IXL fresco Aurora Bedienungsanleitung
transform your outdoors year-round
USER GUIDE
Model No. 23101
Model No. 22001
2 YEAR IN HOME WARRANTY
12 MONTH COMMERCIAL ON
PREMISE WARRANTY
Contents
1 Range……………………………………………………....……………………..3
2 Safety……………………………………………………….…………………….4
3 How It Works……………………………………………….……………………5
3.1 Heating………………………………………….……………………...5
3.2 Areacovered…………………………………...………………………5
3.3 Table Layouts………………………………….……………………….5
4 Electrical Connections…..………………………………….……………..6 - 7
5 Installation Instructions……………………………………………………….8
5.1 Clearances……………………………………..……………………....8
5.2 Step 1…..………………………………………..…………………..…9
5.3 Step 2…..…….………………………………..……………………….9
5.4 Step 3..…………………………………………..……………………10
5.5 Step 4…………………………………………..……………………..10
5.6 Step 5…………………………………………..….……………….....11
5.7 Step 6…………………………………………..……………………..11
5.8 Step 7…………………………………………..……………………..11
5.9 Step 8…………………………………………..……………………..12
5.9 Step 9…………………………………………..……………………..12
6 Operating Instructions……………………………………………………….13
6.1 Fresco Nova(Model No. 22001) .…………………………………..13
6.2 Fresco Aurora (Model No. 23101) …………………………..…….13
6.3 Connecting the Fresco Aurora to your wireless network………...14
6.3.1 Step 1………………………………………………………………….14
6.3.2 Step 2………………………………………………………………….14
6.3.3 Step 3………………………………………………………………….14
6.3.4 Step 4………………………………………………………………….14
6.3.5 App Set Process.…………………………………………………….15
6.3.6 Fresco App Troubleshooting................……………………….16 - 17
7 Resetting the Fresco Aurora………………………………………………..18
8 Replacement Parts……………………………………………………………19
8.1 Remotes………………………………………………………………19
8.2 Fresco………………………………………………………………....19
8.3 Replacing the battery………………………………………………..19
8.4 Fresco Aurora……………………………………….......…………..19
9 Cleaning/Maintenance………………………………………………………..20
10 Troubleshooting….………………………………………………………21 - 22
11 WiringDiagram………………………………………………………………...23
12 Warranty...........…………………………………………………………...24 - 26
Fresco Nova Fresco Aurora
Model 22001 23101
Heat Output (Watts) 2000 1000/2000
Total Wattage 2021 2060
LED Light Output (Lumens) 1800 2920
LED Light Output (Watts) 21 32
Coloured RGB Lights N/A Yes
LED Output DC24V
Remote Control Supplied Yes Optional Accessory
Phone/Tablet App Control No Yes
Power Connection 230 - 240 V
Connection 3 Pin Plug 10 Amp
Lead Length (mm) 2500
IP Rating IPX4
Dimensions (mm) 1218 x 249 x 165
Unit Weight (kg) 12 kg
Minimum Mounting Height (mm) 2100
Recommend Maximum Mounting 2700
Height (mm)
NOTE: Mounting the Fresco unit at higher positions will reduce the heaters
effectiveness. The Mounting Wire Assembly supplied is 2.0m long and is suitable for
ceiling heights of up to 4.0m.
1. Range
FRESCO OUTDOOR ENTERTAINING APPLIANCE
3
HALO HEAT TECHNOLOGY™
TASK LIGHT
MOOD LIGHT
NOTE
• Read through these instructions completely before commencing installation.
• Incorrect installation, operation or maintenance can result in death, severe
injury or property damage.
• The unit must be installed horizontally.
• Fresco products are not tanning lamps.
• Make sure the elements have cooled and power is off to the Fresco before
removing elements for replacement.
• Do not operate this appliance without the end or glass panels in position.
• This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliances by a person responsible for their safety.
• Children should be supervised to ensure they do not play with the appliance.
• This heater must be mounted at least 2.1 metres from the oor.
• The heater must not be located immediately below a socket outlet.
• Do not install or use the appliance if the power cord is damaged.
• If the supply cord is damaged, it should be replaced by IXL Appliances or its
service agent or a similarly qualied person in order to avoid a hazard.
• If the Fresco unit is located within wet areas, the switches or controls must not
be able to be touched by people in a bath, shower or other water-holding
device. In these circumstances the Fresco unit must be located in accordance
with the requirements of the current Australian/New Zealand Wiring Rules
AS/NZS 3000 relating to damp situations.
WARNING: Curtains or combustible material may ignite if in contact with the heater.
WARNING: The heater must not be used if the glass panel is damaged.
WARNING: In order to avoid overheating, do not cover the heater.
WARNING: The heater must be installed horizontally. Failure to do so will cause
hot spots within the heat elements leading to early failure.
