded paper container into the

base cabinet until it latches in the housing.

• Plug in the mains plug. Push down the front of the container (1), push it

back (2) and lift the container out of the bracket

(3).

Note that the shredder can only be switched on

when the CD container is properly in place.

Instructions on removing the CD container

Check the machine and cable regu-

larly for damage. Switch the shred-

der off if it is damaged or not work-

ing correctly or before relocating or

cleaning it and disconnect it from

the mains.

– Keep the machine, the plug and cable away

from open ﬁre and hot surfaces. The ventila-

tion slots must not be blocked or covered

and there must be at least 2“ (5 cm) space

between the shredder and any wall or furni-

ture.

Service work may only be carried

out by HSM Customer Service or by

the service technicians of our con-

tractual partners.

See page 72 for our customer ser-

vice addresses.

Notice Danger from improper use

Only operate this machine in accordance with

the instructions outlined in “Proper use”.

01/2013 shredstar X15_X18 9

english

Switching the paper shredder on

• Press the rocker switch „I“.

The rocker switch locks in place.

The green LED lights up.

The paper shredder is ready for

operation (standby).

Shredding paper and credit cards

• Feed in only one credit card

or no more than 15 sheets of

paper.

The light barrier starts the

cutting unit automatically.

The material is pulled into the

cutting unit and shredded.

Three seconds after the

feed opening is clear again,

the shredder switches off

automatically and goes into

standby.

5 Operation

LED-indicator Cause Remedy

No LED lights up - Place the cutting head correctly on the base cabinet

and push the containers for shredded paper and CDs in

properly.

Press “I” on the switch.

Both LEDs light up The shredded

paper container

is full

Empty the container.

If you take the cutting head off the base cabinet, take

care not to damage the ﬂap on the bottom of the cutting

head.

The red LED ﬂashes Overheating The maximum uninterrupted operating time is ﬁve

minutes. Let the machine cool down for around

20 minutes.

Only the red LED

lights up

Paper cutting

unit overloaded

Press “R” on the switch.

Note: The cutting unit starts up with a delay of two

seconds.

Remove the paper.

Do not feed in more than 15 sheets of paper at a time.

For any other malfunctions, switch off the machine and get in touch with our customer service.

6 Troubleshooting

Shredding CDs

The machine is equipped

with a separate CD

cutting unit. Push the CD

into the feed opening

until the cutting unit

catches it.

The CD is cut into ﬁve strips.

The shredder switches off.

Switching the paper shredder off

• Press the rocker switch “R”.

The rocker switch locks in place.

10 shredstar X15_X18 01/2013

english

EC Declaration of Conformity

HSM GmbH + Co. KG, Austraße 1-9, 88699 Frickingen / Germany hereby declares that the machine, referred to here

document shredder HSM shredstar X15 / X18

corresponds to the health and safety requirements of the following EC directives listed below due to its conception and

design of the version in which it was put into circulation by us:

Low voltage directive 2006 / 95 / EEC

EMC directive 2004 / 108 / EC

Applied standards and technical speciﬁcations:

• EN 13857:2008 • EN 55014-1:2006 + A1:2009

• EN 55014-2:1997 + A1:2001 + A2:2008 • EN 61000-3-2:2006 + A1:2009 + A2:2009

• EN 61000-3-3:2008

Frickingen, 10.01.2013

i.V. Hubert Kötzinger - Head of Environmental Engineering Product Development

9 Technical data

*: only applies to the paper/card cutting unit

Cutting type * Cross cut

Shred size * 1/8“ x 1 1/16“ (4 x 27 mm)

Cutting capacity per cycle 1 CD (max. 1.2 mm thick)

or 1 credit card / store card

or 15 sheets of paper (80 g/m²)

17-18 sheets of paper (70 g/m²)

Cutting speed * 7.9 ft/min (40 mm/s)

Shredded material container volume * 6.6 gal (25 l)

Voltage 120 V / 60 Hz

220 - 240 V, 50 - 60 Hz

Dimensions B x T x H 15.6“ x 10.6“ x 22.5“

(395 x 270 x 580 mm)

Weight 35.3 lbs. (16 kg)

8 Disposal / Recycling

Electrical and electronic old devices

contain a variety of valuable materi-

als, but also hazardous substances

which were required for function and

safety. Incorrect disposal or handling

can be dangerous to your health and

the environment. Never dispose of old devices

in the household waste. Observe the current

applicable regulations and use the collection

points for returning and recycling electric and

electronic devices. Dispose of all the packaging

materials also in an environmentally-responsi-

ble way.

