-2-www.igmtools.com
Operating Instructions EN
Please read this manual thoroughly and follow the safety instructions in it! Technical changes and
printing errors reserved!
Dear customer,
this manual contains information and important guidelines for the assembly and proper use of the Straightline
Edgebanding and Trimming Kit.
Please read and follow the safety instructions!
Carefully read these instructions before using the machine. Operation of the machine will be simpler and
you will also lower the risk of injury while eliminating the probability of incorrect operation and possible
damage to the machine.
Because of our policy of constant improvement, the design, construction or pictures may differ slightly.
Should you discover any mistakes, please contact us at podpora@igm.cz.
1.1 Set description
1
Front fence
Guiding the work piece to
worktable at the front
2
Back fence
Guiding the work piece through the
work table
3Stable plate
Spacer for passing edge band
4Moveable frame
Leveling spacer for work piece
5Lead fence
Lead work piece to worktable
11 Straight lead fence
Fix trimmer holder on worktable.
12 Trimmer holder
Fasten trimmer
1. SPECIFICATIONS
Assemble and operation
• Worktable is compatible for straightline edge banding and trimming operation, follows (Fig1) to begin
installation.
• Make sure the roller is horizontal to the back fence and fasten by screw (Fig 2).
• Make sure the room between front and back fence can fit the tap and two fences are horizontal (Fig 3).
Adjust horizontally
between two fences
Spacer for edge band
Fasten with screw
Fig 1 FIg 2 Fig 3
4
4
2
3
11
12
5
1
