HYOSUNG GV125S Bedienungsanleitung

—1 —

This manual should be considered a permanent

part of the motorcycle and should remain with the

motorcycle when resold or otherwise transferred to

a new owner or operator. The manual contains

important safety information and instructions which

should be read carefully before operating the

motorcycle.

—2 —

BATTERY INITIALCHARGING

Initial charging of the battery is required after filling electrolyte to

improve the battery durability.

BATTERYINSTALLATION

①Fill the electrolyte to the battery.

②Leave the battery for 30 minutes.

③Charge the batterybystandard charging. This is necessaryfor

reliability of the battery.

④Install the battery to the motorcycle.

※STANDARD CHARGING TIME : 1.0 A for 10 hours

Do not use the battery without the battery initial charging.

Otherwisethebatteryservicelifemaybeshortened.

The motorcycle use a battery ignition system.

Do not permit to start or operate the motorcycle without the

battery otherwise the electrical system will be damage.

Always start or ride the motorcycle with the correct battery

installed and connected.

BATTERY INITIAL CHARGING

—3 —

FOREWORD

Thank you for choosing a Hyosung motorcycle. We at

Hyosung have designed, tested and produced this

motorcycle using the most modern technology avail- able to

provide you with much happy, enjoyable, safe riding.

Motorcycling is one of the most exhilarating sports and to

ensure your riding enjoyment, you should become thoroughly

familiar with the information presented in this Owner's

Manual before riding the motorcycle.

The proper care and maintenance that your motorcycle

requires is out- lined in this manual.

By following these instructions explicitly you will ensure a

long trouble-free operating life for your motorcycle. Your

dealer has experienced technicians that are trained to

provide your machine with the best possible service with the

right tools and equipment.

Operative norm:

Q/370100JQH002—2018

—4 —

All information, illustrations photographs and specifications

contained in this manual are based on the latest product

information available at the time of publication. Due to

improvements or other changes, there may be some

discrepancies between information in this manual and your

motorcycle.

Hyosung reserves the right to make changes at any time,

without notice and without incurring any obligation to make

the same or similar changes to motorcycles previously built

or sold.

Please note that this manual applies to all specifications for

all respective destinations and explains all equipments.

Therefore, your model may have different standard features

than shown in this manual.

ⒸCOPYRIGHT KR Motors Co., Ltd.

—4 —

IMPORTANT

BREAK-IN INFORMATION

FOR YOURMOTORCYCLE

The first 1,600 km (1,000 miles)

are the most important in the life

of your motorcycle.

Proper break-in operation

during this time will help ensure

maximum life and performance

fromyournew motorcycle.

Hyosung

parts are

manufactured of high quality

materials, and manu

factured

parts are finished to close

tolerances. Proper break-in

opera

tion allows the machined

surfacesto polish each other and

matesmooth

ly.

Motorcycle reliability and

performance dependonspecial

care and restraint exercise

duringthebreak- in period. It is

especially important that you

avoid operating the engine in a

manner which could expose the

enginepartstoexcessiveheat.

Please refer to the BREAK-IN

section for specific break-in

recommen

dations.

WARNING / CAUTION

NOTE

Please read this manual and

follow its instructions carefully.

To emphasize special

information t he words

『

W A

RNI NG

』

『

CAUTION

』

and

『

NOTE

』

have special

meanings.

Information following these

signal words should be carefully

reviewed.

The personal safety of the

rider may be involved.

Disregarding this information

could result in injury to the

rider.

These instructions point out

special service procedures or

precautions that must be

followed to avoid damaging

the machine.

N O T E

This provides special

information to make

maintenance easier or

important instructions clearer.

—5 —

Noise Control System (muffler assembly)

TAMPERING WITH NOISE CONTROL SYSTEM PROHIBITED

Owners are warned that the law may prohibit :

(a)

The removal or rendering inoperative by any person

otherthan for the purpose of maintenance, repair or

replacement, of any device or element of design

incorporated into any new vehicle for the purpose of

noise control prior to its any sale or delivery to the

ultimate purchaser or while it is in use.

(b)

Theuseofthevehicleaftersuchdeviceorelementof

design has been removed or rendered inoperative

byanyperson.

MAINTENANCE :

The exhaust system of this motorcycle requires no periodic

maintenance.

