Start / Pause
II I
TA
SRT/PAUSE
After choosing the desired program and options, press this button to start the
pa a a rrogram. Start/P use Led will glow red to indicate that the progr m h s sta ted.
Ps t S/ef h
Press Start/ au e button once to enter pause sta e, tart Paus Led will las red in
pause mode.
g
To change the program durin the machine run, Press Pause button èSwitch OFF the
aieè
c
m ch n Swit h ON èSelect a new program.
cr , s oTo sele t / deselect the options du ing the program run Press Pau e butt n èChange the
options è
Press Start button.
m d i
Pause ode is indicate by the flash ng of start pause red LED
I
DOOR ndication
s b . n
Fla hes Red if door opening is availa le wait till it glows Gree .
b d
Door can e opened only when the door Le glows Green.
E oarNOT :
Additi n of load fter sta ting the program.
pp, r
1. To o en the door during rogram run pause the machine. Doo Led will flash Red
n
only if door ope ing is available, if not it will glow red.
The door will get opened after
G
a delay of 1 - 2 minutes. Door Led will glow reen.
c t
2. To prevent any untoward in idents to you, additional pro ection is provided in which
f n
the door cannot be opened even i paused when the water temperature i the
0el s
drum is above 60 C or if the wat r evel inside the drum is high or if the wa hing
nn
machine is in spin ig operation.
L F YCHILD OCK SA ET PROVISION
Y s e s t
ou can safeguard your wa hing machin to prevent any unintentional changes to the elec ed
ioptions and to the program sequence by activating Ch ld lock feature.
“” a resTo activate Child lock fe ture p ess “Pr wash/” and “rinse hold” button simultaneously.
rofo about 3 sec. Child lock can be activated nly after starting the program.
dcu l tl a
Chil lo k feat re makes all the functiona bu tons inoperative. When chi dlock is activ ted
childlock led will glow
To deactivate the child lock, press the same two buttons simultaneously for about 3sec. child
lock LED will go OFF
sunt
If child lock is opted, it ha to be disabled to Pa se and make a y changes in he options
d
uring program run, or after end of the program for opening the door.
RAUTOMATIC DETE GENT DISPENSER TRAY
a v r iDesigned for utomatic dispensing of detergent & additi es as equired which avo ds manual
ih T t
flling at eac stage. he detergent dispenser tray should be filled with detergent & addi ives before
tme
the star of a program.
The tray has three cha b rs
1In s. Pre wash chamber: (Marked – ) To be filled with detergent ica e a pre wash
program has been chosen.
d f
2. Main wash chamber: (Marked –II) To be fille with detergent or every wash
rprog am.
rbb3. Fabric conditione additive cham er: To e used for additives only.
i e o
It should be filled as per nstructions mention d in the topic “ peration”.
eln
Th detergent tray must be pulled out, fil ed as required a d shut before the machine is switched
ON
lt s e r
At power on s art Start/Pause Led will fla h gre n indicating that the prog am has not
started.
l
l
l
l
t, rlA the end of the program Sta t/Pause Led will go off.
ooe
l
Glows Red when do r is lck d
loption
l
l
l
l
l
l
(Marked “ “)
Press
Door
Status
12