Switch off the shredder and pull out the mains

plug. When cleaning only use a soft cloth and

a mild soap-water solution. However, no water

may enter the equipment.

Oil the cutting unit when

cutting performance deterio-

rates or the device becomes

noisy, or every time you

empty the waste container.

• Squirt special cutting unit oil through the

paper feed across the entire width of the

cutting shafts.

• Without feeding in paper, run the cutting unit

in reverse (R).

This loosens paper dust and particles.

7 Cleaning and maintenance

Andere Handbücher für shredstar X15

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere HSM Aktenvernichter Handbücher

HSM

HSM Securio B32s Bedienungsanleitung

HSM

HSM Pure 630c Bedienungsanleitung

HSM

HSM Shred Star X8pro Bedienungsanleitung

HSM

HSM Powerline FA 400.2 Bedienungsanleitung

HSM

HSM securio C16 Bedienungsanleitung

HSM

HSM securio c 14 Bedienungsanleitung

HSM

HSM shredstar S10 Bedienungsanleitung

HSM

HSM Securio P40 Bedienungsanleitung

HSM

HSM 104.3 Bedienungsanleitung

HSM

HSM Securio B34c Bedienungsanleitung

HSM

HSM HSM1912 Bedienungsanleitung

HSM

HSM Securio B24 Bedienungsanleitung

HSM

HSM SECURIO B24s Bedienungsanleitung

HSM

HSM Securio B34 Bedienungsanleitung

HSM

HSM SECURIO B26c Bedienungsanleitung

HSM

HSM Securo AF 300 Bedienungsanleitung

HSM

HSM Classic 225.2 Bedienungsanleitung

HSM

HSM Powerline 450.2 Bedienungsanleitung

HSM

HSM Securio B22 Bedienungsanleitung

HSM

HSM shredstar X15 Bedienungsanleitung

HSM

HSM shredstar S10 Bedienungsanleitung

HSM

HSM Primo 1401 Bedienungsanleitung

HSM

HSM Securio B34c Bedienungsanleitung

HSM

HSM securio C18 Bedienungsanleitung

Beliebte Aktenvernichter Handbücher anderer Marken

Swingline

Swingline STACK-AND-SHRED200X&200XL 60X Bedienungsanleitung

GBC

GBC ShredMaster CC055 Bedienungsanleitung

UNITED OFFICE

UNITED OFFICE UAV 190 A1 Bedienungsanleitung

Rexel

Rexel Optimum AutoFeed+ 45X Bedienungsanleitung

Martin Yale

Martin Yale 227284S1 Bedienungsanleitung

Bonsaii

Bonsaii DocShred C223-A Bedienungsanleitung

TRU RED

TRU RED TR-BMC20A Bedienungsanleitung

Fellowes

Fellowes 50S Bedienungsanleitung

GBC

GBC SHREDMASTER 1236SE Bedienungsanleitung

Gude

Gude GH 2600 P Bedienungsanleitung

Ativa

Ativa DQ80M Bedienungsanleitung

Q-Connect

Q-Connect Q8CC Bedienungsanleitung

Fellowes

Fellowes POWERSHRED C-325CI Bedienungsanleitung

Olivetti

Olivetti Privacy 5000C Kurzanleitung

Dahle

Dahle paperSAFE 22022 Bedienungsanleitung

Formax

Formax OnSite FD 87 Bedienungsanleitung

GEHA

GEHA Home & Office S7 CD Bedienungsanleitung

Fellowes

Fellowes Powershred M-3C Bedienungsanleitung