Infineon GTM ATOM Interrupt 1 Bedienungsanleitung

AURIX™ TC2xx Microcontroller Training

V1.0.0

GTM_ATOM_Interrupt_1

GTM ATOM interrupt

Please read the Important Notice and Warnings at the end of this document

Scope of work

The GTM ATOM is configured to trigger an interrupt every 500 ms. The

interrupt toggles an LED.

The Generic Timer Module triggers an interrupt every 500 ms.

The state of the port pin, where the LED is connected, is toggled inside the

Interrupt Service Routine (ISR).

Introduction

›The Generic Timer Module (GTM) is a modular timer unit designed to

accommodate many timer applications.

›It has an in-built Advanced Router Unit (ARU) that can be used to

exchange specific data between sub-modules without CPU interactions.

›The ARU-connected Timer Output Module (ATOM), which is part of the

GTM, is able to generate complex output signals without CPU

interactions.

›The Clock Management Unit (CMU) is responsible for clock generation of

the GTM. The Configurable Clock Generation Subunit (CFGU) provides

eight clock sources for the GTM submodules TIM, TBU, MON and ATOM.

Hardware setup

This code example has been

developed for the board

KIT_AURIX_TC297_TFT_BC-Step.

LED D107 (1) is used for this

example.

Implementation

Configuring the ATOM

The configuration of the ATOM is done once in the setup phase by calling the initialization

function initGtmAtom() containing the following steps:

›Enable the GTM by calling the function IfxGtm_enable().

›The function IfxGtm_Atom_Timer_initConfig() initializes an instance of the structure

IfxGtm_Atom_Timer_Config with its default values.

›The IfxGtm_Atom_Timer_Config structure allows to set the following parameters to

initialize the module:

–atom –Select ATOM 0

–timerChannel –Select channel 0 of ATOM 0

–clock –Select CMU clock 0

–base.frequency –Set timer frequency to 2 Hz (interrupt every 500 ms)

–base.isrPriority –Interrupt Service Routine priority

–base.isrProvider –Interrupt Service Routine provider

Implementation

Configuring the ATOM

›Set the CMU clock 0 frequency to 1 MHz with the function

IfxGtm_Cmu_SetClkFrequency().

›Enable the CMU clock 0 by calling the function IfxGtm_Cmu_enableClocks().

›After clock configuration, the function IfxGtm_Atom_Timer_init() initializes and activates

the ATOM with the user configuration.

›Start the timer with the function IfxGtm_Atom_Timer_run().

All the functions used for the configuration of the ATOM are provided by the iLLD header

IfxGtm_Atom_Timer.h.

Configuring the LED

The LED configuration is also done in the function initGtmAtom():

›Set the port pin mode to output and push-pull by calling the function

IfxPort_setPinModeOutput(), provided by iLLD header IfxPort.h.

Implementation

Interrupt Service Routine (ISR)

The ISR implemented in this example contains the following steps:

›Clear the timer event with the function IfxGtm_Atom_Timer_acknowledgeTimerIrq() in the

iLLD header IfxGtm_Atom_Timer.h

›Change the LED state by calling the function IfxPort_togglePin() in the iLLD header

IfxPort.h

Run and Test

After code compilation and flashing the device, observe the LED D107 (1),

which should be blinking.

References

›More code examples can be found on the GIT repository:

›https://github.com/Infineon/AURIX_code_examples

›For additional trainings, visit our webpage:

›https://www.infineon.com/aurix-expert-training

›AURIX™ Development Studio is available online:

›https://www.infineon.com/aurixdevelopmentstudio

›Use the „Import...“ function to get access to more code examples.

›For questions and support, use the AURIX™ Forum:

›https://www.infineonforums.com/forums/13-Aurix-Forum

IMPORTANT NOTICE

The information given in this document shall in no

event be regarded as a guarantee of conditions or

characteristics (“Beschaffenheitsgarantie”).

With respect to any examples, hints or any typical

values stated herein and/or any information

regarding the application of the product, Infineon

Technologies hereby disclaims any and all

warranties and liabilities of any kind, including

without limitation warranties of non-infringement

of intellectual property rights of any third party.

In addition, any information given in this

document is subject to customer’s compliance

with its obligations stated in this document and

any applicable legal requirements, norms and

standards concerning customer’s products and

any use of the product of Infineon Technologies in

customer’s applications.

