ICP Electronics POS-566 Bedienungsanleitung

POS-566/566L Ver2.x

AMD-K6®-2/ K6®-III / Pentium® Processor

Multimedia POS Control Board V:a

edition on May.20,2000.

The information in this document is subject to change without prior notice in order

to improve reliability, design and function and does not represent a commitment on

the part of the manufacturer.

In no event will the manufacturer be liable for direct, indirect, special, incidental, or

consequential damages arising out of the use or inability to use the product or

documentation, even if advised of the possibility of such damages.

This document contains proprietary information protected by copyright. All rights

are reserved. No part of this manual may be reproduced by any mechanical,

electronic, or other means in any form without prior written permission of the

manufacturer.

Trademarks

POS-566/566L is a registered trademark of ICP Electronics Inc. IBM PC is a

registered trademark of International Business Machines Corporation. Intel is a

registered trademark of Intel Corporation. AMI is a registered trademark of

American Megatrends, Inc. Other product names mentioned herein are used for

identification purposes only and may be trademarks and/or registered trademarks

of their respective companies.

Contents

1. Introduction.....................................................................................3

1.1 Specifications...........................................................................................4

1.2 What You Have.........................................................................................6

2. Installation ......................................................................................7

2.1 POS-566/566L's Layout..........................................................................8

2.2 Unpacking Precautions………………………………………………...9

2.3 Setting the CPU of POS-566/566L.....................................................10

2.4 Voltage Setting for Flash ROM............................................................11

2.5 LCD Voltage Setting..............................................................................11

2.6 DiskOnChip™Flash Disk....................................................................12

2.7 Watch-Dog Timer ..................................................................................12

2.8 Clear CMOS Setup ...............................................................................13

2.9 RS232/RS422/RS485 Selector...........................................................13

2.10 RI and COM Port Voltage Selector......................................................14

3. Connection....................................................................................16

3.1 Floppy Disk Drive Connector...............................................................16

3.2 PCI E-IDE Disk Drive Connector.........................................................17

3.3 Parallel Port............................................................................................19

3.4 Serial Ports.............................................................................................20

3.5 PS/2 Mouse / Keyboard .......................................................................21

3.6 USB Port Connector..............................................................................22

3.7 External Switches and Indicators .......................................................22

3.8 IrDA Infrared Interface Port ..................................................................23

3.9 Fan Connector .......................................................................................23

3.10 VGA Connector.......................................................................................24

3.11 LCD Connector......................................................................................25

3.12 LAN RJ45 Connector............................................................................26

3.13 Audio Connector....................................................................................26

3.14 Isolated Digital I/O Connector.............................................................27

3.15 AT and ATX Power Connector............................................................29

4. AMI BIOS Setup............................................................................31

4.1 Getting Start............................................................................................31

4.2 Standard CMOS Setup..........................................................................32

4.3 Advanced CMOS Setup.........................................................................33

4.4 Advanced Chipset Setup......................................................................35

4.5 Power Management Setup .................................................................36

4.6 PCI/PLUG AND PLAY Setup................................................................37

4.7 Peripheral Setup....................................................................................39

4.8 Auto-Detect Hard Disk ............................................................................41

4.9 Change Supervisor/User Password……………………………......42

4.10 Auto Configuration with Optimal Settings….....................................43

4.11 Auto Configuration with Fail Save Settings .....................................43

4.12 Save Settings and Exit..........................................................................44

4.13 Exit Without Saving................................................................................44

5. E2Key Function.............................................................................45

Appendix A. DMA, IRQ and 1st MB Memory........................................47

Appendix B. I/O Address Map.. ..........................................................48

Appendix C. Watch-Dog Timer…........................................................49

Appendix D. Flat Panel Connection Module.. .......................................50

Appendix E. AMD-K6 Processor Voltage Requirements........................52

Introduction

Welcome to the POS-566/566L 550MHz K6®-3 / Pentium

Processor Multimedia POS Control Board Computer. The POS-

566/566L board is a LPX Spec. board, which equipped with high

performance Pentium®CPU, LCD/CRT and 10/100Mbps Ethernet,

designed for the system manufacturers, integrators, or VARs that

want to provide all the performance, reliability, and quality at a

reasonable price.

This board has a built-in DiskOnChip™(DOC) Flash Disk Socket

for embedded application. The DOC Flash Disk is 100% software

compatible to hard disk. User can use any DOS command without

any extra software utility. The DOC currently is available from 2MB

to 144MB.

The POS-566/566L provides three 168-pin DIMM sockets for its

on-board DRAM with max. 768MB. DIMM module is 3.3V SDRAM.

The board’s Realtek RTL8139 IEEE 802.u network chipset

provides 10MBps or 100MBps Ethernet with auto-sensing function.

In addition, the POS-566 is also Creative Sound Blaster 16 and

Roland MPU401 UART Mode compatible. This feature is not

available in POS-566L.

With its Isolated Digital I/O control for field site application, this

POS-566/566L is the most advanced POS solution that supports

up to 550MHz processor.

1.1 Specifications :

The POS-566/566L 550MHz K6-3 / PentiumProcessor Multimedia

POS Control SBC provides the following specification:

•CPU: Pentium®MMX up to 233Mhz, AMD®K6®/K6®-2/K6®-3 up to

550MHz, IDT C6, Cyrix 6x86MX, etc. Processor

•RAM : up to 768MB SDRAM 3pcs DIMMs

•Cache memory: 512KB Pipelined Burst SRAM on board

•Bus : PCISA bus expansion to support ISA and PCI bus signal

•Chipset : Aladdin 5, support 100MHz CPU clock

•LCD/CRT Controller :CHIPS 65555 64-bit flat panel controller

Built-in HiQColor Technology for super clean STN flat panel .

