iBall Baton iB-LPDS81EL Bedienungsanleitung
1
User Guide
8-Port 10/100M PoE Switch + 1-Port
Uplink
Model No.: iB-LPDS81EL
Ver.: 1.0.0
2
FCC STATEMENT
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Consult the dealer or an experienced radio/ TV technician
for help.
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions:
3
1) This device may not cause harmful interference.
2) This device must accept any interference received, including
interference that may cause undesired operation.
Any changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority
to operate the equipment.
CE Mark Warning
This is a class A product. In a domestic environment, this
product may cause radio interference, in which case the user
may be required to take adequate measures.
4
Package contents
The following contents should be found in your box:
8-Port 10/100M PoE Switch + 1-Port Uplink
DC Power adapter
User Guide
Safety Notice (Cautions)
Do not use this product near water, for example, in a wet
basement or near a swimming pool. Avoid using this product
during an electrical storm. There may be a remote risk of electric
shock from lightning.
Note:
If any of the listed contents are damaged or missing, please
contact the dealer from whom you purchased the iBall Baton
8-Port 10/100M PoE Switch + 1-Port Uplink
5
Chapter 1 Overview of Product
iBall Baton 8-Port 10/100M PoE Switch + 1-Port Uplink
provides the seamless 10/100Mbps Auto-Negotiation RJ45
Fast Ethernet network connection.
PoE Switch is also a Power Sourcing Equipment (PSE*).
8-10/100Mbps (RJ45) Ethernet Ports (Port no. 1 to 8) of switch
support Power over Ethernet (PoE) function which can
automatically detect and supply power with IEEE 802.3af
complaint powered devices (PDs*).
1 x 10/100M RJ45 Uplink LAN Port.to connect existing network
PSE: A device (switch) that will provide power in a PoE setup.
PoE switch: Allows electrical power to transmit along with data,
over standard twisted-pair cable allowing you to expand your
network where there are no power lines or outlets.
PD is device powered by a PSE
Examples of PD devices are IP Phones, Wireless AP’s,
Network cameras, etc.
6
Chapter 2 Features & Specifications
Complies with IEEE802.3, IEEE802.3u, IEE802.3x,
IEEE802.3af standard
8-10/100Mbps Auto-Negotiation RJ45 ports supporting
Auto-MDI/MDIX
IEEE 802.3x flow control for Full Duplex mode and
backpressure for Half Duplex mode
8-PoE Port supports IEEE802.3af standards
Provides power and data transmission distance up to
100Mtrs. over Cat.5E UTP cable
1.8Gbps Backplane Capacity
VLAN button supported
Power Budget 65W
Store and Forward switching method
MAC address auto-learning and auto-aging
Metal case, desktop or wall-mounting design
External Power adapter
7
Chapter 3 Installation
1) Please inspect the Power Adapter carefully, and make sure
that it is properly connected to a power source.
2) Power on. It will be automatically initialized and the LED
indicators should respond as follows:
3.1 Rear Panel
The rear panel of the iB-LPDS81EL consists of 8- 10/100M PoE
ports & 1x 10/100Mbps Uplink Port.
8
3.2 Front Panel & LED indicators
Technical Specifications
Network
Standards
IEEE802.3, 802.3u, 802.3x, 802.3x, 802.3 af/at
Ports
8 - 10/100M RJ45 PoE Ports
1- 10/100M RJ45 Uplink Port
LED Indicators
Power, PoE Maximum power
Per port: Link, Activity, PoE error
Power
Solid
Power On
Off
Switch is Power Off / No power
PoE
Status
Solid
Port is connected to powered device with
proper power load
Off
Port is not connected or power is not
provided to powered device
Link/Act
Solid
RJ45 port is connected
Blinking
RJ45 port data is transmission
Off
RJ45 port is not connected or not properly connected
9
Cable Type
Wiring: Data & power provided over pairs 1/2and 3/6 or
4/5(+) and 7/8(-)
Cable: UTP cat.5 or higher
Processing types
Store-and-forward Half-duplex back pressure
IEEE802.3x full- duplex flow control
Backplane Bandwidth
1.8GBPS
Buffer memory
2.7Mb embedded memory per unit
MAC Address
4k
Network latency
Less than 20us for 64-byte frames in Store-and-
forward mode
Power Input
52V DC /1.25A
PoE power
15.4W /port (802.3af)
Power budget
65W
Dimension
95x70x26mm(L x W x H)
Environmental and Physical
Operating Temperature
0℃~45 ℃(32 ℉~104 ℉)
Storage Temperature
-40 ℃~70 ℃(-40 ℉~158 ℉)
Operating Humidity
10%~90% non-condensing
Storage Humidity
5%~90% non-condensing
10
COPYRIGHT & TRADEMARKS
Specifications are subject to change without notice. iBall Baton
is a registered trademark of Best IT World (India) Pvt. Ltd.
Other brands and product names are trademarks or registered
trademarks of their respective holders.
No part of the specifications may be reproduced in any form or
by any means or used to make any derivative such as
translation, transformation, or adaptation without permission
from Best IT World (India) Pvt. Ltd. All rights reserved.
Note: For any technical help on iBall Baton products please
contact support.baton@iball.co.in
www.iBall.co.in |www.iBallBaton.com
Inhaltsverzeichnis
Andere iBall Baton Schalten Handbücher
