IN-COMMAND JRVCS105 Bedienungsanleitung

JRVCS105

RV CONTROL AND MONITORING SYSTEM

Installation and Operation Manual

™

Patent # 9,679,644

JRVCS105

Read the iN-Command Manual, and these warnings and instructions carefully before using this product. Failure to follow the use

instructions in this owner’s manual, or improper use of the Mobile Application, Display Commander and/or Body Control Module, could

result in personal injury, including death.

Do not operate while vehicle is being driven. The Mobile Application, Display Commander and/or Body Control Module should not be

used while the vehicle is being driven. Use of the Mobile Application, Display Commander and/or Body Control Module while the vehicle

is being driven is dangerous and may cause personal injury or property damage.

For adult use only. The Mobile Application, Display Commander and Body Control Module are intended for adult use only, and are not

to be used by persons under the age of 18. Use by children may cause personal injury or property damage.

Operate only when you have a clear line of sight. Do not operate any moving parts (including, but not limited to, awnings, jacks and

slides), unless you have a clear line of sight to the moving part. The Mobile Application, Display Commander or Body Control Module

may be used only if you are giving instructions to, and receiving instructions from, another person at least age 18 or older who can clearly

see the moving part. Failure to follow these instructions may result in serious personal injury or property damage.

Do not operate under the inuence of alcohol or drugs. Do not operate the Mobile Application, Display Commander or Body Control

Module while under the inuence of alcohol or drugs. Doing so may result in personal injury or property damage.

Avoid moisture. To reduce the risk of re or electric shock, do not expose this equipment to rain or moisture.

Use recommended accessories. To reduce the risk of re or electric shock and annoying interference, use only the recommended

accessories.

Important Safety Information

JRVCS105

TABLE OF CONTENTS ...........................................................3

INTRODUCTION .....................................................................4

Thank You! .............................................................................4

Features.................................................................................4

Precautions ............................................................................4

Packing List............................................................................4

INSTALLATION ........................................................................5

Tools and Supplies .................................................................5

Disconnecting the battery.......................................................5

Selecting the Mounting Location............................................5

Mounting the Display Commander (DC) ................................5

WIRING ...................................................................................6

BCM AND DC WIRING DIAGRAM ..........................................7

SETUP MENU LIST .................................................................8

SAFETY LOCKOUT ................................................................9

TROUBLESHOOTING ...........................................................10

OVERRIDE SWITCHES ........................................................ 11

DISPLAY COMMANDER BUTTONS ..................................... 11

SPECIFICATIONS .................................................................12

FCC Notes ...........................................................................12

PASSCODE PROTECTION ..................................................13

MENU ....................................................................................14

Text Editing...........................................................................14

Scroll List Editing..................................................................15

Tanks....................................................................................15

Lights ...................................................................................15

Motors ..................................................................................16

Passcode .............................................................................17

Set Passcode Timer ..........................................................18

Change Passcode .............................................................18

Clear Passcode .................................................................18

MOBILE DEVICES: ...................................................................................... 19

Pairing Mobile Device to DC ....................................................................... 20

Setting the Floor Plan on the Mobile Device............................................... 22

CHECKING FOR AN ACTIVE BLUETOOTH SESSION .............................. 23

SOFTWARE UPDATE* ................................................................................. 24

RESET: FLOOR PLAN ................................................................................. 26

SYSTEM CALIBRATION* ............................................................................. 27

• TABLE OF CONTENTS

JRVCS105

• INTRODUCTION

• Thank You!

Thank you for choosing iN-Command. We hope you will nd the instruc-

tions in this owner’s manual clear and easy to follow. If you take a few

minutes to look through it, you’ll learn how to use all the features of your

new JRVCS105 for maximum enjoyment.

• Features

Features of Jensen JRVCS105 system include:

• Simultaneous control by up to three Android Devices and one iOS

Device

• Control two zones of Interior Lighting

• Monitor all water tank levels

• Control and monitor the Water Heater (switches between LP or AC)

• Control and monitor the Water Pump

• Control Awning

• Control Electric Slides

• Control Jacks (non-automatic function)

• Monitor Battery Voltage with Low Voltage Alert

• Precautions

• Use the Proper Power Supply.

