Infinity Total Solutions TSS-SAT500 Bedienungsanleitung

TSS-SAT500

Owner’s Guide

(230V)

TOTAL SPEAKER SOLUTIONS

ENGLISH

2TSS-SAT500

3Introduction

3Included

3Planning Your System

3Placement

4Wall-Mounting

5Connections

5Maintenance and Service

6Specifications

Table of Contents

TSS-SAT500 OWNER’SGUIDE

TSS-SAT500

ENGLISH

Infinity Total Solutions™

Infinity Total Solutions continues Infinity’s longstanding commitment

to accurate sound reproduction. Our high-quality drivers, precision

dividing networks and rigid, well-braced enclosures combine to

deliver uncompromised performance in any multichannel home

theater system. In addition, the TSS-SAT500 is magnetically

shielded for safe place-ment adjacent to a television.

NCLUDED

(1) Speaker (1) Wall bracket

NTRODUCTION

Before deciding where to best place your speakers, survey your

room and study Figures 1 and 2.

Figure 1.This overhead view shows a typical home theater plan.

Left/right rear channels are for a 7-channel system. Center rear

channel is for a 6-channel system.

Figure 2.This figure shows an alternate layout, which may be

more suitable for some rooms. Left/right rear channels are

for a 7-channel system. Center rear channel is for a 6-channel

system.

Center Rear

Channel

Subwoofer

Right

Front

Channel

Right

Surround

Channel

Left

Front

Channel

Left

Surround

Channel

Center

Channel

Center Rear Channel

Couch

LANNING

OUR

YSTEM

LACEMENT

NOTE: The TSS-SAT500 can be placed directly on a shelf,

or mounted on a wall using the included wall bracket.

As Left and Right Front Channels

For left and right front channels, place one satellite to the left and

another to the right of the television, as shown in Figure 1.

Since the speakers are magnetically shielded, you can place them

very close to the TV without worrying about the magnetic field

distorting the picture.

As Surround Channels

For left and right surround channels, place one speaker on the left

and another on the right, to the side of or slightly behind the

listening area.The surround speakers should be mounted at a

height of between 5 ft. (1.5m) and 7 ft. (2m).

In 6- or 7-channel configurations, place the rear channel(s) behind

the listening position, as shown in Figures 1 and 2.

NOTE: An Infinity powered subwoofer will add impact and realism to

both music and film soundtracks. Contact your Infinity dealer for

recommendations on subwoofer models for your application.

Mounting on Floor Stands

An optional TSS-STAND500 floor stand is available, should you

prefer to place your TSS-SAT500 satellites on the floor; see your

dealer or visit www.infinitysystems.com for more information.

In addition, there is a 1/4"-20 insert in each satellite that allows

the satellite to be mounted to many third-party floor stands. Unscrew

the rear foot to reveal the insert.

4TSS-SAT500

WALL-MOUNTING

The TSS-SAT500 satellite is designed to be mounted on the wall.

There is a wall bracket included.The speaker bracket will require

four 1-1/2" #10 wood screws; each screw should be fastened to a

wall stud. If a wall stud is unavailable, install an anchor appropriate

for a 1-1/2"#10 screw.

NOTE: The customer is responsible for the correct selection and use

of mounting hardware (available through hardware stores) that will

ensure the proper and safe wall-mounting of the speakers.

Step 1. Detach shelf stand by removing screw in rear of speaker.

Step 2. Mark the positions on the wall where you would like to place

the mounting screws.

Step 3. Place bracket against the wall and fasten four 1-1/2" #10

wood screws through the bracket’s screw holes into the wall. If a

wall stud is not available, use an appropriate anchor.

Step 4. Unscrew round collar (C) from bracket (A).

Step 5. Screw the ball and shaft assembly (B) to 1/4"-20 insert on

rear of speaker. Back out 1/2 of a turn and tighten nut against the

speaker.

Step 6.Attach speaker wire as shown on page 5.

Step 7. Drop round collar (C) over ball and shaft assembly (B) that

is mounted to the speaker with the finished side of the collar facing

the rear of the speaker.

Step 8. Carefully push the ball straight into the socket mounted on

the wall, angle the speaker as desired and tighten the collar using

the enclosed metal bar.

Figure 3. Bracket on wall.

Metal Bar

TSS-SAT500

ENGLISH

ONNECTIONS

After placing the speakers, you are ready to connect your system.

First, turn off all audio-system power. Use high-quality speaker wire

to make your connections. #18-gauge speaker wire with polarity

coding is included. For longer distances, #16-gauge or heavier

wire is recommended.The side of the wire with a ridge or other

coding is usually considered positive polarity (i.e., +). Also, consult

the owner’s manuals that were included with your amplifier or

receiver to confirm connection procedures.

Observe polarities when making speaker connections, as shown in

Figure 4. Connect each + terminal on the back of the amplifier or

receiver to the respective + (red) terminal on each speaker.

Connect the – (black) terminals in the same way.

Important!

Do not reverse polarities (i.e., + to –, or – to +) when making

connections. Doing so will cause poor imaging and diminished bass

response. Be certain that positive and negative wire strands are

completely isolated to avoid short circuits that may damage your

equipment.

Press

Connector

In and

Hold

Insert Bare

End; Release

Connector

–+

Figure 4. Wiring diagram shows polarity connections for one

channel of a home theater system.

AINTENANCE AND

ERVICE

The TSS-SAT500 enclosure may be cleaned using a soft cloth to

remove fingerprints or to wipe off dust.