WARNING: Do not feed in any excess cable into the unit as this can interfere with
the wireless control.
2. Safety
FRESCO OUTDOOR ENTERTAINING APPLIANCE
4
3. How It Works
3.1 Heating
The heat source used in the Fresco is carbon bre heat lamps. The 22001 model
use one 2000W heat lamp, while 23101 uses two 1000W lamps. The 23101 model
also allows for the selection 1 or 2 heat lamps to be in operation.
3.2 Area covered
3.3 Table Layouts
1x Fresco
2x Fresco
IXL Fresco 2000W Heat Spread Adjusted
(X - Axis)
IXL Fresco 2000W Heat Spread Adjusted
(Y- Axis)
FRESCO OUTDOOR ENTERTAINING APPLIANCE
5
4. Electrical Connections
Installation of any electrical wiring, power outlet or switch is to be carried out by
registered/licensed electrician. This installation must comply with the requirements
of the current Australian/New Zealand Wiring Rules AS/NZS 3000.
Electrical connections or socket outlets should not be located directly above the
heater. These are to be located outside the physical footprint of the Fresco unit to
ensure that it minimises the effect caused by heat build-up above the heater.
Only a licensed electrician can shorten the supply cord if it is too long. When
shortening the supply cord the internal wiring of the Fresco unit must not be
disrupted in any way.
If the Fresco unit is installed on an angled ceiling, the electrical connections or
wall socket are to be located at the lowest point of the Fresco unit.
The heater must not be located in front of a socket-outlet.
Refer to the images below for the correct and incorrect positioning the wall socket.
Correct Installation (Horizontal).
Correct Installation (Angled).
CEILING
CEILING
FRESCO OUTDOOR ENTERTAINING APPLIANCE
6
4. Electrical Connections
Incorrect Installation (Angled)
Incorrect Installation (Horizontal)
Incorrect Installation
Incorrect Installation
Incorrect Installation
CEILING
CEILING
CEILING
CEILING
FRESCO OUTDOOR ENTERTAINING APPLIANCE
7
5. Installation
The following dimensions shows the clearances required for the Fresco unit. The 2
wire mounting assemblies supplied with the heater are 2.0m in length. Do not install
heater close to curtains or other combustible materials.
The minimum installation height is 2.1m from the oor to the glass panel
Refer to images of clearances below.
5.1 Clearances
Fans, Lights and Sprinkler Fittings
Must Not Be Below The Heater
Ceiling
1000mm min
from surfaces
below heater
Floor
2100mm
min from
floor
300mm min
400mm
min
400mm min
400mm min.
Same for both ends
<
FRESCO OUTDOOR ENTERTAINING APPLIANCE
8
5. Installation
Step 1
Measure and mark the mounting holes on the ceiling at a distance of 1025mm.
When installing into a plaster board ceiling, make sure that the unit is hung from the
joists, beams or rafters. This Fresco unit is not suitable for recessed mounting.
Step 2
Screw the xing caps to the ceiling with the screws provided.
1025mm
1025mm
FRESCO OUTDOOR ENTERTAINING APPLIANCE
9
5. Installation
Step 3
To remove the cable from the cable gripper assembly, loosen the clamping nut at
the top of the gripper and push down. This loosens the lock and the cable is able
to move freely through the gripper. When the downward pressure is released the
gripper will lock onto the cable.
Step 4
After the cable is removed from the gripper assembly, measure out the required
cable length. The cable length required is calculated by the following formula.
Cable length required = Ceiling height – 2.1m
(e.g. 2.4m – 2.1m = 0.3m of cable required)
When cutting the cable, the cut must be clean so that the end is not frayed which
could cause the Cable catching on either the cable guides or the gripper assembly.
Note: This length is based on the lowest surface for the heater being
2.1 metres from the oor.
Note: The lowest point of the heater must be a minimum of 2.1m from the oor.
If this is not done, the installation is not complaint.
FRESCO OUTDOOR ENTERTAINING APPLIANCE
10
Clamping
Nut
Gripper
Assembly
Small
Thread
Section
Andere Handbücher für fresco Aurora
1
Dieses Handbuch passt für folgende Modelle
3
Inhaltsverzeichnis
Andere IXL Heizung Handbücher
Beliebte Heizung Handbücher anderer Marken
Empire Heating Systems
Empire Heating Systems WCC65 Bedienungsanleitung
Wetekom
Wetekom 92 86 43 Bedienungsanleitung
Desa
Desa SPC170-F Bedienungsanleitung
Watlow
Watlow Watrod Electric Tubular Heaters Bedienungsanleitung
Haverland
Haverland ECO-DRY GPS Series Stücklistenhandbuch
Stelpro
Stelpro ASILVC2060 Series Bedienungsanleitung