Huawei EC168 Bedienungsanleitung
Copyright © 2008 Huawei Technologies Co., Ltd.
All Rights Reserved
No part of this document may be reproduced or transmitted in any form or by any
means without prior written consent of Huawei Technologies Co., Ltd.
Trademarks and Permissions
and other Huawei trademarks are trademarks of Huawei Technologies Co.,
Ltd.
All other trademarks and trade names mentioned in this document are the
property of their respective holders.
Notice
The information in this document is subject to change without notice. Every effort
has been made in the preparation of this document to ensure accuracy of the
contents, but all statements, information, and recommendations in this document
do not constitute the warranty of any kind, express or implied.
i
Table of Contents
Getting to Know Your EC168.................................................................... 1
Requirements for the Computer ............................................................... 3
Installation/Removal Guide...................................................................... 3
Safety Information................................................................................. 6
1
Thank you for choosing Huawei EC168 EV-DO
Rev.A Rotatable USB Stick (hereinafter referred to
as the EC168). With the EC168 Rotate USB Stick,
you can access the Internet through wireless
network at a high speed.
Note:
This manual describes the appearance, installation and removal of the EC168. For
the operation of the management program, refer to the User Manual.
Getting to Know Your EC168
The following figure shows the appearance of the EC168. It is only for your
reference. The actual product may differ.
2
Micro SD card slot
Holds the Micro SD card.
Rotatable USB connector
Connects to the USB interface of the PC.
External Antenna Slot
Holds the external antenna.
Indicator
It indicates the status of the EC168.
3
On, The EC168 is powered on.
Blinking once every 2s: The EC168 is searching the network or the network is
not found.
Blinking twice every 2s: The network is found.
Blinking once every 0.2s: The EC168 is engaged in a call or a data service.
Requirements for the Computer
To use the EC168, the computer must meet the following requirements:
Standard USB interface.
Windows 2000 SP4, Windows XP SP2, Windows Vista.
Your computer’s hardware system should meet or exceed the recommended
system requirements for the installed version of OS.
Resolution for the display: 800 × 600 or above.
Installation/Removal Guide
On different operating systems (OSs), the installation and removal procedures
may differ. Follow the system prompts during operation.
Connecting the EC168 with a Computer
Plug the EC168 into the USB interface of the PC.
4
Installing the EC168 Management Program
1. Connect the EC168 with the PC.
2. The OS automatically detects and recognizes new hardware and starts the
installation wizard.
3. Follow the prompts of the installation wizard.
4. After the program is installed, a shortcut icon for the EC168 management
program is displayed on the desktop.
Note:
If the auto-run program does not respond, find the AutoRun.exe file in the driver
path. Then double-click AutoRun.exe to run the program.
5
Starting the Management Program
After the EC168 is installed, the management program is launched automatically.
You can also double-click the shortcut icon on the desktop to launch the
management program.
Removing the Management Program
1. Choose Start > Control Panel.
2. Find the management program, and click Add/Remove Program to uninstall
the management program.
Note:
Before removing the management program, exit the management program.
Removing the EC168
1. Double-click in the system tray. The Unplug or Eject Hardware
interface is displayed.
2. Select the hardware related to the EC168 and click Stop.
3. When the prompt "It is safe to remove the device" is displayed, remove the
EC168.
6
Safety Information
Read the safety information carefully to ensure the correct and safe use of your
wireless device.
Interference
Do not use your wireless device if using the device is prohibited or when it cause
danger or interference with electric devices.
Medical Device
Do not use your wireless device and follow the rules and regulations set forth
by the hospitals and health care facilities.
Some wireless devices may affect the performance of the hearing aids. For
any such problems, consult your service provider.
If you are using an electronic medical device, consult the doctor or device
manufacturer to confirm whether the radio wave affects the operation of this
device.
Area with Inflammables and Explosives
To prevent explosions and fires in areas that are stored with inflammable and
explosive devices, do not use your wireless device and observe the rules. Areas
stored with inflammables and explosives include but are not limited to the
following:
Gas station
Fuel depot (such as the bunk below the deck of a ship)
Container/Vehicle for storing or transporting fuels or chemical products
7
Area where the air contains chemical substances and particles (such as
granule, dust, or metal powder)
Area indicated with the "Explosives" sign
Area indicated with the "Power off bi-direction wireless equipment" sign
Area where you are generally suggested to stop the engine of a vehicle
Traffic Security
Observe local laws and regulations while using the wireless device. To prevent
accidents, do not use your wireless device while driving.
RF signals may affect electronic systems of motor vehicles. For more
information, consult the vehicle manufacturer.
In a motor vehicle, do not place the wireless device over the air bag or in the
air bag deployment area. Otherwise, the wireless device may hurt you owing
to the strong force when the air bag inflates.
Observe the rules and regulations of airline companies. When boarding,
switch off your wireless device. Otherwise, the radio signal of the wireless
device may interfere with the plane control signals.
Safety of Children
Do not allow children to use the wireless device without guidance. Small and
sharp components of the wireless device may cause danger to children or cause
suffocation if children swallow the components.
Environment Protection
Observe the local regulations regarding the disposal of your packaging materials,
used wireless device and accessories, and promote their recycling.
8
WEEE Approval
The wireless device is in compliance with the essential requirements and other
relevant provisions of the Waste Electrical and Electronic Equipment Directive
2002/96/EC (WEEE Directive).
RoHS Approval
The wireless device is in compliance with the restriction of the use of certain
hazardous substances in electrical and electronic equipment Directive
2002/95/EC (RoHS Directive).
Laws and Regulations Observance
Observe laws and regulations when using your wireless device. Respect the
privacy and legal rights of the others.
Care and Maintenance
It is normal that your wireless device gets hot when you use or charge it. Before
you clean or maintain the wireless device, stop all applications and disconnect the
wireless device from your PC.
Use your wireless device and accessories with care and in clean environment.
Keep the wireless device from a fire or a lit cigarette.
Protect your wireless device and accessories from water and vapor and keep
them dry.
Do not drop, throw or bend your wireless device.
Clean your wireless device with a piece of damp and soft antistatic cloth. Do
not use any chemical agents (such as alcohol and benzene), chemical
detergent, or powder to clean it.
Do not leave your wireless device and accessories in a place with a
Andere Handbücher für EC168
1
Inhaltsverzeichnis
Andere Huawei USB-Modem Handbücher