All wiring connections should be inspected and cleaned or remade

periodically.The frequency of maintenance depends on the metals

involved in the connections, atmospheric conditions and other

factors, but once per year is the minimum.

If a problem occurs, make sure that all connections are properly

made and clean. If a problem exists in one loudspeaker, reverse the

connection wires to the left and right system. If the problem remains

in the same speaker, then the fault is with the loud-speaker. If the

problem appears in the opposite speaker, the cause is in another

component or cable. In the event that your TSS-SAT500 ever needs

service, contact your local Infinity dealer or distributor, or visit

www.infinitysystems.com for a service center near you.

TSS-SAT500

Frequency Range: 150Hz – 25,000Hz (±3dB)

Recommended

Amplifier Power Range: 10 – 100 watts

Sensitivity: 86dB

(2.83V @ 1 meter)

Nominal Impedance: 8Ω

Crossover Frequency: 7,000Hz

Midrange Driver(s): 64mm (2-1/2")

magnetically shielded

High-Frequency Driver: 19mm (3/4")

magnetically shielded

Dimensions (H x W x D): 195mm x 89mm x 70mm

(7-11/16" x 3-1/2" x 2-3/4")

Weight: 0.5kg (1.2 lb)

Infinity continually strives to update and improve existing products, as well as create new ones.

The specifications and construction details in this and related Infinity publications are

therefore subject to change without notice.

PECIFICATIONS

6TSS-SAT500

Laurent Rault

Harman Consumer Group International

Château du Loir, France 11/05

Declaration of Conformity

We, Harman Consumer Group International

2, route de Tours

72500 Château du Loir

France

declare in own responsibility that the products described

in this owner’s manual are in compliance with technical

standards:

EN 61000-6-3:2001

EN 61000-6-1:2001

TSS-SAT500

ENGLISH

OTES

Infinity Systems, 250 Crossways Park Drive,Woodbury,NY 11797 USA www.infinitysystems.com

Infinity and Harman International are trademarks of Harman International Industries, Incorporated, registered in the United States and/or other countries.

Total Solutions is a trademark of Harman International Industries, Incorporated.

Dolby and Pro Logic are registered trademarks of Dolby Laboratories.

DTS is a registered trademark of DTS,Inc.

Part No. 406-000-05350-E 11/05

Inhaltsverzeichnis

Andere Infinity Lautsprechersystem Handbücher

Infinity

Infinity Entra Two Bedienungsanleitung

Infinity

Infinity ENTRA Bedienungsanleitung

Infinity

Infinity Reference 2000.1 Bedienungsanleitung

Infinity

Infinity Total Solutions TSS-1200 Bedienungsanleitung

Infinity

Infinity Primus Series Primus Theater Pack II Bedienungsanleitung

Infinity

Infinity INTERLUDE IL10 Bedienungsanleitung

Infinity

Infinity Total Solutions TSS-450 Bedienungsanleitung

Infinity

Infinity Total Solutions TSS-FMK4000 Bedienungsanleitung

Infinity

Infinity IRSV System Bedienungsanleitung

Infinity

Infinity Beta ES250 Bedienungsanleitung

Infinity

Infinity PRIMUS 250 Bedienungsanleitung

Infinity

Infinity Total Solutions TSS-750 Bedienungsanleitung

Infinity

Infinity Primus 250 Bedienungsanleitung

Infinity

Infinity RS-10 Bedienungsanleitung

Infinity

Infinity Cascade Five Bedienungsanleitung

Infinity

Infinity Total Solutions TSS-SUB4000 Bedienungsanleitung

Infinity

Infinity ENTRA Bedienungsanleitung

Infinity

Infinity Cascade Speaker System Bedienungsanleitung

Infinity

Infinity Kappa Series perfect6.1 Bedienungsanleitung

Infinity

Infinity Total Solutions TSS-1100 Bedienungsanleitung

Infinity

Infinity Primus 250 Bedienungsanleitung

Infinity

Infinity Total Solutions TSS-800 Bedienungsanleitung

Infinity

Infinity Interlude IL50 Bedienungsanleitung

Infinity

Infinity Primus Theater Pack 700P5PPS10 Bedienungsanleitung

Beliebte Lautsprechersystem Handbücher anderer Marken

JVC

JVC CA-MXK5R Bedienungsanleitung

LG NB4532B Bedienungsanleitung

JVC

JVC CA-FSH100 Bedienungsanleitung

5Core

5Core Pro Series Bedienungsanleitung

EAW

EAW MQV1394e Bedienungsanleitung

Lynx

Lynx GXR-LA10A Bedienungsanleitung

iLive

iLive ITB066B Bedienungsanleitung

RDX

RDX QuickStation 4 Bedienungsanleitung

Electro-Voice

Electro-Voice S-122 Bedienungsanleitung

Sven

Sven SPS-619 GOLD Bedienungsanleitung

Pioneer

Pioneer CS-7070 Bedienungsanleitung

EAW

EAW UB82e Bedienungsanleitung

Sondpex

Sondpex Active Speaker System and Digital Music... Bedienungsanleitung

JVC

JVC NX-PN7 Bedienungsanleitung

Marshall Amplification

Marshall Amplification AR-DM61-BT Bedienungsanleitung

Yamaha

Yamaha NX-A01 - Speaker Sys Bedienungsanleitung

SE Audiotechnik

SE Audiotechnik I-LINE Bedienungsanleitung

Gemini

Gemini WRX-843 Series Bedienungsanleitung