JCM Technologies ACTIVA Bedienungsanleitung

ACTIVA

Introduction 4

General data 5

Chassis attachment 5

Connections terminals 6

Installation 7

Regulatory Data 8

EU Declaration of conformity 8

Introducción 9

Datos técnicos 10

Fijación de la caja 10

Bornes de conexión 11

Instalación 12

Datos reglamentarios 13

Declaración de conformidad UE 13

Introduction 14

Données techniques 15

Fixation du boîtier 15

Bornes de connexion 16

Installation 17

Données réglementaires 18

Déclaration de conformité UE 18

Einführung 19

Technische Daten 20

Einbau 20

Anschlußklemme 21

Installation 22

Daten 23

jcmtechnologies

EU-Konformitätserklärung 23

Introduzione 24

Dati tecnici 25

Fissaggio della scatola 25

Morsetti di collegamento 26

Installazione 27

Dati regolamentari 28

Dichiarazione di conformità UE 28

jcmtechnologies

Introduction

ACTIVA antenna (Dynamic code):

This external antenna is very usefull for facilities where the reception of the built-in

antenna is not good (for example: long distances, access ramps or underground gar-

ages, large metal surfaces, ...). In addition to its antenna functions, it also contains

the entire receiving piece and enables different receiving points of a facility to be

improved or extended (up to a maximum of 200 meters). As the decoder unit is

always located inside the building, it makes the facility completely invulnerable.

1AERIAL CONNECTOR 2RADIO CARD

3RECEIVER UNIT / CONNECTION TERMINAL / POWER SUPPLY

CONNECTION / EXIT SIGNAL

jcmtechnologies

General data

Parameter Value

Frequency 433.92 MHz

Antenna Built-in adjustable

Certificate Meets European std I-ETS 300 220

Power 12 V.DC

Sensitivity > 100 dBm

Power consumptionat

work / at rest 7 mA / 20 mA

Working temperature 0 - 70°C

Waterlight IP 44

Dimensions 112 x 72 x 51 mm

Chassis attachment

The antenna comprises four different pieces: a rear cover, circuit, front curved cover

and adjustable antenna.

1. Attach the rear of the box to the wall using the plugs and screws supplied.

2. Attach the circuit to the rear of the box.

3. Pass the cables through the bottom of the microreceiver.

4. Slide the front of the ACTIVA antenna over the track in the rear cover.

5. Screw the antenna to the top of the chassis.

jcmtechnologies

Connections terminals

+ Alimentación, 12 V

-Supply voltage,

ground

S Coded signal

Disconnect the power before handling.

•Connect the three terminals to match the settings on the receiver unit installed

inside.

•To connect the ACTIVA antenna and the receiver unit located inside the facility, use

a 3-wire twisted sheathed cable.

In the case of using standard 4-strand cable, the correct connection is as follows:

Cable connection enlarged

For extreme cases of more than 200 metres distance, the cable

can be extended some metres further by placing a 1K resistance

between the "S" and "-" terminals, always depending on the inter-

ference that may arise in the installation itself.

jcmtechnologies

Installation

Place the antenna outdoors to ensure optimal reception. Since the codes are stored in

the decoder and not in the antenna, this does not pose any possible breach of secur-

ity.

•It disposes of an adjustable antenna.

•Do not place the ACTIVA antenna less than five meters from any other receiver

and/or ACTIVA antenna.

Table showing the cable section to use, according to the distance between the

receiver and the operative antenna:

From 1 to 3 operative antennae connected to the same receiver

Cable section Maximum distance

0,5 mm2 200 m

From 4 to 7 operative antennae connected to the same receiver

1 mm2 200 m

Avoid placing near metal objects. If unavoidable, tilt

the antenna 90°C to position it perpendicular to these

objects.

jcmtechnologies

Regulatory Data

EU Declaration of conformity

The manufacturer JCM TECHNOLOGIES, S.A. declares that the product ACTIVA

complies with the relevant fundamental requirements of the RED Directive

2014/53/EU and of the RoHS Directive 2011/65/EU.

