IEI Technology JUKI-C400 Series Bedienungsanleitung

September 1, 2004

JUKI-C400 Series

Intel ULV Celeron Processor

With Ethernet , USB 2.0 ,Audio

Embedded Board

User Manual

Version 1.1

The information in this document is subject to change

without prior notice in order to improve reliability, design

and function and does not represent a commitment on

the part of the manufacturer.

In no event will the manufacturer be liable for direct,

indirect, special, incidental, or consequential damages

arising out of the use or inability to use the product or

documentation, even if advised of the possibility of such

damages.

This document contains proprietary information protected

by copyright. All rights are reserved. No part of this

manual may be reproduced by any mechanical, electronic,

or other means in any form without prior written

permission of the manufacturer.

Trademarks

JUKI-C400 is registered trademarks of ICP Electronics Inc.;

IBM PC is a registered trademark of International

Business Machines Corporation. VIA is a registered

trademark of VIA Corporation. AMI is registered

trademarks of American Megatrends Inc.,Other product

names mentioned herein are used for identification

purposes only and may be trademarks and/or registered

trademarks of their respective companies.

Table of Contents

CHAPTER 1 INTRODUCTION......................................5

1.1 SPECIFICATIONS............................................................6

1.2 PACKAGE OF CONTENTS ...................................................8

CHAPTER 2 INSTALLATION.........................................9

2.1 LAYOUT ......................................................................9

2.2 DIMENSION DIAGRAM (UNIT: MM)....................................11

2.3 UNPACKING PRECAUTIONS ..............................................12

2.4 CLEAR CMOS SETUP ....................................................12

2.5 BUZZER FUNCTION SETTING............................................13

2.6 COM2 RS-232 /422/485 MODE SETTING.........................13

2.7 TFT LCD SETTING.......................................................13

2.8 COM2 RI FUNCTION SETTING.........................................14

2.9 COMPACT FLASH MASTER/SLAVE FUNCTION SETTING ..............14

CHAPTER 3 CONNECTION............................................15

3.1 AUDIO CONNECTORS.....................................................15

3.2 IDE DISK DRIVE CONNECTOR..........................................16

3.3 PARALLEL PORT ...........................................................17

3.4 LVDS LCD INVERTER CONNECTOR ...................................18

3.5 USB PORT CONNECTORS ...............................................18

3.6 SERIAL PORTS ............................................................19

3.7 KEYBOARD/MOUSE CONNECTOR .......................................20

3.8 IRDA INFRARED INTERFACE PORT .....................................21

3.9 FAN CONNECTOR .........................................................21

3.10 VGA CONNECTOR ........................................................22

3.11 DIGITAL I/O CONNECTOR...............................................22

3.12 EXTERNAL SWITCHES AND INDICATORS...............................23

3.13 PS-ON CONNECTOR.....................................................23

3.14 LAN RJ45 CONNECTOR.................................................24

3.15 TFT LCD CONNECTOR ..................................................24

3.16 LVDS LCD CONNECTOR................................................25

3.17 PC/104 CONNECTION BUS.............................................26

3.18 FLOPPY CONNECTOR .....................................................27

3.19 COMPACT FLASH STORAGE CARD SOCKET............................28

CHAPTER 4 AMI BIOS SETUP..................................30

4.1 GETTING START ..........................................................30

4.2 STARTING SETUP .........................................................30

4.3 USING SETUP .............................................................31

4.4 GETTING HELP ............................................................32

4.5 MAIN MENU ...............................................................33

4.6 STANDARD CMOS SETUP...............................................35

4.7 ADVANCED CMOS SETUP...............................................37

4.8 ADVANCED CHIPSET SETUP .............................................42

4.9 POWER MANAGEMENT SETUP ...........................................44

4.10 PCI / PLUG AND PLAY SETUP...........................................46

4.11 PERIPHERAL SETUP.......................................................48

4.12 HARDWARE MONITOR SETUP ...........................................50

4.13 CHANGE SUPERVISOR PASSWORD .....................................50

Chapter 1 Introduction

Welcome to the JUKI-C400 board, which comes equipped with a

low power consumption and high performance INTEL ULV C400

processor. It is designed for the system manufacturers,

integrators, or VARs that want to provide all the performance,

reliability, and quality at a reasonable price.

