7|English
GENERAL SAFETY RULES
△WARNING: Read and understand all instructions.Failure to follow all instructions listed
bellowed may result in electric shock, tire,and/or seriouspersonal injury.
1. KEEP GUARDS IN PLACE and in working order.
2. REMOVE ADJUSTING KEYS AND WRENCHES. Form habit of checking to see that
keys and adjusting wrenches are removed from tool before turning it on.
3. KEEP WORK ARES CLEAN AND DRY. Cluttered areas and benches invite accidents
Don't use power tools in damp yr wet locations or espore themto rain
4. KEEP CHILDREN AWAY. All visitors should be kept safe distance from work area.
5. USE RIGHT TOOL .Don't force tool or attachment to do a job for which it was not
designed.
6. USE PROPER EXTENSIONCORD. Make sure your extension cord isin good condition.
7. WEAR PROPER EXTENSION. Do not wear loose clothing, neckties, ringsbracelets, or
other jewelry whitch may getcaught in moving parts. Wear protective hair covering to
contain Iong hair.
8. ALWAYS USE SAFETY GLASSES. Also use fact or dust mask if cutting operation is
dusty.
9. DON'T OVERREACH. Keep proper footing and balance at all times.
10.MAINTAIN TOOLS WITHCARE Keep tools sharp and clean for bestand safest
Performance. Follow instructions for lubricating and changing accessories.
l 1. DISCONNECT TOOLS before servicing, when changing accessories, such as blades, bit,
cutters, and the like.
12. REDUCE THE RISK OF UNINTENTIONAL STARTING. Make sure switch is in off
position before plugging in.
13.CHECK DAMAGED PARTS. Beforefurther use of the tool, a guard or other past that is
damaged should be carefully checked and performits intended function-check for alignment
of moving parts, binding of moving parts, breakage of parts, mounting, and any other
conditions that may affect its operation
14. DO NOToperate tool if you are under the influence of any drugsi alcohol or medication that
could affect your ability use the tool properly
15.NEVER use the power curd to pull theplug out of the pulg out of the electrical socket.
16. ALWAYS keep the power cord aways from sharp objects or any other obstacle that may
cause damage to the cord
SPECIFIC SAFETY RULES
1 Inspect for and remove allnails from lumber beforeoperation. Following this rule will
reduce the risk of serious personal injury.
2. Wear earprotection in continuous working time
3. Make sure the transparent guard secure installed before operation.
4. When operation, keep hands awayfrom the rotating parts and hold the trimmer firmly still.
5. Running the tool no loaded for least 1 minute in a protection area when using the new cutter
for the first time.
6. Save these instruction. Refer to them frequently and use them to instruct others who may use
this tool.
