–3 –Jema Autolifte A/S wheel balancer DWC
From the control position the operator must be able to see the entire apparatus and the surrounding area. Within the area
you must prevent access to unauthorized persons and objects that may constitute a source of danger.
All the installation operations involving connections with outside main supplies (especially electricity) must be done by
professionally qualified people.
Installation must be done by authorized personnel following the special instructions contained in the manual where necessary.
In case of doubt, consult authorized service centre or the technical services office of Balance.
Safety
Any tampering or alteration of the apparatus which is not previously authorized by the manufacturer will release the latter from
any liability for damages deriving from or referring to the above-mentioned actions.
Removal or tampering with the safety devices constitutes violation of the safety regulations.
The operator must also observe the following safety procedures:
Check that dangerous conditions do not arise during the operation maneuvers. Stop the machine immediately in case of
irregular functioning and contact the customer service office of the authorized retailer.
Check that the working area around the machine is free of potentially dangerous objects and that there is no oil (or other
sticky materials) on the flooring since this is a potential danger for the operator.
The operator must wear suitable work clothing, protective goggles, gloves and mask to prevent harm from dust or
impurities being blown out. Dangling objects such as bracelets should not be worn, long hair should be protected in a
suitable manner, shoes should be suitable for the type of operation to be performed.
Technical service, repairs and replacement of parts
All repair and extraordinary maintenance operations should be carried out by authorized and professionally qualified personnel.
Disconnect the machine from the mains supplies (electricity, compressed air, etc.) before any maintenance operation.
Use original spare parts supplied by the manufacturer.
Consult the technical services office of Balance for any doubt regarding the suitability and conformity to safety regulations of the
accessories and spare parts to be used on the machine.
Storing
Should the machine have to placed in storage for a long period, disconnect the main supplies, empty the tanks containing the
operating liquids and make sure that those parts which could be damaged by the deposit of dust are adequately protected.
Grease those parts which could be damaged due to drying out and, when the machine is used again, replace the gaskets
indicated in the spare parts section.
Scrapping
If the machine is not to be used again, it should be made inoperative.
Those parts which could cause danger should be rendered harmless.
Consult disposal classification lists for the disposal category of the product.
Scrap as iron scrap and send to the appropriate refuse collection centre.
If it is considered special waste, dismantle and divide into similar parts before disposing in accordance with the regulations in
force. 1.
2.GENERAL PRECAUTIONS
Before operating the balancing machine, read carefully the use and maintenance manual. The noncompliance with these
standards frees the constructor from any responsibility.
1.1 Warnings and cautions
-The machine is to be operated only by authorized personnel.
-Check that the use of the balancing machine does not trigger off hazardous situations to people or things.
-When irregularities or malfunctions occur, stop immediately and require the intervention of the specialized technical