In addition, JUKI-C400 built-in the ProSavage4 AGP4X VGA

controller. It is a 2D/3D graphics controller, which provides

resolution up to 1920X1440, and supports both CRT and LCD

simultaneously. The VGA controller can share 8~32MB frame

buffer of system memory.

For the application that needs high speed serial transmission,

JUKI-C400 provides both the USB1.1 and USB2.0 for your choice.

The high speed USB2.0 host controller implements an ECHI

interface that provides 480Mb/s bandwidth.

Both on-chip UARTs are compatible with the NS16C550. The

parallel port and IDE interface are compatible with IBM PC/AT

architecture.

JUKI-C400 built-in 10/100 Fast Ethernet LAN. It is a fully

integrated 10BASE-T/100BASE-TX LAN controller with high

performance and low power features.

JUKI-C400 uses the advanced VIA VT8606/VT82C686B Chipsets

which is 100% software compatible chipset with PCI 2.2

standard.

1.1 Specifications

CPU INTEL ULV Celeron processor ,supports

100 MHz FSB

Bus interface PCI/ISA bus

Bus speed ISA: 8MHz, PCI: 33MHz

DMA channels 7

Interrupt levels 15

Chipset VT8606

Real-time

clock/calendar VT82C686B

Main memory One 144-pin DIMM socket supports

133Mhz SDRAM . The max. memory is up

to 512MB.

Ultra DMA 100

IDE interface Up to four PCI Enhanced IDE hard drives

are supported. The Ultra DMA 100 IDE

can handle data transfer up to 100MB/s.

Compatible with existing ATA IDE

specifications is best advantage, so there

is no need to do any changes for users’

current accessories.

Floppy disk drive

interface Supports up to two floppy disk drives,

5.25”(360KB and 1.2MB) and/or 3.5”

(720KB, 1.44MB, and 2.88MB)

Serial ports Four RS-232 ports with 16C550 UART (or

compatible) with 16-byte FIFO buffer.

Support up to 115.2Kbps. Ports can be

individually configured to COM1,

COM2 ,COM3, COM4 or disabled.

Bi-directional

parallel port Configurable to LPT1 or disabled.

Supports EPP/ECP/SPP

Hardware monitor

Built-in to monitor power supply voltage

and fan speed status

IrDA port Supports Serial Infrared(SIR) and

Amplitude Shift Keyed IR(ASKIR)

interface

USB 2.0/1.1 port

Support 3 USB2.0 and 2 USB1.1 ports for

future expansion

Watchdog timer Software Programmable, reset generated

when watchdog timer is time-out. You can

use I/OPort hex 043(843) & 443 to

control the watchdog.

VGA controller Built-in ProSavage4 AGP4X 256-bit 2D/3D

graphics engine. 8~32MB share Memory.

Screen Resolution: up to 1920x1440.

Ethernet Fast Ethernet controllers, IEEE 802.3u

Auto-Negotiation supports 10BASE-

T/100BASE-TX standard. The RJ45

connectors are located on the mounting

bracket for easy connection.

Keyboard and

PS/2 mouse

connector

A 6-pin mini DIN connector is located on

the mounting bracket for easy connection

to a keyboard or PS/2 mouse. For

alternative application, a keyboard and a

PS/2 mouse pin header connector are also

available on board.

Audio AC’97 Audio CODEC

Compactflash It can be used with a passive adapter

(True IDE Mode ) in a Type I/II Socket.

Expansion bus PC/104 compatible

Power consumption

(INTEL C400 400Mhz, PC133 SDRAM)

+5V @2.8A ,+12V @ 500mA

Recommended: 250-watt power supply or

higher

Operating

temperature 0°~ 60°C

1.2 Package of Contents

JUKI-C400 package includes the following items:

lJUKI-C400 Main Board

lTwo RS-232 cables

lOne Parallel port cable

lOne FDD cable

lTwo ATA IDE cables

lOne Audio cable

lKeyboard and mouse Y-Adapter cable

lOne Companion-CD

NOTES:If any of these items are missing or damaged, contact

the dealer from whom you purchased this product.

