ice.net D-50 Bedienungsanleitung
Usage recommendations
Do not operate the ice.net modem:
≫In areas where blasting is in progress
≫Where explosive atmospheres may be present
≫Near medical equipment
≫Near life support equipment, or any equipment that may be susceptible to any form of radio
interference. In such areas, the ice.net modem MUST BE POWERED OFF. The ice.net
modem can transmit signals that could interfere with this equipment.
Do not operate the ice.net modem in any aircraft, whether the aircraft is on the ground or in flight. In
aircraft, the ice.net modem MUST BE POWERED OFF. When operating, the ice.net modem can
transmit signals that could interfere with various onboard systems.
Note: Some airlines may permit the use of cellular phones while the aircraft is on the ground and the
door is open. The ice.net modem may be used at this time.
The driver or operator of any vehicle should not operate the ice.net modem while in control of a vehicle.
Doing so will detract from the driver or operator’s control and operation of that vehicle. In some states
and provinces, operating such communications devices while in control of a vehicle is an offence.
Besides this the following recommendations apply:
≫The ice.net modem generates radio frequency (RF) energy while in operation and If not
installed and used in accordance with the instructions, may cause interference to radio
communication.
≫Use an antenna approved by ice.net, otherwise it may cause damage to the modem and void
any warranty.
≫Use the modem in the manner you would use a notebook PC in general.
≫Position the antenna upright and avoid touching it during operation. Touching the antenna may
degrade the performance of the modem and may cause excessive power consumption.
≫Be cautious as the radio frequency (RF) energy may affect the electronic devices installed in a
car.
≫This equipment has been tested and found to comply with the limits pursuant to US FCC rule
Parts 22H/24E, these limits are designed to provide reasonable protection against interference
in an appropriate installation. However there is no guarantee that interference will not occur in
a particular installation.
≫Beware of environments where use of cell phones and wireless modems are prohibited.
≫Use of D-50 Modem while running a notebook PC with a battery may cause earlier exhaustion
of the battery than usual due to additional consumption of electric currents.
≫Call the service center designated by ice.net for after-sales service.
Nordisk Mobiltelefon accepts no responsibility for damages of any kind resulting from operating the
ice.net modem in contradiction to the usage recommendations stated above.
To install D-50 Modem application
The installation program starts automatically when D-50 modem is inserted into USB port.
D50 install program supports Windows 2000, Windows XP and Vista 32bit Vista 64bit.
Start the installation
Connect your D-50 modem to your USB port.
If the installation program does not start automatically, double click on the Setup.exe program in the
"CD Drive" in My Computer directory's "Portable Devices".
Install Shield Wizard... click 'next'
Choose the installation directory and click "Next" to continue.
Click "Next" to continue.
Click "Install" to continue.
D-50 Modem is configuring your new software installation.
Installation Complete. Click “Finish” and remove the installation CD.
When inserting the Modem
On Window 2000
You may run D-50 modem application when modem is connected to USB port and
device is detected.
On Window XP
In Windows XP or Vista you will see the “Find New Hardware” dialog box.
Step 1 - Data Modem @ CDMA Composite Device Install
Step 2 - Data Modem @ CDMA(6803) Install
Step 3 - Data Modem @ CDMA Diagnostic Serial Port(WDM)(6803) Install
Modem Driver Install Finish
Using the D-50 Modem Application Software
During this installation wizard a shortcut is placed on your desktop. Double click on the
icon in order to start the D-50 Modem Application software.
Main
Indicator state Icons
Icon Meaning Icon Meaning
Antenna Coverage Icon. 1xEV-DO Rev.A
available
Roaming Coverage Icon. 1xEV-DO available
Current High Data Rate mode
selected : Hybrid Mode (1xEV-
DO Preferred) DEFAULT. The
modem will automatically look
for the highest speed network
available in this mode.
Coverage Icon. CDMA 1x available
Current High Data Rate mode
selected: CDMA 1X only Mode Coverage Icon. IS95 available only
Current High Data Rate mode
selected: 1xEV-DO only Mode. 1X : Active 1X Data connection
DO : Active EVDO Data connection
Taskbar Icon
When the Application Software is running in the background, the Windows taskbar will show an icon
as above.
To maximize the ApplicationSoftware, click once on the icon.
Andere Handbücher für D-50
1
Inhaltsverzeichnis
Andere ice.net Modem Handbücher
Beliebte Modem Handbücher anderer Marken
Davicom
Davicom DM562AP Bedienungsanleitung
EpiValley
EpiValley TATA indicom SXC-1080 Bedienungsanleitung
Zte
Zte WiMAX Bedienungsanleitung
Intelimax
Intelimax MA-2060 Bedienungsanleitung
SMC Networks
SMC Networks D3CM1604V Gebrauchs- und Pflegehandbuch
Telstra
Telstra Wi-Fi 4G Advanced Pro X Bedienungsanleitung
US Robotics
US Robotics 3453C Bedienungsanleitung
MaxTech
MaxTech Plug & Play Internal Voice/FAX/Data/SVD... Bedienungsanleitung
Zte
Zte MF823 Bedienungsanleitung
Four-Faith
Four-Faith F1403 Bedienungsanleitung
Sierra Wireless
Sierra Wireless AIRLINK MP595W Bedienungsanleitung
Gemtek
Gemtek WiMAX WIXFBR-103 Bedienungsanleitung