The engine should be adjusted to the manufacture’s

specifications and the spark plug should be kept in good

condition. Running the engine with incorrectly operating spark

plug or misadjusted fuel injection systemmaycausepermanent

damagetothecatalystand to the noise controlsystem.

—6 —

CONSUMER

INFORMATION

SAFE RIDING

RECOMMENDATION

FOR MOTORCYCLE

RIDERS

Motorcycleriding is great fun

and anexcitingsport.Motorcycle

riding also requires he/she to

takesome extra precautions to

ensurethe safetyoftheriderand

passenger.

These precautions are :

●

Before first use of the

motorcycle read this owner’s

manual carefully to become

familiar with the motorcycle

features, and safety and

maintenance requirements.

Review all instructions,

requirements and warnings.

●

Before the rider’s first use of

the motorcycle, make sure

that he / she is familiar with

thelocation and operation of

all controls, and has been

instructed in the proper

operationof themotor- cycle.

●

For first use of the

motorcycle, find a level, open

area for the rider to use to

become familiar with the

operation of controls and the

operating and handling

characteristics of the

motorcycle.

—7 —

●

Before each use, perform

daily inspections with the

rider.

●

Specific items to check are

listed in the INSPECTION

BEFORE RIDING section on

page 58 of this owner’s

manual.

●

Make sure the rider wears a

helmet, eye protection, and

protective clothing (gloves,

leather or heavy cloth pants,

long sleeved shirt or jacket,

boots).

●

Permit use only by two

per-sons.

●

This motorcycle is designed

for use only by one rider and

one passenger.

●

Do not permit anyone to

operate the motorcycle

under the influence of

alcohol or otherdrugs. It may

cause damage to the

motorcycle and alter

handling characteristics.

●

Observe periodic

maintenance requirements.

Your authorized dealer is

trained and equipped to

perform this ser- vice.

●

Drain gasoline from the fuel

tank prior to transporting the

motorcycle.

●

Caution the rider and

others near the motorcycle

not to get close to or touch

any moving parts or any

heated areas such as the

engine and exhaust sys- tem.

Do not make any modifications

to the motorcycle

Modifications may make

the motorcycle unsafe or

illegal in your state.

The motorcycle is equipped

with the side stand ignition

interlock sys- tem.

If the transmission is in

neutral or the side stand up,

you can only start the engine

by squeezing the clutch lever.

This side stand ignition

interlock system prevents the

motorcycle from being started

with side stand down.

Make sure that the side stand

ignition interlock system is

working properly before riding.

—8 —

The position lamp, meter

lamp, tail lamp and license

plate lamp on this

motorcycle always comes

on when the ignition switch

is turned to the “”

position.

The head lamp is always lit

when starting the engine.

●

Donotruntheengine

indoors or where there is

little or no ventilation.

Exhaust gases contain

carbon monoxide, a

potentially lethal gas that

is colorless and odorless.

●

Never leave the

motorcycle running while

unattended, even for a

short time.

Always open the throttle

gradually to prevent front

wheel lifting. Failure to

observe this precaution may

result in loss of control and an

accident.

Keep both hands on the

hand- grips at all times when

riding. Removing your hands

from the handgrips reduces

your ability to control the

motorcycle and could result in

anaccident.

While operating the

motorcycle, the rider should

keep both feet on thefootrests

at all times to avoid injuries

resulting from accidents.

Moving the rider’s feet from

the footrests reduces the

rider’s ability to control the

motorcycleandcouldleadtoan

accident.

When storing for long period :

Supplyenoughthefuelin

the fuel tank.

Remove the battery from

the motorcycle.

Do not turn the ignition switch

to its “ ” position or the

steering lock to “ ” position

or the engine stop switch to

its “ ” position while riding

themotorcycle.

—9 —

⊙WEAR A HELMET

Motorcycle safety

equipment starts with a

quality safety helmet. One

of the most serious

injuries that can happen is

a head injury. ALWAYS

wear a properly approved

helmet. You should also

wear a suitable eye

protection.

⊙RIDING APPAREL

Loose clothing can be

uncomfortable and unsafe

when riding a motorcycle.

Use good quality

motorcycle riding apparel

when riding your

motorcycle.

