2 - MicroTimer 2400
Introduction
Introduction
The MicroTimer® standard control board design includes a minimum of functionality. The functionality of the MicroTimer®
can be expanded by means of additional “ECOS”® software modules. Thus, it is possible to produce perfectly customised
MicroTimers®. MicroTimer® outputs have two neutral relay points to control a connected device over a certain
programmable length of time. This MicroTimer® is programmed in a user-optimised way by means of three control keys.
With its potted electronics and its extensibility by means of “ECOS”® software modules the MicroTimer® is a very special
timer of its kind.
“ECOS”® : Electronic Customised Option System
Design
§
Very resistant plastic housing
§
Suitable for internal and external installation
§
Three keys: Start/Pause, Timer & Stop (internal and external)
§
Bright green 2-digit LED display
§
Extensibility by means of ECOS software modules
§
Supply voltage either 24 Volt or 240 Volt
Extra werking (with all ECOS modules)
The MicroTimer® can be activated with three freely programmable time-segments. The duration of these time-segments
can be set at 0 to 255 minutes.
Prior Time
The MicroTimer® starts with a prior time. During the prior time the length of the main time will be shown intermittently on
the display. During the prior time it is possible to reduce the main time if necessary. The prior time can also be bypassed so
that the main time will start automatically.
Time per periode (Main Time)
During the main time the remaining time will be shown on the display. When activating a pause a buzzer signal may be
generated. Another possibility consists of the automatic main time adjustment based on the progression of the service
counter.
Post Time
The main time is automatically followed by the post time. During the post time “Cl” (cool) is displayed. After the post
time it is possible to activate a clean function, in this case “CL” is displayed intermittently. This clean function inhibits
the MicroTimer®. Furthermore, there is an “after start” function by means of which an extra main time of 30 seconds can
be given at the end of the whole session.
Service Message
Registration facilities, as for example start, running time and service counters can also be used. The start and running time
counters may either be activated as counters, which can be reset, or as cumulative counter, which can not be reset.
Automatic representation of the Running time counter is affected by pressing the Stop key during 3 seconds. The service
counter generates a SR (service message) on the display
