1. On the Installer Registration screen, enter your name and contact information. This information will be used by
Indyme Support personnel throughout the install and to ensure you are at the correct job site.
2. On the Work Order screen, verify the listed details match your present job site and, the list of devices match your
inventory of products. Once all details are confirmed, select the “Start Work” button and begin your installation.
3. With the Devices screen showing, connect POE power source to the RJ45 inside the DM9032. (Power may come
from a POE switch OR a POE injector.) The device will power up and produce a VERY LOUD “chime” tone and the
LEDs will flash. The unit will associate with the local Indyme infrastructure, (access point and control unit), and its
unique-id will appear highlighted in green on the webpage. Verify the unique-id that appears matches the sticker
inside the DM9032.
4. Select the highlighted device, (DM9032). In the Device Details screen, select the Location where the device
will be installed. The Activity Profile and Alert Profile will automatically be filled in. Do not change these
values.
5. Select the “Add Picture” button and take a picture of the device properly mounted.
6. Select the “Save” button.
6a. (After the Save button), A “Sending Changes” pop up will appear. This will transfer the Device’s data to
the control unit.
6b. The “Ready for Activation” pop up appears directing the user to press the button, (Activation Button) to
activate changes.
6c. Push the Activation Button as indicated. When the transaction is complete, another pop up will appear –
“Your changes have been saved. Return to devices list?”. Select Yes
6d. Repeat until all DM9032 devices are properly programmed.
7. Once all devices have been programmed, return to the Work Order screen. Verify the number of Completed
devices. Select the “Stop Work” button and close the work order.
8. Call Indyme to verify the devices are correctly configured and working.
NOTE: The DM9032 devices should be programmed while in the designated location OR after they are physically
mounted to ensure proper signal strength with the system antenna(s).
SmartDome™ Installation
The DM9032/DM9032-SA SmartDome™ are designed as ceiling mounted devices. They may be mounted directly
to a drop-tile ceiling grid, extended from the grid using a telescoping pole or extended from a ceiling truss.
Mounting hardware is available for all options. For ceiling heights of 11-feet or less, the DM9032-DM9032-SA
should be direct mounted, heights greater than 11-feet should use the telescoping pole. Ideal height is 12-feet or
less.
Required Tools
The following tools are recommended to complete the installation according to these instructions;
(1) 1/4” or 1/2” socket wrench handle, (1) 9/16” socket, (1) 7/16” deep socket, (1) 3/16” Allen wrench, (1) pair
pliers, (1) Philips screwdriver.
