Jabra BIZ 2400 Series Bedienungsanleitung

USER MANUAL

www.jabra.com

Jabra BIZ 2400

This user guide is published by GN Netcom A/S.

The information in this user guide is furnished for informational use only, is subject to change without notice, and

should not be construed as a commitment by GN Netcom A/S. GN Netcom A/S assumes no responsibility or liability

for any errors or inaccuracies that may appear in this user guide.

Written and designed at GN Netcom A/S, Lautrupbjerg 7, 2750 Ballerup, Denmark, www.jabra.com.

part overview

HEADBAND ASSEMBLY

1 Headband

2 Ear cushion

EAR HOOK ASSEMBLY*

5 Ear hook ring 6 Ear gel

7 Ear hooks

(Small/Large)

HEADSET

3 Headset

4 Quick disconnect

connector

NECKBAND ASSEMBLY*

8 Neckband 9 Neckband ring

CLOTHING CLIP

10 Name tag

11 Transparent cover

*Only included in some Jabra BIZ 2400 models. Also available to order as accessory

connecting the headset to the phone:

- Plug the headset into an adapter cord suited to your phone system

- Unplug the handset from the phone*

- Connect the adapter cord to the handset port

*If your phone has a headset port, connect the adapter cord directly to the headset port.

english

Thank you for buying a GN Netcom A/S product.

All GN Netcom A/S products are designed and manufactured in accordance with strict quality standards and

should, with a minimum of maintenance, give many years of satisfactory use.

wearing the headset with the headband

All mono Jabra BIZTM 2400 models include a headband attachment. To use it:

2 cm

3/4" 2

1. How to wear the headband.

Place the headband over your head, with the headset positioned against your preferred ear and the T-bar

positioned just above the opposite ear. Adjust the headband for optimal t on your head.

2. How to position the microphone.

Adjust the microphone by rotating it around the headset and exing the boom arm until it is positioned less

than 2 cm from the front of your mouth.

3. How to rotate the boom arm.

The boom is free to rotate 360o.

4. How to attach the ear cushion.

Align the ear cushion with the headset ear plate so that the groove in the ear cushion slips around the ridge of

the headset ear plate. Rotating the cushion will ensure it snaps securely into place.

5. How to remove the headband

Remove the ear cushion by gently pulling it o the ear-plate. Push on the inner part with your thumb until the

headset clicks out of the headband.

6. How to press the headset into the headband ring on the headband.

Hold the headband in one hand and the headset in the other. Align the headset against the outside of the

headband ring with the headset cable pointing down. Gently press the headset into the headband ring until it

clicks into place.

wearing the headset with an ear hook

Two sizes of ear hook are included with some Jabra BIZ 2400 models. They can be purchased as an accessory for

any mono model. To use it:

12 3

1. How to attach the ear gel.

The ear gel is a round rubber part which helps stabilize the headset on your ear. Place the ear gel inside the

ear hook ring. Gently push the ear gel through the hole so that it sits in the hole. Once you click the headset

into the ear hook ring, the ear gel will be locked into place.

2. How to press the headset into its ear hook ring on the ear hook.

Hold the ear hook ring in one hand and the headset in the other. On the inside surface of the ear hook ring

you will nd "L" and "R" markings. Align the cable of the headset with the "R" marking if you wish to wear it on

you right ear, or "L" if you wish to wear it on your left ear. Gently press the headset into the ear hook ring until

it clicks into place.

3. How to position the ear hook on the ear hook ring for left or right ear use.

The ear hook wearing style has two parts: an ear hook and an ear hook ring. One end of the ear hook forms a

pin that presses into a loop on the ear hook ring and holds it there.

You will wear the headset with the ear hook behind your ear and the ear hook opening pointing down towards

your jaw. Decide on which ear you would like to wear the headset and assemble the ear hook and ear hook ring

appropriately.

To change from one ear to the other, pull the ear hook up and away from the loop, and press into the other side

of the loop. Then remove the headset from the ear hook ring. Rotate it and replace it again with the cable posi-

tioned at the ‘L’ or ‘R’ for the selected wearing side as described in point 2.

2 cm

3/4"

5 6

4. How to wear the ear hook.

To wear the headset, slip the ear hook behind your ear while keeping the ear gel centred into the middle part

of your ear. The ear hook comes in two sizes for optimal t. Please try both for best personal support and t.

5. How to position the microphone.

Adjust the microphone by rotating it around the headset and exing the boom arm until it is positioned less

than 2 cm from the front of your mouth.

6. How to rotate the boom arm.

The boom is free to rotate 360o.

wearing the headset with the neckband

A neckband wearing style is included with some Jabra BIZ 2400 models. Neckbands can be purchased as an

accessory for any mono Jabra BIZ 2400. To use it:

1. How to press the headset into the neckband ring.

The neckband can be assembled for wearing on either the left or right ear. Decide whether you would like to

wear your headset on your left or right ear and position the neckband ring appropriately. Hold the neckband

ring in one hand and the headset in the other. Align the headset against the outside of the neckband ring with

the headset cable pointing down. Gently press the headset into the neckband ring until it clicks into place.

2. How to attach the ear cushion.

Align the ear cushion against the neckband ear plate so that the groove in the ear cushion slips around the

ridge of the ear plate. Rotating the cushion will ensure it snaps securely into place (you can remove it as you

attach it).

3. How to position the neckband on the neckband ring.

Attach the neckband by sliding the left or right tip of the neckband through the loop in the neckband ring.

Note the small bump inside the neckband ring; this must align with the groove on the tip of the neckband.

2 cm

3/4"

456

4. How to wear the neckband.

Wear the neckband so the band goes around the back of your neck and the bowed sections go over your right

and left ear respectively, whilst the ear cushion sits on your ear.