⊙INSPECTION BEFORE

RIDING

Review thoroughly the

instruct ions in the

“INSPECTION BEFORE

RIDING” section of this

manual.

Do not forget to perform an

entire safety inspection to

ensure the safety of the rider

and its passenger.

⊙FAMILIARIZE YOURSELF

WITH THE MOTORCYCLE

Your riding skill and

mechanical knowledge from

the foundation for safe riding

practices.

We suggest that you

practice riding your

motorcycle in a non-traffic

situation until you are

thoroughly familiar with your

machine and its controls.

Remember practice makes

perfect.

Inhaltsverzeichnis

Andere HYOSUNG Motorrad Handbücher

HYOSUNG

HYOSUNG GV250 AQUILA - Bedienungsanleitung

HYOSUNG

HYOSUNG Comet 650 Bedienungsanleitung

HYOSUNG

HYOSUNG GT 650 EFI Bedienungsanleitung

HYOSUNG

HYOSUNG Aquila GV 650 Bedienungsanleitung

HYOSUNG

HYOSUNG GT650SR - PARTS CATALOGUE Bedienungsanleitung

HYOSUNG

HYOSUNG XRX125sm Bedienungsanleitung

HYOSUNG

HYOSUNG AQUILA GV125 EURO3 - CATALOGUE Bedienungsanleitung

HYOSUNG

HYOSUNG RX 125 - Bedienungsanleitung

HYOSUNG

HYOSUNG Comet650 Bedienungsanleitung

HYOSUNG

HYOSUNG COMET 250/R FI Bedienungsanleitung

HYOSUNG

HYOSUNG RT125D - PARTS CATALOGUE Bedienungsanleitung

HYOSUNG

HYOSUNG COMET GTR125 - CATALOGUE Bedienungsanleitung

HYOSUNG

HYOSUNG GT650 - PARTS CATALOGUE Bedienungsanleitung

HYOSUNG

HYOSUNG GT 650 Bedienungsanleitung

HYOSUNG

HYOSUNG Aquila Bedienungsanleitung

HYOSUNG

HYOSUNG COMET 125 - SERVICE Bedienungsanleitung

HYOSUNG

HYOSUNG Karion Bedienungsanleitung

HYOSUNG

HYOSUNG GV125 - CATALOGUE Bedienungsanleitung

HYOSUNG

HYOSUNG 2010 ST7 Bedienungsanleitung

HYOSUNG

HYOSUNG Prima Bedienungsanleitung

HYOSUNG

HYOSUNG GT 125R Bedienungsanleitung

HYOSUNG

HYOSUNG Aquila GT250 Ej Bedienungsanleitung

HYOSUNG

HYOSUNG GT250 Bedienungsanleitung

HYOSUNG

HYOSUNG GF125 Bedienungsanleitung

Beliebte Motorrad Handbücher anderer Marken

OHVALE

OHVALE GP-0 Stücklistenhandbuch

Yamaha

Yamaha Star XV19CTSZ 2009 Bedienungsanleitung

KTM

KTM 350 XCF-W USA Bedienungsanleitung

Husqvarna

Husqvarna FC 250 2016 Bedienungsanleitung

Ducati

Ducati SCRAMBLER 800 Gebrauchsanweisung

APRILIA

APRILIA ETV MILLE CAPONORD - PART1 02-2001 Bedienungsanleitung

Yamaha

Yamaha 2006 YZF-R1V Bedienungsanleitung

KTM

KTM Freeride E-XC 2021 Bedienungsanleitung

Fantic

Fantic Enduro 125 Bedienungsanleitung

Ducati

Ducati Supersport 750 desmodue Bedienungsanleitung

MV Agusta

MV Agusta 2008 F4 312RR 1078 Gebrauchsanweisung

Yamaha

Yamaha XVS650A Bedienungsanleitung

Yamaha

Yamaha YZF-R6T(C) Handbuch

Ducati

Ducati 748 monoposto strada Bedienungsanleitung

ATK

ATK 1988 250 Bedienungsanleitung

Excelsior-HENDERSON

Excelsior-HENDERSON 1999 HCX Bedienungsanleitung

Triumph

Triumph Thunderbird Bedienungsanleitung

Yamaha

Yamaha 2006 FJR1300A Bedienungsanleitung