Save the shipping materials and carton in case you

want to ship or store the product in the future.

Chapter 2 Installation

This chapter describes how to install the JUKI-C400.

The layout diagram of JUKI-C400 is shown on the

next page and the Unpacking Precautions that you

should be careful with is described on the following

page. Also included is the jumpers and switches

setting for this board’s configuration, such as: CPU

type selection, system clock setting and Watchdog

timer.

2.1 Layout

< Please, refer to next page >

Layout (JUKI-C400 Series)

Inhaltsverzeichnis

Andere IEI Technology Hauptplatine Handbücher

IEI Technology

IEI Technology PCIE-9450 Bedienungsanleitung

IEI Technology

IEI Technology IMB-H810-i2 Bedienungsanleitung

IEI Technology

IEI Technology IMB-Q770 Bedienungsanleitung

IEI Technology

IEI Technology NANO-KBN-i1 Bedienungsanleitung

IEI Technology

IEI Technology IMB-G41A Bedienungsanleitung

IEI Technology

IEI Technology IMBA-C2460 Bedienungsanleitung

IEI Technology

IEI Technology KINO-HM551 Bedienungsanleitung

IEI Technology

IEI Technology IMBA-BDE Bedienungsanleitung

IEI Technology

IEI Technology WSB-945GSE Bedienungsanleitung

IEI Technology

IEI Technology NANO-QM871-i1 Bedienungsanleitung

IEI Technology

IEI Technology PCIE-G41A2 Bedienungsanleitung

IEI Technology

IEI Technology NOVA-9152 Bedienungsanleitung

IEI Technology

IEI Technology IMBA-C2060 Bedienungsanleitung

IEI Technology

IEI Technology NANO-BT Series Bedienungsanleitung

IEI Technology

IEI Technology PCIE-Q57A Bedienungsanleitung

IEI Technology

IEI Technology IMBA-9454B-R11 Bedienungsanleitung

IEI Technology

IEI Technology IMBA-H610 Bedienungsanleitung

IEI Technology

IEI Technology NANO-GM45A Bedienungsanleitung

IEI Technology

IEI Technology IMBA-H110 Bedienungsanleitung

IEI Technology

IEI Technology IMBA-9454 Bedienungsanleitung

IEI Technology

IEI Technology NANO-GM45A2 Bedienungsanleitung

IEI Technology

IEI Technology POS-6614 Bedienungsanleitung

IEI Technology

IEI Technology SAGP-648E Bedienungsanleitung

IEI Technology

IEI Technology IMBA-9654 Bedienungsanleitung

Beliebte Hauptplatine Handbücher anderer Marken

DFI

DFI SD170 Bedienungsanleitung

ASROCK

ASROCK ROMED8-2T Bedienungsanleitung

Asus

Asus P2L97A Bedienungsanleitung

Winmate

Winmate IC70 Bedienungsanleitung

Asus

Asus MES-B Bedienungsanleitung

Grantech

Grantech SYS8F377VGGA-3OMN Bedienungsanleitung

Telit Wireless Solutions

Telit Wireless Solutions SL869-3DR Bedienungsanleitung

Texas Instruments

Texas Instruments ADS8372EVM Bedienungsanleitung

Commell

Commell MS-C73 Bedienungsanleitung

Gigabyte

Gigabyte GA-9IVDT Bedienungsanleitung

IBT Technologies

IBT Technologies MB860 Bedienungsanleitung

Nvidia

Nvidia TEGRA DG-04927-001_V01 Bedienungsanleitung

Intel

Intel D33217CK Bedienungsanleitung

Asus

Asus F1A55-M LX PLUS R2.0 Bedienungsanleitung

EPC

EPC EPC9147C Bedienungsanleitung

Asus

Asus EX-B760M-V5 D4 Bedienungsanleitung

EPOX

EPOX MU-8KHA0010 Bedienungsanleitung

Ski-Doo

Ski-Doo Bombardier MPEM 219 700 090 Bedienungsanleitung