Chapter 1
1.1 Machine Description
The machine contain the oil tank components (with the pump), oil conveying pipe, spraying oil
pipe, oil collecting pan, reflow pipe and liquid level control. With compact and briefness
structure, easy dismounting and replace the parts. Easy control, easy operate, low power
consumption, good effect etc.
1.2 Un-crating Instructions
During un-crating make sure that no physical damage to the outside of the crate has taken
place. Carefully break open the exterior panels to reveal the machine and its working parts.
The machine will be covered in a plastic protective cover. This is to be removed. Make sure
that no parts have been damaged during transport, or fallen off the machine. The machine will
arrive with certain parts dis-assembled. These need to be fitted to the machine to resemble
the photos above the machine. The machine is fixed to the wooden palett by four metal
brackets. Remove these brackets and discard or keep for future use. The doors and covers
have been taped closed for safety reasons, these taped parts can now be opened. Surface rust
can take place due to the excessive sea sir during shipping. This will only be surface rust and a
dry cloth should be used to remove this rust residue. The entire machine has bee shipped with
an oil coating on the surface to safeguard the machine from corrosion. This can now be
removed with a very light detergent. The non-stainless steel parts should be re-oiled to
prevent rusting taking place after cleaning. Do not leave the machine wet.
The machine is top-heavy and as such, care should be taken when handling the machine and
removing it from its wooden pallet.
NOTE: DO NOT HANDLE THE MACHINE ON THE FILM BRACKETS OR ROLLERS. These parts are
critically aligned and should they be bent out of position the film may run off.
1.3 Installation
Only a qualified technician should perform the machine installation or a suitably trained
person.
Note: it is dangerous to work on a moving machine and the machine should be off and
isolated before any form of work is performed.
Machine should be placed in a well-ventilated room, free from dust and excessively
corrosive materials.
