Ironman4x4 Luxury rooftop tent Bedienungsanleitung

USER GUIDE

IMPORTANT: Please read all procedures and precautions before installing and

using the Ironman 4x4 Luxury Rooftop Tent. If you have any questions please

contact our customer service department listed in the back of the user guide.

Luxury Rooftop Tent With Annex (Optional)

Ladder / Annex Extension (Optional)

LUXURY ROOFTOP TENT

THIS USER GUIDE ALSO INCLUDES

INSTALLATION & SETUP FOR OPTIONAL

IRONMAN 4X4 ANNEX + LADDER / ANNEX

EXTENSION

ANNEX

Thank you for purchasing an Ironman 4x4 Luxury Rooftop Tent

Your Ironman 4x4 Luxury Rooftop Tent is designed to ﬁt a variety of different roof rack styles.

The following User Guide will help you adapt your new Luxury Rooftop Tent to suit your application.

PRE-INSTALLATION

2 - 15

1. Find a ﬂat area to work. Open carton out. This will provide

a clean surface to work on whilst tent is being set up.

2. Locate the four mounting points under the tent ﬂoor and

lay tent down with this side facing upwards. Remove four

rubber bungs.

3. Remove protective plastic coating from tent ﬂoor.

4. Release the four velcro securing straps and open tent

enough to access the mounting rails, installation kit, ladder

and cover which can found inside the tent.

3 - 15

5. The Ironman 4x4 Rooftop Tent can be installed to the

vehicle so that it opens to the rear or either side. This will

determine which way the mounting rails are ﬁtted to the

tent ﬂoor.

The mounting rails need to be running at right angles to

the roof bars on the vehicle.

6. The mounting rails will need to be shortened if they are

required to be mounted across the tent from the hinge.

To do this place the mounting rails in position, with the

mounting holes lined up with the mounting holes in tent

ﬂoor.

Mark both ends of rail level with the edge of the tent and

cut to length.

7. Slide two 6mm Nyloc nuts into mounting rails and align

with mounting holes. Locate the mounting holes under the

mattress and insert the M6 x 40mm bolts and ﬂat washers

from inside out.

PRE-INSTALLATION

4 - 15

12. Attach the ladder to the brackets using M6 bolts, ﬂat

washers and Nyloc nuts, placing plastic spacers between

the ladder mounts and brackets as shown.

PRE-INSTALLATION

11. Turn over tent over and remove rubber bungs from ladder

mounting holes. Attach the ladder brackets as shown,

using M6 bolts, washers and Nyloc nuts.

10. Attach hooks for bungee cord into pre-drilled holes using

self-tapping screws provided.

Note: Depending on direction of rails, some hooks will not

be required.

9. Secure the ends of the mounting rails using the self drilling

screws provided through the pre-drilled holes as shown.

8. Attach the mounting rails to the tent ﬂoor using the M6

bolts and tighten ﬁrmly.

13. Stand tent up on it’s side and slide the four M8 x 55mm

bolts and mounting plates into each mounting rail and

install plastic end caps.

Your tent is now ready to be ﬁtted to your vehicle.

PRE-INSTALLATION

• Itistheresponsibilityoftheinstallertoensuretheroofrackhasanadequateloadratingtosupportthe

Ironman 4x4 Luxury Rooftop Tent. Tent weighs approximately 55kg.

• Although two people can possibly lift the Luxury Rooftop Tent onto the vehicle, we recommend that four people

be used due to the weight and size of the tent. This is to prevent personal injury or damage to the vehicle

• Ifmountingthetentforrearopening,makesurethatthetailgateoperationdoesnotinterferewithtent.

• Whenliftingthetentontotheroofofthevehicle,makesurethatmountingboltsdonotcontacttheroofasthis

will cause damage to the vehicle. In some cases the mounting bolts might need to be shortened to clear the

roof.

• In some cases, 6.5mm holes will need to be drilled through roof bars to secure tent.