5. Position the microphone.

Adjust the microphone by rotating it around the headset and exing the boom arm until it is positioned less

than 2 cm from the front of your mouth.

6. How to rotate the boom arm.

The boom is free to rotate 360o.

wearing a duo headset

(Duo models only)

The duo version of Jabra BIZ 2400 is always worn as a headband. To wear and adjust your headset:

1 2

1. Adjust the headband length.

The headband is adjustable in length to t the size of your head. Push or pull the top section of the

headband until the headset ts comfortably.

2. How to wear the headset.

Position one speaker over each ear with the headband going over the top of your head, just as with a

traditional pair of headphones. The headset can be worn on either the left or right ear, simply rotate

the boom arm as needed.

3 4

2 cm

3/4"

3. How to position the microphone.

Adjust the microphone by rotating it around the headset and exing the boom arm until it is positioned less

than 2 cm from the front of your mouth.

4. How to rotate the boom arm.

The boom is free to rotate 360o.

connecting the headset to a phone or computer

The headset features a Quick Disconnect (QD) connector, which enables you to use the headset with a variety of

telephones, computers and other sound sources by attaching any of the QD cords and adapters available from

GN Netcom A/S.

To connect your headset to a QD adapter, simply press its connector into the similar connector on your adapter.

Then connect the adapter to a telephone or computer and your headset is ready to use.

You can disconnect your headset at any time without terminating the current call (if any). To do so, hold the QD

adapter with your thumb and index nger and pull the connectors apart. Always pull on the connectors, never

on the cords.

For more information about QD adapters, please see the documentation that came with your adapter and/or go

to www.jabra.com.

care, cleaning and maintenance

- Avoid getting the headset wet and never submerge it in water.

- Avoid stretching, bending or twirling the wire; this will weaken the connectors and the wire itself and may

result in loss of audio.

- Do not block the microphone holes on either side of the boom arm. Advanced Jabra BIZ 2400 models

feature a small hole on both the inward and outward facing sides of the boom. This front-facing hole is a

noise-cancelling feature and does not allow extra noise into the microphone.

- You can clean the ear cushions or other parts of the headset by using a cleaning wipe designed for use with

electronic and plastic equipment. Allow to dry before replacing them. Suitable tissues are available from

GN Netcom A/S; contact your GN Netcom A/S representative for details. After extensive use, the ear cushion

may become worn. New ear cushions are available from GN Netcom A/S.

Dispose of the product according to local standards and regulations.

www.jabra.com/weee

Andere Handbücher für BIZ 2400 Series

Inhaltsverzeichnis

Andere Jabra Headset Handbücher

Jabra

Jabra GN 6110 Bedienungsanleitung

Jabra

Jabra BT2010 - ANNEXE 746 Bedienungsanleitung

Jabra

Jabra BT 125 Bedienungsanleitung

Jabra

Jabra GO 6430 Bedienungsanleitung

Jabra

Jabra Engage 65 Bedienungsanleitung

Jabra

Jabra GN9330e - USB - Headset Sicherheitsleitfaden

Jabra

Jabra Move Style Edition Bedienungsanleitung

Jabra

Jabra HALO Referenzhandbuch

Jabra

Jabra Stone2 Bedienungsanleitung

Jabra

Jabra BT8030 - Headset - Convertible Bedienungsanleitung

Jabra

Jabra Sport Pace Wireless Technisches Datenblatt

Jabra

Jabra BT8010 - Headset - Clip-on Bedienungsanleitung

Jabra

Jabra Steel Bedienungsanleitung

Jabra

Jabra Evolve 65t Bedienungsanleitung

Jabra

Jabra 2403-700-105 - BIZ 2400 Mono Headband Bedienungsanleitung

Jabra

Jabra GN9330e - USB - Headset Installations- und Benutzerhandbuch

Jabra

Jabra BT2070 - Headset - In-ear ear-bud Bedienungsanleitung

Jabra

Jabra GN2000 - DATASHEET 3 Bedienungsanleitung

Jabra

Jabra TALK 5 Bedienungsanleitung

Jabra

Jabra GN9330e - USB - Headset Bedienungsanleitung

Jabra

Jabra BT205 - Bedienungsanleitung

Jabra

Jabra BT325s Bedienungsanleitung

Jabra

Jabra BT5020 - ANNEXE 641 Bedienungsanleitung

Jabra

Jabra BT2046 Bedienungsanleitung

Beliebte Headset Handbücher anderer Marken

Sena

Sena SMH10 Bedienungsanleitung

IASUS

IASUS Stealth IA-NT4-BASIC-BT Bedienungsanleitung

Sennheiser

Sennheiser EPOS ADAPT 230 Bedienungsanleitung

GE 98971 Bedienungsanleitung

Hama

Hama 00184070 Bedienungsanleitung

Plantronics

Plantronics Blackwire 3200 Series Bedienungsanleitung

Blue Tiger

Blue Tiger Advantage PLUS Bedienungsanleitung

Jawbone

Jawbone Icon Bedienungsanleitung

Roxcore

Roxcore Flow A+ Bedienungsanleitung

Turtle Beach

Turtle Beach XP 510 Bedienungsanleitung

Philips

Philips SHB6101 Bedienungsanleitung

HyperX

HyperX HyperX Cloud Flight Bedienungsanleitung

Bose

Bose MIE2 Mobile Bedienungsanleitung

HyperX

HyperX cloud ii Bedienungsanleitung

Southwing

Southwing SA505 Bedienungsanleitung

Blueant

Blueant X5i Bedienungsanleitung

Amytel

Amytel ABH 204 Bedienungsanleitung

Plantronics

Plantronics Savi W730 Bedienungsanleitung