The data contained in this document is exclusively

intended for technically trained staff. It is the

responsibility of customer’s technical

departments to evaluate the suitability of the

product for the intended application and the

completeness of the product information given in

this document with respect to such application.

For further information on the product,

technology, delivery terms and conditions and

prices please contact your nearest Infineon

Technologies office (www.infineon.com).

WARNINGS

Due to technical requirements products may

contain dangerous substances. For information

on the types in question please contact your

nearest Infineon Technologies office.

Except as otherwise explicitly approved by

Infineon Technologies in a written document

signed by authorized representatives of Infineon

Technologies, Infineon Technologies’ products

may not be used in any applications where a

failure of the product or any consequences of the

use thereof can reasonably be expected to result

in personal injury.

Edition 2019-10

Published by

Infineon Technologies AG

81726 Munich, Germany

Do you have a question about this

document?

Email: erratum@infineon.com

Document reference

GTM_ATOM_Interrupt_1

Trademarks

All referenced product or service names and trademarks are the property of their respective owners.

Inhaltsverzeichnis

Andere Infineon Steuereinheit Handbücher

Infineon

Infineon GTM ATOM PWM 1 Bedienungsanleitung

Infineon

Infineon ERU Interrupt 1 Bedienungsanleitung

Infineon

Infineon GPT12 PWM Capture 1 Bedienungsanleitung

Infineon

Infineon Cypress EZ-BLE CYBLE-022001-00 Bedienungsanleitung

Infineon

Infineon XMC1000 Bedienungsanleitung

Infineon

Infineon AIROC CYW20822-P4TAI040 Bedienungsanleitung

Infineon

Infineon GTM TOM Interrupt 1 Bedienungsanleitung

Infineon

Infineon Multicore 1 Bedienungsanleitung

Infineon

Infineon PressFIT Bedienungsanleitung

Infineon

Infineon CCU6 PWM Capture 1 Bedienungsanleitung

Infineon

Infineon FF900R12IE4 Handbuch

Infineon

Infineon GTM TIM Capture 1 Bedienungsanleitung

Infineon

Infineon Easy 1B Bedienungsanleitung

Infineon

Infineon Cypress CYBLE-212020-01 Bedienungsanleitung

Infineon

Infineon SCU Reset Detection 1 Bedienungsanleitung

Infineon

Infineon ASCLIN LIN Master 1 Bedienungsanleitung

Infineon

Infineon GTM ATOM PWM 1 Bedienungsanleitung

Infineon

Infineon AIROC CYW20835 Bedienungsanleitung

Infineon

Infineon Cypress EZ-BLE CYBLE-012011-00 Bedienungsanleitung

Infineon

Infineon PBA 313 07 Bedienungsanleitung

Infineon

Infineon UART VCOM 1 Bedienungsanleitung

Infineon

Infineon SMU IR Alarm 1 Bedienungsanleitung

Infineon

Infineon AIROC CYW20829B0-P4TAI100 Bedienungsanleitung

Infineon

Infineon GPT12 Timer Concatenation 1 Installationsanleitung

Beliebte Steuereinheit Handbücher anderer Marken

Festo

Festo Compact Performance CP-FB6-E Stücklistenhandbuch

Elo TouchSystems

Elo TouchSystems DMS-SA19P-EXTME Bedienungsanleitung

JS Automation

JS Automation MPC3034A Bedienungsanleitung

JAUDT

JAUDT SW GII 6406 Series Kurzanleitung

Spektrum

Spektrum Air Module System Bedienungsanleitung

BOC Edwards

BOC Edwards Q Series Bedienungsanleitung

KHADAS

KHADAS BT Magic Bedienungsanleitung

Etherma

Etherma eNEXHO-IL Bedienungsanleitung

PMFoundations

PMFoundations Attenuverter Bedienungsanleitung

GEA

GEA VARIVENT Bedienungsanleitung

Walther Systemtechnik

Walther Systemtechnik VMS-05 Bedienungsanleitung

Altronix

Altronix LINQ8PD Montageanleitung

Eaton

Eaton Powerware Series Bedienungsanleitung

WAGO

WAGO 750-407/040-000 Bedienungsanleitung

Sony

Sony CCU-590 Bedienungsanleitung

Graco

Graco 25D614 Bedienungsanleitung

Task Force Tips

Task Force Tips YE-RF-900 Programmierhandbuch

Shini

Shini SPV-U Series Bedienungsanleitung