JCM Technologies GSM-CARD Bedienungsanleitung
GSM-CARD / VGSM-CARD
communications card
User Manual
Table of contents
Important safety instructions 3
Use of the equipment 3
Introduction 4
General description 4
Installation 5
Assembly 5
Configuration 6
GSM-CARD 6
VGSM-CAR 6
Verification 7
LED indicators 7
GSM LEDs 7
Communication LEDs 7
Operation LEDs 8
ERROR LED 8
Solving problems 9
FAQs 9
Notes 10
Technical details 12
Regulatory Data 12
EU Declaration of conformity 12
jcmtechnologies
2
Important safety instructions
Disconnect the power supply whenever you proceed
to the installation or repair of the equipment.
In compliance with the European Low Voltage Directive, we inform you of the fol-
lowing requirements:
•When the devices remain permanently connected, an easily accessible connecting
device must be incorporated into the wiring.
•This system must only be installed by qualified professionals that have with auto-
mated garage doors and knowledge of the relevant European standards.
•The user instructions for this device must always be in the user’s possession.
•The operating frequency of the receiver does not interfere in any way with the 868
MHz remote control systems.
Use of the equipment
This device is designed for applications with an automated garage door. It is not guar-
anteed for the direct activation of devices other than those specified. The man-
ufacturer reserves the right to change the device specifications without warning.
jcmtechnologies
3
Introduction
General description
GSM communication card for real-time management
Connected to an ACCESS-5K access control, it allows remote management of users.
Connected to a VERSUS control panel, it allows remote configuration of parameters
and alarms.
jcmtechnologies
4
Installation
Assembly
jcmtechnologies
5
Configuration
GSM-CARD
To change the default options, you must install the SoftAssistant program for Win-
dows.
For more information, visit:
https://www.jcm-tech.com/JCM/soft-assistant/
VGSM-CAR
To configure the device, please access the following website:
https://versuscloud.jcm-tech.com/Account/Login
jcmtechnologies
6
Verification
LED indicators
GSM LEDs
GOOD Good coverage. Optimum data transfer
POOR Weak coverage, but sufficient for data transfer
BAD Unstable coverage or no connection. We recommend you not
use the device in this status, as there may be errors
When led indicator is bad, it is recommended to use
a 3 meters long GSM antenna extension cable.
Communication LEDs
TX Lit during data transmission
jcmtechnologies
7
Operation LEDs
OK System working correctly (flashing=in process)
ALARM Use of backup GSM frequency (850 MHz)
ERROR System error
If the GSM-CARD uses the backup frequency, it can
interfere with the Motion transmitters.
ERROR LED
Number
of
flashes Error type Action required
1 Module initialisation Wait for the initialization to be com-
pleted
2 SIM card not detected Check SIM card insertion
3 Incorrect PIN Modify communication settings in
SoftAssistant
4 SIM card locked Unlock SIM card (for example, with
a free mobile)
5 No communication Review GSM antenna connection
(see GSM leds)
6 Adjustments not valid Check Unique Key and APN in
SoftAssistant
7 Server not detected Contact M2M service provider
jcmtechnologies
8
Solving problems
FAQs
Q: Can I use the supplied SIM to surf in Internet with a smartphone?
A: No, the SIM card is type M2M (Machine to Machine), therefore it only connects the
main equipment to a private server.
Q: Can I use any SIM card, for example the one I have on my phone?
A: No you cannot. It only works with bidirectional M2M SIMs from approved operators
and specifically configurated.
Q: With the serial number that appears on the label, can you access your computer
through any SoftAssistant?
A: No, you cannot. In addition to the serial number, it is also required the unique key to
connect remotely.
Q: If I have the main equipment installed, will it work remotely only by plugging in a
GSM-CARD?
A: Yes, the card is configured by default with the communication parameters of the
approved operator.
jcmtechnologies
9
Notes
jcmtechnologies
10
Andere Handbücher für GSM-CARD
1
Dieses Handbuch passt für folgende Modelle
1
Inhaltsverzeichnis
Andere JCM Technologies Konferenzsystem Handbücher
Beliebte Konferenzsystem Handbücher anderer Marken
Kramer
Kramer VIA GO Bedienungsanleitung
AVT
AVT MAGIC AC1 Go Bedienungsanleitung
ProSoft Technology
ProSoft Technology AN-X4-AB-DHRIO Bedienungsanleitung
Sony
Sony PCS-I150 Bedienungsanleitung
Middle Atlantic Products
Middle Atlantic Products VTC Series Bedienungsanleitung
Prentke Romich Company
Prentke Romich Company Vanguard Plus Leitfaden
