Property Damage: Do not extendthe copper
linesfarther than the 16" provided.
Personal Injury: Do not locate filter above an outlet or other
electrical device. Install headandbracket so that connections
require no stretching, kinkingor pinchingof tubing.
It is normal for approximately 2 oz. of water to
discharge when filter is removed.
Property Damage: Tube runsneedto form to the cabinet’s
contoursto allow storage space with no sharp bends. Tubes
needclean, perpendicular, burr-free cutsto ensure a true fit.
A
BQDetermine length of tubing required,
then cut to length making sure the
cut is perpendicular and burr-free.
QInsert a white 3/8"tube into inlet
side of filter head until it stops.
Press in again to ensure a secure fit.
QInsert the other white 3/8"tube
into outlet side of filter head
until it stops. Press in again to
ensure a secure fit.
QMark hole locations for filter head
and bracket in a spot that allows for
filter replacement.
QDrill 1/8"starter holes and attach
bracket to wall with wood screws,
turning until snug.
QRemove red filter cap, insert filter
cartridge into filter head and twist
clockwise until “LOCK” arrow on the
filter aligns with arrow on bracket.
QTo redirect filter replacement water
discharge, place 6"clear tube over
vent hole on the left side of filter head.
QNote: 3/8"fitting is required to make
connection to water supply.
QConnect remaining white 3/8"tube
to incoming water supply line.
(See Step 6.)
CQInsert the copper tube(s) from the
dispenser into the 3/8"to 1/4"
quick-connect fitting.
QConnect the white 3/8"tube
from the right outlet on the filter
head into the quick-connect fitting
until it stops. Press in again to
ensure a secure fit.
from water
supply line
to dispenser
To remove tube(s) or plug from quick-connector,
depress the release ring and gently pull away.
Discharge
tube
From water
supply line
To dispense
From filter or
water supply line
From filter or
water supply line
D
5INSTALLING FILTRATION SYSTEM
Hot & cool models Hot only models
9