CRT Resolution up to 1280 x

1024, 256 color 1024 x 768,

64K color 800 x 600 , 16M

color Display Memory : 2MB

EDORAM

•Support 3.3V or 5V flat panel.

•Support Mono, Color STN, TFT, EL,….wide range flat panel.

•Optional One Channel or Two Channels LVDS module.

•10/100Mbps Ethernet Controller : Realtek RTL8139 IEEE 802.u

100 BASE-TX standard Dual

Auto-sensing interface to 10MBps or 100MBps networks RJ45

connector for 10BASE-T and 100BASE-TX Full duplex

capability, full software driver support. For more

information : www.realtek.com.tw

•Creative Sound Blaster 16 compatible and Roland MPU401

UART Mode compatible

•Floppy disk drive interface : two 2.88 MB, 1.44MB, 1.2MB, 720KB, or

360KB floppy disk drives.

•Four high speed Serial ports : three RS-232C, one RS-232C or

RS-422/485 Port

•Parallel Ports : Two SPP/EPP/ECP Parallel Ports

•Enhanced IDE Interface : One

44-pin Header for 2.5”HDD One 40-pin

Header for 3.5”HDD

•PCISATM Bus Expansion to support ISA and PCI bus signal

•Isolated Digital I/O : 4 Digital Input and 4 Digital Output channels

•IrDA port : Support Serial Infrared (SIR) and Amplitude Shift Keyed

IR (ASKIR) interface.

•TwoUSB ports : Support USB port for future expansion.

•Watchdog timer : can be set by 1, 2, 10, 20, 110 or 220 seconds

period. Reset or NMI is generated when CPU does not periodically

trigger the timer.

•E2KeyTM Function : A special designed 1Kbit EEPROM (non volatile

memory) provided to accept read/ write data by customer’s program.

It is useful to store system ID, Password, Critical Data on the board.

•Flash Disk –DiskOnChip™: The Flash Disk provides 100%

compatibility with hard disk.

•Keyboard connector

•Mouse : PS/2 Mouse Port on-board.

•Power Consumption: +5V/5.5A (AMD K6-2 350MHz,384MB SDRAM)

+12V : 170mA , -12V : 60mA

•Support ATX and AT power supply

•Operating Temperature : 0°~ 60°C ( CPU needs Cooler)

•Operating Humidity: 5-95% non-condensing

1.2 What You Have

In addition to this User's Manual, the POS-566/566L package

includes the following items:

•POS-566/566L 550MHz K6-3 / PentiumProcessor Multimedia

POS Control Board

•RS-232 / Printer Cable

•FDD / HDD Cable

•Audio Cable

•FP24-01 Flat Panel Connection Module (see Appendix D for

detail pin assignment).

•6-pin Mini-Din to Keyboard and Mouse Adapter Cable

If any of these items is missing or damaged, contact the dealer from

whom you purchased the product. Save the shipping materials and

carton in case you want to ship or store the product in the future.

Installation

This chapter describes how to install the POS-566/566L. The

layout of POS-566 is shown on the next page and the Unpacking

Precautions that you should be careful with are described on the

following page. Also included is the jumpers and switches setting

for this board’s configuration, such as: CPU type selection,

system clock setting and Watchdog timer.

2.1 POS-566's Layout

< please, refer to the next page >

2.1 POS-566's Layout

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere ICP Electronics Computerhardware Handbücher

ICP Electronics

ICP Electronics PX-14S3 Bedienungsanleitung

ICP Electronics

ICP Electronics IEI PCISA-6755-RS Series Bedienungsanleitung

ICP Electronics

ICP Electronics ROCKY-3785EV Serial Bedienungsanleitung

ICP Electronics

ICP Electronics PCISA-3717EVT Bedienungsanleitung

ICP Electronics

ICP Electronics NOVA-3710 Bedienungsanleitung

ICP Electronics

ICP Electronics PCISA-3716E2V Bedienungsanleitung

ICP Electronics

ICP Electronics JUKI-752 DX4-100 Bedienungsanleitung

ICP Electronics

ICP Electronics PX-10S Bedienungsanleitung

ICP Electronics

ICP Electronics JUKI-511P Bedienungsanleitung

ICP Electronics

ICP Electronics PX-8S Bedienungsanleitung

ICP Electronics

ICP Electronics Celeron ROCKY-3701 Bedienungsanleitung

Beliebte Computerhardware Handbücher anderer Marken

EMC2

EMC2 VNX Series Betriebsanleitung

Panasonic

Panasonic DV0PM20105 Bedienungsanleitung

Mitsubishi Electric

Mitsubishi Electric Q81BD-J61BT11 Bedienungsanleitung

Gigabyte

Gigabyte B660M DS3H AX DDR4 Bedienungsanleitung

Raidon

Raidon iT2300 Bedienungsanleitung

National Instruments

National Instruments PXI-8186 Bedienungsanleitung

Hauppauge

Hauppauge WinTV-HVR-2250 Bedienungsanleitung

Kontron

Kontron CP6002 Bedienungsanleitung

Manhattan

Manhattan 702843 Bedienungsanleitung

Aphex

Aphex 230 Bedienungsanleitung

AMD

AMD Phenom II Betriebshandbuch

Intel

Intel NUC 12 Pro Bedienungsanleitung

dbx

dbx Zone Pro 1260 Bedienungsanleitung

Galaxy

Galaxy GHDX2-2430S-24F4D Bedienungsanleitung

Intel

Intel AXXRMFBU4 Bedienungsanleitung

Kontron

Kontron DIMM-PC/MD Bedienungsanleitung

ST X-NUCLEO-SAFEA1B Betriebsanleitung

STEINWAY LYNGDORF

STEINWAY LYNGDORF SP-1 Bedienungsanleitung