QUICK-START GUIDE BATTERY INSTALLATION
ONCE BATTERIES HAVE BEEN INSTALLED
1. Locate Blazor’s power switch, and turn it from “TRY ME” to “OFF”
2. Using a Phillips head screwdriver ( ), remove Blazor’s battery
cover.
3. If installing batteries for the first time, remove the two AA LR6
“TRY ME” batteries and discard them.
4. Place 4 AA LR6 batteries in Blazor and replace the cover.
5. Remove the controller battery cover.
6. Insert 3 AAA LR3 batteries, and replace the cover.
1. Locate Blazor’s power switch between his legs. Turn it from
“OFF” to “ON”.
• You will hear a growl indicating that Blazor is on.
• NOTE: When the power switch is set to “TRY ME”, Blazor will
make sounds when his jaw is closed but will not move.
2. Blazor is ready to play!
Getting started
Carefully remove Blazor from his packaging. Be sure to properly
remove all twist ties, tape, and packing materials from the robot’s
body before playing with him.
Package contents
1 Blazor robot
1 Remote controller
Battery Information
Blazor uses 4 AA LR6 batteries.
Remote Controller uses 3 AAA LR3 batteries.
We recommend using good quality alkaline batteries.
Important Battery Safety Information
3
Batteries should only be replaced
by adults.
Rechargeable batteries should only
be used and charged with adult
supervision.
Remove rechargeable batteries
from Blazor before charging.
DO NOT mix old and new batteries
or dierent types of batteries.
DO NOT short-circuit the supply
terminals.
Respect the correct polarity (+)
and (-) as indicated.
Replace all batteries of the same
type / brand at the same time.
Remove batteries if Blazor will not
be used for an extended period of
time.
DO NOT try to recharge
non-rechargeable batteries.
Use only fresh batteries of the
required size and recommended
type.
DO NOT dispose of batteries in fire.
Batteries may leak or explode.
Remove exhausted batteries from
Blazor and the remote controller.