This product is designed to operate with a 12 volt DC, negative ground

battery system (the standard system in a North American vehicle).

• Use Authorized Service Centers.

Do not attempt to disassemble or adjust this precision product; contact

a professional for assistance.

• Avoid Moisture.

To reduce the risk of re or electric shock, do not expose this equipment

to rain or moisture.

• Avoid Cleaning Products.

The front of this unit should only be cleaned with a slightly damp cloth.

Do not use cleaning products.

•

(1) Cover, (1) Thumb Screws (1) Body Control Module (BCM)

(1) Display Commander (DC)

• Packing List

• Use Recommended Accessories.

TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK AND

ANNOYING INTERFERENCE, USE ONLY THE RECOMMENDED

ACCESSORIES.

JRVCS105

• INSTALLATION

It’s a good idea to read all of the instructions before beginning the

installation. We recommend having your Jensen JRVCS105 installed

by a reputable RV dealership

• Tools and Supplies

You will need these tools and supplies to install your JRVCS105:

• Phillips screwdriver

• #2 square drive bit

• Wire cutters and strippers

• Electrical tape

• Volt meter/test light

• Crimping tool

• Fork Crimp connectors

• Minimum of 24 gauge wire required to connect DC to BCM

• 10 gauge wire for power and slide connections

• 14 and 18 gauge wire for all other connections

• Four #8 PH (0.164” x 0.75”) screws for the DC

• Six #8 PH (0.164” x 1.0”) screws for the BCM

• Disconnecting the battery

To prevent a short circuit, be sure to turn off 12V power and remove

the negative (-) battery cable prior to installation.

• Selecting the Mounting Location

Select a mounting location, taking care to avoid the following:

• Places exposed to heat-radiating appliances such as electric heaters

• Adjacent to other equipment that radiates heat

• Under thermostats

• Poorly-ventilated or dusty places

• Moist or humid locations

CUTOUT FOR DISPLAY COMMANDER (DC)

NOTE: Before cutting the mounting hole, make sure the area

behind the mounting location is clear of wires, fuel and vacuum

or water lines; ensure there is at least a 2.75”clearance below

the Display Commander to allow for programming by USB stick.

RECOMMENDED CUTOUT

WALL FOR

REFERENCE

CUTOUT 3.0"

4.3"

• Mounting the Display Commander (DC)

• Use the mounting hole diagram to measure and cut a mounting hole,

allowing space below for future programming and behind for ventilation

• Route power and transmit wires through the hole and connect

• Check and ensure correct operation

• Mount the unit using four #8 PH (0.164” x 0.75”) screws

• Attach Trim ring

JRVCS105

PIN NO. WIRE GAUGE DESCRIPTION

118 AWG FRESH TANK 1 (IN)

218 AWG BLACK TANK 1 (IN)

318 AWG BLACK TANK 2 (IN)

418 AWG GRAY TANK 1 (IN)

518 AWG GRAY TANK 2 (IN)

618 AWG GRAY TANK 3 (IN)

718 AWG TANK COMMON 7V (IN)

814 AWG LIGHT GROUPS +12V (IN)

914 AWG LIGHT GROUP 1 – 12V (GND)

10 14 AWG LIGHT GROUP 1 +12V (OUT)

11 14 AWG LIGHT GROUP 2 -12V (GND)

12 14 AWG LIGHT GROUP 2 +12V (OUT)

13 14 AWG AWNING LIGHT -12V (GND)

14 14 AWG LAWNING LIGHT +12V (OUT)

15 18 AWG WATER HEATER FAULT

16 18 AWG WATER HEATER GROUND

17 18 AWG WATER HEATER ON (GAS)

18 18 AWG WATER HEATER ON (ELECTRIC)

19 16 AWG TRAVEL LOCK +12V (IN)

20 14 AWG WATER PUMP +12V (OUT)

• WIRING

The wiring diagram depicts all the wiring connections required for proper operation of the unit.

The TX (transmit) and RX (receive) wires from the BCM to DC are reversed at each device (the BCM transmits and the DC receives, and vice versa).

