1
1. Screen Activation
All Impulse Pumps equipped with ECOMIZER-PRO are operated using only a single
switch. To activate the display, keep the switch in the “Start” position until the display
lights up (approximately 5 seconds). Once it has lit up, you can release the switch, which
will return to the “On” position. In the “On” position, the unit is active for remote
operation.
Please be aware that the pump is in Stand-By mode as soon as the switch is in “On”
position. Maintenance, repair, and/or transportation should never be done with the
switch in “On” position.
1. To start the ECOMIZER-PRO: Hold the “Off-On-Start” switch on the control box in
the “Start” position, and wait until the Touch Screen display appears.
2. After these 3 seconds the switch can be released, and it return to its “on” position.
When no further actions are made during the shutdown delay (standard on 2
minutes) the ECOMIZER-PRO will switch itself into Stand-By. To reactivate the
ECOMIZER-PRO the user has to turn the switch on “start” again, or when applied
(optional), the pump can be started by Remote Control.
3. The “Off” position will shut down the Pump Unit completely. This position can be
used as emergency stop. Make sure the ECOMIZER-PRO is on “Off” while
maintaining, repairing, transporting or being stored.
Screen Activation
Switching to “Off” Position has the same working as an
emergency stop
