To adjust grill burner air shutters and surfaceburner air shutters (Some
models):
The_efthandair shuttercontro}sthe rear half of thegriJIburneror the rear surface
burner.The right hand shutter controls the front half of the grill burner or the front sur-
face burner.
S_ideairshutter backward or forward to in-
crease or decrease the size of the airopen- _ _>_ __AIR SHUTTER
ing. Air shutters fit snugly on the burner,so a _ _"_ '_
screwdriver blade may berequired to make
thisadjustment.Observe changeinflame ap-
pearance as the air shutter is moved. Adjust- R,VE_BL_OE
ment is satisfactory when a clearly defined, _NSLOTANDTWiSTWITHSLIGHT PRESSU_aETQ ALLOW
even blue flame results at theHi flame set- A_RSHUTrERTOSUOEEAS_LY.
ting. The snug fit of theair shutter assures it
will remain positionedcorrectly.
On any burner, closing the air shutter too far will cause the flame to become soft and
yellow tipped. Openingthe air shutter too wide will cause the flame to blow away from
the burner ports. Properadjustment willproduceasharp, clearly definedeven, blue
flame.
LO Flame Adjustment
This appliance has been shipped from thefactory with Lo and Med flame se_ngs
adjustedfor usewith natural gas and average instaJlafiens.Thereis a widevariety of
conditionscaused byaltitude andgas mixtures controlled byutility companieswhich will
vary and effect thegasflame andperformance.Adjustmentsshould be madeat time of
installation.If conditions change, followthe procedures outlined below to adjustthe Lo
setting.
1. Lightburner and set control knob for low flame.
2.Remove control knob from valve stem.
CAUTION: Neverusea metal bladetopry
knoboff. _LOCk3_JSE
3. Inserta slender,thin-bladescrewdriver into TO._'_vc_
therecess at center of valve stemand en-
gagebladewith slot in adjustingscrew.
4. Turn center stem adjusting screw slightly
to set flame size,Note: Turn clockwisetoCOUNTERCLOCKWISE
TOINCREASEFLAME
reduce orcounterclockwise toincrease _ s_zE
flamesize.
5.Replacecontrol knob when adjustment is
completed.
Proper adjustment will produce a stable, steady blue flame of minimum size. The final
adjustment shou)d bechecked by turning knob from Hi to Lo several times without
extinguishing the flame,This adjustment, at the Lo setting, will automaticallyprovide
the proper flamesize at Mealsetting.
9
