idlock.no/zwave
ID Lock 202 Multi
Z-Wave Module (FW 1.6)
English User Manual
•Open the door
•Remove batteries from the lock
•Place the module in the tray for “Remote
Control” (see illustration 1)
•Insert batteries
•Activate “Add node” in the gateway app
Follow the instructions in the gateway manual
•Hold key button (3 secs) to activate panel
•Enter [Master PIN], followed by [*]
oMaster PIN is created upon setup
•Enter digit [9], followed by [*]
•Enter digit [1]
•Open the door
•Activate “Remove node” in the gateway app
Follow the instructions for your gateway
•Hold key button (3 secs) to activate panel
•Enter [Master PIN], followed by [*]
oMaster PIN is created upon setup
•Enter digit [9], followed by [*]
•Enter digit [1]
•Open the door
•Hold key button (3 secs) to activate panel
•Enter [Master PIN], followed by [*]
oMaster PIN is created upon setup
•Enter digit [9], followed by [*]
•Enter digit [0]
NB! If the module resets while it is included with a
gateway, the door lock will factory reset. To prevent
this, remove (exclude) the lock first (see: “Remove
the lock”).
Technical specs for the Z-Wave module is listed on the
next page.
Correct communication mode is activated when
batteries are inserted (v1.6 only).
The batteries must be removed before the Z-Wave
Module is inserted or removed. Failing to do so can
cause damage on the module and/or the lock.