See website https://www.jcm-tech.com/declarations/

JCM TECHNOLOGIES, SA

C/COSTA D'EN PARATGE, 6B

08500 VIC (BARCELONA)

SPAIN

jcmtechnologies

UM_3200070_ACTIVA_5ID_Rev03

Introducción

Antena ACTIVA (Dynamic code):

Este equipo permite cubrir la necesidad de una recepción exterior directa en los casos

en que la del receptor o cuadro de maniobra ubicados en el interior, se vea obs-

taculizada por grandes distancias, rampas de acceso a garajes subterráneos, gran-

des superficies metálicas, etc. Su reducido tamaño y fácil instalación lo convierten en

un equipo de recepción idóneo.

La Antena ACTIVA no contiene la parte de descodificación de códigos en su circuito y

es el receptor interno quien determina si la señal recibida a través del cable es la

correcta o no. Esta configuración garantiza la imposibilidad de sabotajes o mani-

pulaciones indeseadas.

1CONECTOR ANTENA 2TARJETA DE RADIO

3BORNE CONEXIÓN / EQUIPORECEPTOR / ENTRADA

ALIMENTACIÓN /SALIDA SEÑAL

jcmtechnologies

Datos técnicos

Parámetro Valor

Frecuencia 433,92 MHz

Alimentación 12 V D.C.

Número máximo de antenas

conectables 3 en paralelo

Antena Incorporada orientable

Certificación s/norma europea I-ETS 300 220

Estanqueidad IP 44

Sensibilidad mejor que -100 dBm

Consumo reposo/ fun-

cionamiento 7 mA / 20mA

Temperatura fun-

cionamiento 0 a 70°C

Dimensiones 112 x 72 x 51 mm

Fijación de la caja

La antena ACTIVA está compuesta por 4 piezas distintas: una tapa posterior, un cir-

cuito, una tapa frontal de forma curvada y una antena orientable.

1. Fijar la parte posterior de la caja en la pared utilizando los tornillos y tacos sumi-

nistrados.

2. Fijar el circuito a esta parte posterior.

3. Pasar los cables por la parte inferior de la antena ACTIVA.

4. Deslizar el frontal por la guía de la tapa posterior.

5. Roscar la antena en la parte superior de la caja.

jcmtechnologies

Inhaltsverzeichnis

Sprachen:

Andere JCM Technologies Antenne Handbücher

JCM Technologies

JCM Technologies FREE 15 R Bedienungsanleitung

Beliebte Antenne Handbücher anderer Marken

Alfa Network

Alfa Network APA-L01 Bedienungsanleitung

Naval

Naval PR-422CA Bedienungsanleitung

Feig Electronic

Feig Electronic ID ISC.ANTH200/200 Series Bedienungsanleitung

TERK Technologies

TERK Technologies TV44 Bedienungsanleitung

Directive Systems & Engineering

Directive Systems & Engineering DSE2324LYRMK Bedienungsanleitung

HP J8999A Bedienungsanleitung

MobilSat

MobilSat MSP-S Bedienungsanleitung

Steren

Steren ANT-UHF 13 Bedienungsanleitung

Novatel

Novatel 600-G Bedienungsanleitung

Radio Shack

Radio Shack Amplified VHF/UHF/FM Indoor Antenna Bedienungsanleitung

TRENDnet

TRENDnet TEW-AO12O Bedienungsanleitung

Radio Shack

Radio Shack 15-1837 Bedienungsanleitung

CommScope

CommScope CMAX-OMFX-43M-I53 Bedienungsanleitung

Ramsey Electronics

Ramsey Electronics DAP25 Bedienungsanleitung

COBHAM

COBHAM SAILOR 800 VSAT Gebrauchs- und Pflegehandbuch

Trango Systems

Trango Systems AD900-9 Bedienungsanleitung

Steren

Steren ANT-100 Bedienungsanleitung

Proxim

Proxim 5054-PA-23 Bedienungsanleitung