7
4. Assembly Instructions
WARNING: The Tx 150 is designed to be easily assembled,
but before doing so please check that it complies with your
local Moving and Handling guidelines
Assembly instructions
1. Place the base on the floor and apply the brakes on the rear castors.
2. Fit the mast over the spigot in the centre of the base. Make sure the
mast is fully engaged with the spigot by checking the engagement
label on the face of the mast. Fully tighten the mast retaining knob.
WARNING: Avoid trapped fingers – Keep fingers away from
the end of the mast when fitting to the spigot.
3. Fit the electric actuator to the mast. The lower mounting point on the
actuator is slotted. Align the actuator slot with the pivot pin on the
mast (see illustration page 6) and fully engage. The actuator can now
be swung into the upright position and leant against the mast.
WARNING: Avoid trapped fingers – Keep fingers away from
the open end of the actuator pivot when fitting to the mast
pivot.
4. Fit the jib to the mast. One end of the jib is slotted and this engages
with the pivot pin at the top of the mast. Align the slot in the jib with
the flat parts of the pivot pin (see illustration page 6) and fully engage.
The jib can now be rotated into the normal working position. Snap jib
cover moulding into place.
WARNING: Avoid trapped fingers – Keep fingers away from
the end of the jib when fitting to the pivot pin.
5Fit the actuator top mounting to the jib. Remove one keyring from the
pin in the actuator mounting plate on the jib. Remove the pin. The
actuator mounting plate on the jib now fits into the slotted end of the
actuator. Align the pin holes. Re-fit the pin and replace the keyring.
6Attach spreader bar to jib. Push down the safety latch on the spreader
bar mounting point and slide the slotted sides over the mounting pin at
the end of the jib (see illustration page 6). Release the safety latch and
check the spreader bar is fully engaged with the jib pin and free to
swing and rotate.
7Electrical connections.
Leg actuator lead (Black) from crossmember cover – plug into socket
2 on the underside of the control box.
