ITEC TWIN-BOX www.itec-audio.com 9
TWIN-BOX
16. Changing batteries of radio microphones
Attention: old batteries are hazardous waste; dispose of properly!
ITEC WM-716 - hand held microphone
(also WM 816 and WM 702)
Slide battery lid open, remove top battery and then pull the white plastic
strip to remove the other two batteries from the battery compartment.
Insert 3 new batteries!
Mind the poles (+ is at the bottom)!
Battery type: 3 pcs Mignon „AA“ 1.5 V
Batteries are okay: green LED is on
Batteries are low: red LED is on
ITEC WT-716 - button microphone
(also WT 816 and WT 702)
Open lid at the bottom of the casing and exchange all three batteries.
Mind the poles !
Battery type: 3 pcs Mignon „AA“ 1.5 V
Batteries are okay: red LED blinking
Batterie are low: red LED permanently on
ITEC WM-5100 - hand held microphone
Unscrew lid at the bottom end of the microphone and insert two new
batteries.
Mind the poles (+ is at the bottom)!
Battery type: 2 pcs Mignon „AA“ 1.5V
Batteries are okay: red LED blinking
Batterie are low: red LED permanently on
The status of the battery is also shown on the LCD-display.
ITEC WT-5100 - button microphone
Open lid at the bottom of the casing and exchange both batteries.
Mind the poles!
Battery type: 2 pcs Mignon „AA“ 1.5V
Batteries are okay: red LED blinking
Batterie are low: red LED permanently on
The status of the battery is also shown on the LCD-display.
ITEC WM-5300 Handheld Microphone
Unscrew cap on lower end of microphone and insert two new batteries.
Note the poles (- pole at spring contact, once at top, once at bottom)!
Battery type: 2 „AA“ 1.5V Mignon
When you switch on, red LED briefly illuminates.
Battery status on display.
ITEC WT-5300 Pocket Transmitter
Open pocket transmitter cover by pressing left and right snapper
simultaneously. Insert two new batteries.
Note the poles (- pole at spring contact, left)!
Battery type: 2 „AA“ 1.5V Mignon
Battery status on display.
