8
USER MANUAL V1.2
JEFSWMIT12-110 •JEFSWMIT12-230
305mm SLIDING COMPOUND MITRE SAW
3.4 Working Environment
• Keep the work area clean. Cluttered workbenches increase the risk of accidents and injuries.
• Do not expose the tool to water or any other liquid. Do not use power tools in damp or wet areas. Do not expose power tools to rain.
• Make sure the work area is well lit.
• Keep onlookers and children at a safe distance. Onlookers should wear safety glasses and be kept at a safe distance from the work area.
• Do not allow onlookers to touch the tool or extension cord.
• Put away tools that are not being used. When not in use, store the tool in a dry place out of the reach of children.
• Always unplug the power cord when the tool is not being used, and before carrying out service work or changing accessories, such as blades,
bits or discs.
• Do not stand on the power tool. If the tool tips over or if you come in contact with the disc this can lead to serious injuries.
• Do not use power tools in explosive environments, for example, in the vicinity of flammable liquids, gases or dust.
• Cutting produces sparks. Do not use the tool near flammable materials – risk of fire and/or serious personal injury.
• If using the tool outdoors, only use an earthed extension cord approved for outdoor use.
•This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for
their safety.
• Do not use saw blades which are damaged or deformed;
- replace the table insert when worn;
- use only saw blades recommended by the manufacturer which conform to EN 847-1;
- do not use saw blades manufactured from high speed steel;
• Wear suitable personal protective equipment when necessary, this could include:
- hearing protection to reduce the risk of induced hearing loss
- eye protection when using the tool
- respiratory protection to reduce the risk of inhalation of harmful dust
- gloves for handling saw blades (saw blades shall be carried in a holder wherever practicable) and rough material
•Connect the saw to a dust collecting device when sawing wood. In addition the operator shall be informed of factors that influence
exposure of dust and the precautions mentioned e.g. type of material to be machined and the importance of local extraction (capture or source)
and proper adjustment of hoods/baffles/chutes.
• Select the correct saw blade for the material to be cut;
• Do not use the saw to cut other materials than those recommended by the manufacturer.
• Lifting and transportation information: Information shall include where to lift and support the mitre saw and when necessary a warning not to
use guards for this purpose.
• Do not use the saw without the guards in position, in good working order and properly maintained.
• Ensure that the arm is securely fixed when bevelling.
• Keep the floor area around the machine level, well maintained and free of loose materials e.g. chips and cut-offs.
•Provide adequate general or localised lighting.
•The operator is adequately trained in the use, adjustment and operation of the machine.
•Use correctly sharpened saw blades. Observe the maximum speed marked on the saw blade.
•Ensure that any spacers and spindle rings used are suitable for the purpose as stated by the manufacturer.
•Only use the laser fitted with the Mitre Saw.
•Repairs shall only be carried out by the laser manufacturer or an authorised agent.
•Blade replacement procedure including the method for repositioning and a warning that this must be carried out correctly.
•Refrain from removing any cut-offs or other parts of the workpiece from the cutting area whilst the machine is running and the saw head is not
in the rest position.
•Ensure that the machine is always fixed to a bench, wherever possible.
•Replace table insert when worn.
•Remove the plug from the socket before carrying out any adjustment, servicing or maintenance.