The manner in which your Luxury Rooftop Tent can be attached depends on the type of roof rack / roof bars ﬁtted to

your vehicle.

Below are some of the more common roof rack styles and mounting techniques.

This diagram shows the rooftop tent clamped to a

cross bar using clamp plate and bolts provided.

This diagram shows the rooftop tent clamped to a

roof rack using clamp plate and bolts provided.

This diagram shows the rooftop tent bolted to

a roof bar by drilling through the roof bar and

attaching with bolts provided.

INSTALLATION HINTS

5 - 15

ROOFTOP TENT SETUP

1. Undo velcro securing straps.

2. Unhook all bungee cords from tent base.

3. Undo velcro corner straps.

4. Unzip tent cover. Care must be taken not to catch tent

material in zip.

6 - 15

ROOFTOP TENT SETUP

5. Remove tent cover.

6. Undo both velcro securing straps.

7. The two ladder locking pins require spring pressure to

engage them into the locked position. To do this, twist

locking pins in an anti-clockwise direction.

8. Slide ladder out until locking pins lock ladder into place.

7 - 15

9. Whilstpullingdownontheendoftheladder,walk

backwards away from the vehicle allowing the tent to

unfold.

10.Whententisfullyunfoldedtheendoftheladdershould

touch the ground.

Note: if your vehicle is too tall to allow the ladder to touch

the ground, a ladder extension will be required. See Pages

13 - 14.

11. Remove support bow from under mattress above ladder.

12. Slip support bow under tent opening and push into outer

corners as shown.

ROOFTOP TENT SETUP

8 - 15

ROOFTOP TENT SETUP

13. Push bow away from the tent and insert ends into bow

brackets on corners of tent base.

14. Although the tent is self-supporting, we recommend the

use of pegs and guy ropes in case of potentially windy

conditions.

15. Engage the two long support rods through eyes in canvas

into support holes in aluminium base.

Flex support rod to engage hook end with eyelet, in

corner of ﬂy.

Eyelet Holes

9 - 15

16. Repeat step 15 using short support rods for window

awnings.

17. Remove all four bungee cords from inside of tent. These

should be reﬁtted when packing up the tent.

18. Rooftop Tent complete.

ROOFTOP TENT SETUP

10 - 15

Inhaltsverzeichnis

Andere Ironman4x4 Zelt Handbücher

Ironman4x4

Ironman4x4 IRTI0023 Bedienungsanleitung

Beliebte Zelt Handbücher anderer Marken

OZTENT

OZTENT JV SIGNATURE EDITION Bedienungsanleitung

GigaTent

GigaTent Summer Chalet Mini Tent Bedienungsanleitung

ShelterLogic

ShelterLogic 107153 Bedienungsanleitung

Outsunny

Outsunny 84C-230 Bedienungsanleitung

Napier

Napier SPORTZ COVE 61 Series Bedienungsanleitung

EuroTrail

EuroTrail ATLANTIS PRO Bedienungsanleitung

Reimo

Reimo Marina Bedienungsanleitung

TiiTENT

TiiTENT TB300 Bedienungsanleitung

Coleman

Coleman 2000033134 Installationsanleitung

Ozark Trail

Ozark Trail W784.1 Kurzanleitung

SlingFin

SlingFin CrossBow 2 Bedienungsanleitung

Coleman

Coleman 9600-141 Bedienungsanleitung

Palram

Palram Arizona 5000 Wave - WINGS Bedienungsanleitung

COVERPRO

COVERPRO 56184 Montageanleitung

Vango

Vango Zenith 100 Bedienungsanleitung

Costway

Costway PATIOJOY OP70818 Bedienungsanleitung

Clarke

Clarke PUC 88 Bedienungsanleitung

Coleman

Coleman MONTANA 14'x7' Bedienungsanleitung

Ironman4x4 luxury rooftop tent Bedienungsanleitung

Beliebte Zelt Handbücher anderer Marken