Idex Akron Brass FS100 Bedienungsanleitung
#2 SURFACE PREP
Clean heavily soiled areas with soap and water rst before
disinfecting, per recommendation of the area having jurisdiction
(AHJ).
#3 SAFETY REQUIREMENTS
Only use this product with approved disinfectants suitable for use
with the FS100.*
Refer to the SDS sheets and authority having jurisdiction (AHJ) for
the proper PPE, concentration, and application methods.
*Refer to active ingredient compatibility list in the FS100™ user
manual
Akron Brass Company | akronbrass.com | 1-800-228-1161
343 Venture Blvd |Wooster, Ohio 44691
REV001 4/20
FSG-MNL-00220
#1 COMMISSIONING
Review all safety warnings in the manual before operating the unit.
Before using the unit, the user manual should be read and the unit
needs to be put into service by hooking up the proper AGM
battery, priming the unit, and testing operation.
The label on the tank has a place to write down the chemical
currently in use and the date added.
FS100 QUICKSTART GUIDE
ATTENTION WARNING
IMPORTANT NOTICE
IMPORTANT NOTICE
IMPORTANT NOTICE
ATTENTION CAUTION
ATTENTION WARNING
The Water Flow Experts
TM
Akron Brass Company | akronbrass.com | 1-800-228-1161
343 Venture Blvd |Wooster, Ohio 44691
REV001 4/20
FSG-MNL-00220
#4 FILLING UP RESERVOIR
•Before starting, check to ensure the reservoir is empty.
•If the reservoir is not empty, remove excess liquid and ush the
system with water.
•Once the reservoir is cleaned and empty, use the 4-inch open-
ing on top to ll it with the disinfectant recommended by your
AHJ in the concentration compliant with the EPA label and the
FS100™chemical compatibility list.
Do not pour hot or boiling liquids into the reservoir. When mixing
liquids in the reservoir, add water rst, then the concentrate, so that
the concentrate is not sitting undiluted in the reservoir.
Follow all safety and PPE guidelines listed on the SDS sheet and
EPA label specic to the disinfectant you will be handling.
ATTENTION CAUTION
ATTENTION CAUTION
ATTENTION CAUTION
#5 PRIMING THE PUMP
•Disconnect the wand from the end of the hose, using the
quick-connect tting.
•Place the end of the hose into the top of the 5-gallon reservoir.
•Locate the on/off switch on the unit and move the switch to the
on position. You should hear the piston pump operating as it
begins to circulate uid through the system.
•Once uid is circulating through the system and back into the
5-gallon reservoir, turn the switch to the off position or down
direction. The pump has been primed.
•Remove the hose from the 5-gallon reservoir and reconnect the
wand.
#6 POWER REQUIREMENTS
The system either operates from the installed 12VDC battery or
when plugged into a standard 120VAC GFCI protected outlet via the
integrated battery charger.
Unit should be turned off when not spraying.
ATTENTION CAUTION
FS100 QUICKSTART GUIDE
The Water Flow Experts
#8 APPLYING THE PRODUCT
Ensure the work area is well ventilated in accordance with OSHA,
NIOSH, or AHJ standards.
Apply product to the surface using slow and smooth sweeps to wet,
but not saturate the surface.
Use the EPA guidance in order to determine proper contact time for
disinfection.
The wand trigger can create a pinching hazard. Use gloves or grip the
trigger near the bottom when applying the product.
#9 TURNING OFF SYSTEM
When you have nished operating the system, ip the switch to the off
position. This deactivates the pump.
With the wand pointed in a safe direction, relieve pressure in the sys-
tem by pulling the wand trigger.
#10 STORAGE
After the system is safely shutdown, return the hose, wand, and
extension cord back to the storage area.
If the system is going into long term storage, ensure the chemical
is properly drained from the reservoir according to EPA and AHJ
regulations. Flush the system with water and drain.
If the system will be stored in a below-freezing environment, ush the
system with an antifreeze solution and drain.
#11 DISPOSAL/REMOVAL OF PPE
When you are nished shutting down and storing the system.
Remove and dispose or clean your PPE according to your AHJ.
Akron Brass Company | akronbrass.com | 1-800-228-1161
343 Venture Blvd |Wooster, Ohio 44691
REV001 4/20
FSG-MNL-00220
FS100 QUICKSTART GUIDE
#7 TURNING THE SYSTEM ON
System is turned on via the on/off switch.
The pump will pressurize the uid, which can be expelled via the trig-
ger on the wand.
IMPORTANT NOTICE
ATTENTION CAUTION
IMPORTANT NOTICE
IMPORTANT NOTICE
ATTENTION CAUTION
ATTENTION CAUTION
The Water Flow Experts
Inhaltsverzeichnis
Andere Idex Spritzpistole Handbücher
