Intermec 730IS Konfigurationshandbuch

1730IS Manual Supplement

Manual

730IS

Supplement

Mobile

Computer

2730IS Manual Supplement

730 Intrinsically Safe (730IS) Mobile

Computer

Important Operating Instructions

The Model 730IS Mobile Computer has been quali-

fied by the Underwriters Laboratories Inc., to the re-

quirements of the USA and Canada for use in Class I,

Division 1, Groups C and D; Class II, Division 1,

Groups F and G locations; and Class III Division 1. It

has a T4 temperature code..

Warnings and Cautions

Explosion Hazard-Substitution of

components may impair suitability for

Class I, Class II, and Class III Division 1

locations.

Note: This unit has no operator replace-

able parts other than the battery pack and

SD Card. Repair of the 730IS Mobile

Computer must be performed by trained

Intermec service personnel.

Explosion Hazard-Batteries must only be

changed or charged in an area known to

be non-hazardous. Use Intermec battery

pack p/n: 318-011-006 only.

Note: From time to time additional battery

packs may be added to the qualifications of

the 730IS. Contact your local Intermec

representative if battery pack (p/n:

318-011-006) is no longer available as a

replacement battery pack.

The battery pack used in this device may

present a fire or chemical burn hazard if

mistreated. Do not disassemble, heat

above 100°C (212°F) or incinerate.

Dispose of used battery packs promptly.

Keep away from children.

3730IS Manual Supplement

The following additional warnings and cautions must

be observed for the safety of the operator and others in

potentially hazardous locations:

SThe 730IS must only be used when the ambient

temperature is between -20°C and +40°C(-4°F

and +104°F).

SUse only Intermec part number 715-370-001 Se-

cure Digital memory card while in potentially haz-

ardous locations. This card must not be removed or

changed while in the hazardous location.

Battery Pack Removal

For maximum effectiveness it is important to leave the

main battery installed in your 730IS Mobile Comput-

er even if it is discharged. If the main battery is re-

moved, it should be replaced within 10 minutes to

avoid the possibility of data loss. Before removing

the battery ensure that your 730IS Mobile Computer

is in sleep mode. Not doing this could result in a loss

of data.

730IS Hand Strap

Install the hand strap and docking connector cover as

shown in the following illustration. When you need to

gain access to the connector loosen the two thumb

screws to remove the connector cover.

Note: It’s recommended that the docking

connector cover be installed whenever your

730IS Mobile Computer is not in the

dock.

Thumb screws

Slide bottom of strap forward

to release from the retaining slot.

Corporate Headquarters

6001 36th Avenue West

Everett, Washington 98203

U.S.A.

tel 425.348.2600

fax 425.355.9551

www.intermec.com

730IS Manual Supplement

*962-054-124A*

P/N: 962-054-124A

Inhaltsverzeichnis

Andere Intermec Handheld Handbücher

Intermec

Intermec 600 Series 600 Bedienungsanleitung

Intermec

Intermec CN3 Series Bedienungsanleitung

Intermec

Intermec CK60 Ethernet Multidock Bedienungsanleitung

Intermec

Intermec 730 Bedienungsanleitung

Intermec

Intermec CK70 RFID Bedienungsanleitung

Intermec

Intermec CN50 Bedienungsanleitung

Intermec

Intermec CN3A Bedienungsanleitung

Intermec

Intermec CN4NI Bedienungsanleitung

Intermec

Intermec 700 Series 700 Bedienungsanleitung

Intermec

Intermec 741 Bedienungsanleitung

Intermec

Intermec 700 Series Bedienungsanleitung

Intermec

Intermec CN50 Bedienungsanleitung

Intermec

Intermec CN30 Bedienungsanleitung

Intermec

Intermec Oracle-Ready CK31 Bedienungsanleitung

Intermec

Intermec CK30 Handbuch

Intermec

Intermec CK3a Bedienungsanleitung

Intermec

Intermec Oracle-Ready CK31 Bedienungsanleitung

Intermec

Intermec CK32IS Handbuch

Intermec

Intermec PEN*KEY 6100 Bedienungsanleitung

Intermec

Intermec CS40 Vehicle Power Adapter Bedienungsanleitung

Intermec

Intermec CN3E Series Bedienungsanleitung

Intermec

Intermec 200 Bedienungsanleitung

Intermec

Intermec CN4 Bedienungsanleitung

Intermec

Intermec CK70 RFID Bedienungsanleitung

Beliebte Handheld Handbücher anderer Marken

Honeywell

Honeywell Dolphin 9900 Bedienungsanleitung

Honeywell

Honeywell CN75 Bedienungsanleitung

MiTAC

MiTAC Mio 168 Bedienungsanleitung

Wasp

Wasp WDT92 Bedienungsanleitung

Texas Instruments

Texas Instruments TI-Nspire Bedienungsanleitung

AXEM Technology

AXEM Technology MBS Bedienungsanleitung

Armstrong

Armstrong Brain Wave Montageanleitung

Unitech

Unitech TB128 Bedienungsanleitung

Symbol

Symbol MC9000-G Installations- und Betriebshandbuch

Unitech

Unitech HT1 1D Batch Bedienungsanleitung

Ingenico

Ingenico IWL220 GPRS Bedienungsanleitung

Symbol

Symbol c2000 Bedienungsanleitung

Symbol

Symbol MC18 Installations- und Betriebshandbuch

Acer

Acer n20 Bedienungsanleitung

Docomo

Docomo F-04H Bedienungsanleitung

Toshiba

Toshiba e350 Series Bedienungsanleitung

Palm

Palm Tungsten E2 Handbuch

Alien

Alien ALR-H460 Bedienungsanleitung