Page 4 of 13 2448A2 - Rev: 8/23/2011 5:22 PM
Energy Display Owner’s Manual
INSTALLATION
Installing Energy Display
NOTE: Energy Display uses 2 AAA batteries which will provide approximately one year of use.
d INSTEON device and an INSTEON meter
splay
3) ment
on and all the LCD segments will turn on
After a few seconds, the screen will go to Display Mode
er Device
1) Be sure you have properly installed at least one dual-ban
device (such as iMeter Solo #2423A1)
2) Remove the battery compartment door from the rear of Energy Di
atteries, and then replace the battery compartObserve the polarity markings, install two AAA b
door
The Energy Display screen will turn
Energy Display is now ready to use. See Linking Energy Display to an INSTEON Met to begin
bout your appliances.receiving energy information a
HOW TO SET UP ENERGY DISPLAY TO MONITOR AN APPLIANCE’S
POWER CONSUMPTION
Linking Energy Display to an INSTEON Meter Device
Follow these steps to Link Energy Display to an INSTEON meter device (e.g., iMeter Solo). See the meter
it to Energy Display.
The devices:
2) tion is blinking (Meter 1, 2, or 3)
3) ps (3 seconds)
Display Status LED will begin blinking GREEN
Linking Mode automatically times out.
-beep and its Status LED will turn off.
en will display information for the meter device you
Unlinking an INSTEON Meter Device from Energy Display
that you Unlink it.
Display will retry gathering information from the unused meter device, thus slowing
down the system and reducing battery life.
The following will work on the most common INSTEON devices:
1) Use the 1-2-3,Down button to select the meter device you wish to Unlink
2) Set Energy Display to Linking Mode by pressing & holding the Set button until it beeps (3 seconds)
The Energy Display Status LED will begin blinking GREEN
3) Set Energy Display to Unlinking Mode by pressing & holding the Set button until it beeps again (3
seconds)
device’s Owner’s Manual for detailed instructions on how to properly install and Link
following will work for the most common INSTEON
1) Make sure the meter device is properly installed with the appliance you wish to monitor
Tap the 1-2-3/Down button until the desired meter posi
Set Energy Display to Linking Mode by pressing & holding the Set button until it bee
The Energy
You will have 4 minutes to complete the next step before
4) On the meter device, press & hold the Set button until it beeps (3 seconds)
Energy Display will double
A few moments later the Energy Display scre
are metering
If you are no longer going to use an INSTEON meter device, it is very important
Otherwise, Energy
