1. Press button 2 times.
2. Press button 2 more times.
Transmitter Fob UNLOCK icon will flash, vehicle signal lights will flash, and
Driver's door will UNLOCK.
Transmitter Fob UNLOCK icon will flash, vehicle signal lights will flash, and all
doors will UNLOCK.
While the vehicle is running via remote start,
1. Press button one (1) time.
Transmitter Fob LOCK icon will flash, vehicle signal lights will flash, and all
doors will lock.
1. Press button one time.
(All doors, hood & trunk are closed).
Transmitter Fob LOCK icon will flash, vehicle signal lights will flash, and all
doors will LOCK.
1. Press button one time.
2. Within 3 seconds, press and hold button for 2 seconds.
Transmitter Fob LOCK icon will flash, vehicle signal lights will flash, and all
doors will LOCK.
Transmitter Fob KEY icon will flash, the engine will crank and start, the
vehicle signal lights will flash.
The hazard lights will flash while the engine is started remotely.
While the vehicle is running via remote start,
1. Press button two (2) times.
2. Press button two (2) additional times.
Transmitter Fob UNLOCK icon flash, vehicle signal light flashes twice
and Driver's door will unlock.
Transmitter Fob UNLOCK icon flash, vehicle signal light flashes twice
and All doors will unlock.
On the vehicle SMART KEY
1. Press button, one (1) time.
2. Within three (3) seconds, press or , one (1) time.
Vehicle signal lights will flash, and all doors will LOCK.
Engine will crank and start (there may be a short delay), the vehicle signal
lights will flash.
While the vehicle is running via remote start with the SMART KEY,
1. Press button one (1) time.
2. Press button one (1) additional time.
3. Press or button one (1) time.
Vehicle signal lights will flash, and Driver's door will UNLOCK.
Vehicle signal lights will flash, and all doors will UNLOCK.
The engine will stop.
While the vehicle is running via remote start,
1. Open the hood.
While the vehicle is running via remote start,
1. Open driver's door and enter into vehicle with OE Smart KEY, close
the driver's door within 30sec.
The engine will continue running for drive off automatically.
(Hazard lights will stop flashing after drive off).
While the vehicle is running via remote start,
1. Open driver's door and press brake pedal with OE Smart KEY
within 30 sec.
The engine will continue running for drive off automatically.
(Hazard lights will stop flashing after drive off).
While the vehicle is running via remote start,
1. Open any door.
The engine will stop after approximately thirty (30) seconds.
While the vehicle is running via remote start,
1. Open trunk.
The vehicle LOCKS, UNLOCKS, but does not START.
Ensure the Valet Mode is OFF.
(Refer to Owner's Guide for details.)
Ensure that the buttons are properly activated.
Buttons may not recognize a command if the LED icon light is
still flashing.
The engine will stop after approximately fifty (50) seconds.
While the vehicle is running via remote start,
1. Press and hold button for two (2) seconds.
Transmitter Fob KEY icon will flash, and the engine will stop.
The vehicle does not LOCK by using the Remote Start Key Fob.
Check the vehicle status
1. Engine is OFF.
2. Accessory function is OFF.
3. All doors are closed.
4. Hood and Tailgate are closed.
Engine turns off immediately when the brake pedal is pressed
after starting engine with remote.
Ensure Smart KEY FOB is inside the vehicle.
The remote does NOT LOCK / UNLOCK.
and does not START the vehicle. The Remote LED lights flash when buttons
are pressed.
The Transmitter Fob is not paired to the Control Module.
Follow the Remote Start Fob Pairing Procedure in the
Installation Instructions.
The LED icon lights on the Transmitter Fob does not light up.
The Transmitter Fob batteries are dead.
Refer to the Owner's Manual for instructions to change the batteries.
The hazard lights will flash while the engine is started remotely.
This is normal and cannot be changed.
