imenco Spinner Shark Bedienungsanleitung
Spinner Shark
User manual
1
Imenco
Imenco Is a major EPC-contractor……………………………
Contents
Introduction………………………………………………………………… 2
Safety guidelines………………………………………………............. 2
Before use……………………………………………………………………3
Item Checklist……………………………… 3
Function Test………………………………. 3
Installation……………………………………………………………………4
Operation…………………………………………………………………….5
Maintenance…………………………………………………………………6
Service……………………………………………………………………… 6
Technical Specification…………………………………………………… 7
Camera………………………………………… 7
Lens……………………………………………. 8
Physical properties……………………….. 9
Power…………………………………………. 9
Apendix 1
Conector configuration / Final test... 11
2
Introduction
Thank you for purchasing this Imenco product.
The Imenco Spinner Shark Camera HD-SDI camera is designed primarily for ROV operations.
With 30x optical zoom, horizontal angel of view 65 and a lens system who gives al good optical,
and a low barrel distortion.
Spinner shark have Titanium Housing, and fused silica front port.
Depth rating for Spinner shark camera is 4000msw.
Video transfer is by using HD-SDI over coax, or by fiber.
Spinner camera is Nitrogen filled to, prevent camera become misted.
Safety guidelines
Read and understand all sections in this manual before installing or operating this product.
Installation of this product should only be performed by qualified personnel.
3
Before use
Item checklist
Before starting, check that the following items have been included with your Spinner Shark
camera. Contact Imenco or your local dealer if anything is damaged or missing.
1. Spinner Shark HD-SDI camera
2. User manual, this document.
3. Case.
4. (Memory stick, with software and manual.) (option).
5. Test interface box (option).
6. Dummy connector (option)
Function Test
Make sure your new product is working as intended. Connect your system as further described in
this manual, and make sure all function is working. Imenco cannot be held liable for any loss or
inconvenience caused by the use of a faulty product.
4
Installation
Installation of this product should only be performed by qualified personel.
Mount the camera on a secure and vibration free surface if possible.
To avoid corrosion, and pitting, Keep Spinner camera isolated from other metals, by using
Plastic, rubber, or similar material to isolate camera.
5
Operation
Caution: Turn off power before connecting or disconnecting the power cable.
Caution: avoid long term testing in air, as overheating can cause damage to internal components.
Connector configurations
Study the connector configuration diagram in appendix 1 and make connections accordingly.
Operational Temperatures
The HD-SDI camera is designed for subsea usage and should not be operated without adequate
cooling for long periods of time.
Camera control
Spinner camera can be controlled in different ways.
RS232: (RS485 option).
You have full control of camera settings.
You can control Zoom, Focus, White balance, Autofocus, video output , etc,, all of camera
module settings.
Tristate:
Zoom is controlled with one wire, with ref to +12v in camera.
Focus is controlled with one wire, with ref to +12v in camera.
Autofocus can be activated by operating zoom and focus at same time.
Control level is ±5vdc to 24vdc.
Two wire:
Zoom is controlled with two wire.
Focus is controlled with two wire.
Autofocus can be activated by operating zoom and focus at same time.
Input voltage is ± 5vdc to 24vdc.
With two wire, control input is optical isolated from camera.
6
Maintenanse
After use in seawater or other corrosive environments, rinse unit and cables in fresh water.
Inspect the front port for dirt and dust and remove any surface dirt using compressed air. Clean
the port glass using a mild detergent and a soft cloth. Avoid circular wiping patterns. Reapply
silicon based lubricant to the connector regularly as needed.
Service
This product contains no user serviceable parts. Service and modifications are to be carried out
by Imenco personnel or by Qualified third party with prior approval from Imenco. Failure to
comply may result in personal injury, damage to Equipment and loss of warranty.
7
Technical specification
Camera
Image device: 1/2.8 Type “Exmor”CMOS Sensor
Image : 1080p
Picture elements 2140K pixels
Video Output: HD-SDI 1080p/720p 59,94hz/50hz/30hz/25hz
Analog SD: VBS
Min. illumination 50%norm mode 1,4lx (F1,6 AGC on, 1,30s)
ICR-OFF 0.35 lx (1/30 sec, 50%,
High Sensitivity mode On)
1.4 lx (1/30 sec, 50%, High
Sensitivity mode Off)
White Balance Auto, ATW, Indoor, Outdoor, One
Push WB, Manual WB, Outdoor
Auto, Sodium Vapor Lamp (Fix/
Auto/Outdoor Auto)
Electronic shutter speed 1/1 sec to 1/10000 sec (22 steps)
Gain Auto/Manual
(0 to 43.1 dB (0 to 28 step))
Max. Gain Limit
(9.2 to 43.1 dB (6 to 28 step))
8
Lens
Angle of view (H) Approx. 65 degrees
1080p mode 65°(wide end)to 2,3°(tele end).
720p mode 65°(wide end)to 2,3°(tele end).
SD mode 48°(wide end)to 1,7°(tele end).
30×Zoom
F= 4.3 mm (WIDE) to 129 mm
(TELE), F1.6 to F4.7
Zoom movement speed
Optical WIDE –Optical TELE
4.6 sec (Focus Tracking On)
3.2 sec (Focus Tracking Off)
Optical WIDE –Digital TELE
6.7 sec (29.97p/59.94p mode)
7.1 sec (25p/50p mode)
Digital WIDE –Digital TELE
2.2 sec (29.97p/59.94p mode)
2.7 sec (25p/50p mode)
Focus Movement time
∞to Near 1.1 sec
Digital Zoom 12×(360×with optical zoom)
Min. working distance
Front port Glass (fused silica)
9
Physical properties
Dimensions: Ø: 140mm x L: 234mm (excl connector)
Weight air / water: 4,9 kg/2,9 kg
Housing Material: Titanium TI-6AL-4V
Depth Range: 4,000 MSW
Temperature :
Operating -5 +50℃
Storage -20 +60
Power
Operating voltage 12-36vdc (24vdc 600ma)
Current draw (24vdc max 600ma)
Inhaltsverzeichnis
Andere imenco Scheinwerfer Handbücher
Beliebte Scheinwerfer Handbücher anderer Marken
Guangzhou Yinhe Lighting&Sound Equipment Factory
Guangzhou Yinhe Lighting&Sound Equipment Factory NE-204 Bedienungsanleitung
LIVARNO home
LIVARNO home 375304 2101 Originalbetriebsanleitung
Cameo
Cameo CLQS40WW Bedienungsanleitung
Leviton
Leviton Ellipsoid 5/50 Bedienungsanleitung
Monacor
Monacor img Stage Line PARL-56PDX/CR Bedienungsanleitung
Vector
Vector SL3AKV Bedienungsanleitung
EuroLite
EuroLite Akku flat light 1 Bedienungsanleitung
Commercial Electric
Commercial Electric SPTM-1401 Bedienungsanleitung
Vision & Control
Vision & Control SLB-500-W5K7-P-SL Bedienungsanleitung
Teknik
Teknik FLEXI Bedienungsanleitung
Craftsman
Craftsman CMXLSB10 Bedienungsanleitung
EuroLite
EuroLite LED SLS-144 UV Floor Spot Bedienungsanleitung