BODY CONTROL MODULE (BCM) CONNECTIONS

PIN NO. WIRE GAUGE DESCRIPTION

21 14 AWG WATER PUMP -12V (GND)

22 14 AWG WATER PUMP +12V (IN)

23 12 AWG MOTOR 5 -12V (IN)

24 12 AWG MOTOR 5 +12V (OUT)

25 10 AWG MOTOR 4 -12V (IN)

26 10 AWG MOTOR 4 +12V (OUT)

27 10 AWG MOTOR 3 -12V (IN)

28 10 AWG MOTOR 3 +12V (OUT)

29 10AWG MOTOR 2 -12V (IN)

30 10 AWG MOTOR 2 +12V (OUT)

31 10 AWG MOTOR 1 -12V (IN)

32 10 AWG MOTOR 1 +12V (OUT)

33 10 AWG CHASSIS GROUND (IN)

34 10 AWG MOTOR FEED+12V (IN)

35 10 AWG BCM +12V (IN)

36 N/A NC

37 24 AWG +12 VDC

38 24 AWG TX (Connect to DC RX)

39 24 AWG RX(Connect to DC TX)

40 24 AWG GND

• BCM AND DC WIRING DIAGRAM

JRVCS105

• SETUP MENU LIST

ITEM SELECTION

Black Water Tank 2 No, Yes

Gray Water Tank 2 No, Yes

Grey Water Tank 3 No, Yes

Light Group 1 No, Yes

Light Group 2 No, Yes

Awning Light No, Yes

Motor 1 No, Yes

Motor 2 No, Yes

Motor 3 No, Yes

Motor 4 No, Yes

Motor 5 No, Yes

Tanks, light groups, and motor functions can be added or removed.

Motor functions may include slides, awnings, jacks, or any motor

that may be controlled with a momentary switch.

Refer to the Wiring Diagram and Terminal List when installing new

equipment. The BCM may not include relays for non-OEM

functions. Basic automotive 1505 relays (12VDC Coil, 40/30A

14VDC Contact) can be purchased for installation and repair.

JRVCS105

• SAFETY LOCKOUT

IN-Command is equipped with a Safety Lockout feature to

ensure certain system functions are unavailable during transit.

When the Brake or Right Turn Signal on the tow vehicle is

activated, IN-Command will lock down all motorized functions.

A red button, with Travel Lock in white text, will appear on the

DC and mobile devices will display “Travel Lock On” in red

letters. All motor functions will cease to actuate and Disable

will be written on their buttons.

The lights, water pump, water heater, and sensors will

continue to function.

To turn the Travel Lock off, ensure 12VDC is not going to the

Travel Lock system by removing the 7-way connector from

the tow vehicle and press the “Unlock” button on the Display

Commander inside the RV.

Travel Lock on the Display Commander

Travel Lock on a handheld device app

Inhaltsverzeichnis

Beliebte Sicherheitssystem Handbücher anderer Marken

Inner Range

Inner Range Concept 2000 Bedienungsanleitung

Climax

Climax Mobile Lite R32 Montageanleitung

CADDX

CADDX NX-6 Bedienungsanleitung

FBII

FBII XL-31 Series Bedienungsanleitung

Johnson Controls

Johnson Controls PENN Connected PC10 Bedienungsanleitung

Aeotec

Aeotec Siren Gen5 Bedienungsanleitung

Blaupunkt

Blaupunkt SA 2700 Bedienungsanleitung

IDEAL

IDEAL Accenta Betriebsanleitung

AJAX

AJAX DoubleButton Bedienungsanleitung

Swann

Swann SW-P-MC2 Bedienungsanleitung

Ecolink

Ecolink Siren+Chime Bedienungsanleitung

Digital Monitoring Products

Digital Monitoring Products XR150 Bedienungsanleitung

EDM

EDM Solution 6+6 Wireless-AE Bedienungsanleitung

Highway Safety Group

Highway Safety Group EA401 Bedienungsanleitung

Siren

Siren LED GSM Bedienungsanleitung

Detection Systems

Detection Systems 7090i Montageanleitung

Se-Kure Controls

Se-Kure Controls MicroMini SK-4841 Bedienungsanleitung

Siemens

Siemens FDM273 Bedienungsanleitung