ISR-PRO Quick Start Guide
5 Steps to Healthier Living
For more informaon and to order more salt, please visit our website at
www.innitysaltair.com
Step 5: Cleaning Your ISR-PRO
Twist Fan Assembly to align the
dot with the unlock icon, then pull
to remove the fan assembly.
Reverse procedure to re-assemble.
1. Turn o Main Power Switch on boom and unplug
the unit from the power adapter.
2. Pull the top half from the boom half.
3. Empty the grinding barrel. Use the supplied brush to
remove all salt remnants.
4. Remove the fan assembly.
5. Clean Middle Secon (see below).
6. Clean Fan Assembly (see below).
7. Re-assemble the ISR-PRO and it is ready to go!
Microscopic parcles of salt can cover the electrical connecons and cause the unit not to work. When this occurs, it is possible
that the salt grinder will not react to the buon push. If the unit is plugged in, the boom power buon is ON, the fan assembly is
correctly locked, and the unit will not work, please try to clean the unit thoroughly, including the brass contacts, with these simple
instrucons.
Cleaning the Fan Assembly: Remove as much salt residue as possible with the supplied brush. This
includes removing salt from around the spring loaded contacts on the assembly and on and around the
fan blades.
Special Note: Your salt grinder is NOT waterproof. In fact, humidity is halotherapy’s worst enemy. Do not aempt to use
water to remove salt or clean the unit. You should also run it in an environment where the humidity is less than 50%RH for
the smallest, most benecial salt parcle size for your health.
Washing or rinsing in water will void the warranty.
Cleaning the Middle Secon: Remove as much salt residue as possible with the supplied
brush. This includes removing salt from around the spring loaded contacts on the middle
secon and in and around vortex tube. A rm toothbrush or brass brush can help!
Clean the at contacts, too. If
they are corroded, use a rm
brush.
Helpful Hint: Check that all 4 spring loaded contacts push in and release freely!
